HEX –BEAM SP7IDX TECHNOLOGY
HEXBEAM MARK IV HD &
Ver 01,04.020
HEX-BEAM SP7IDX TECHNOLOGY ANTENNA is a broad band hex antenna
operating in PLUG AND PLAY system, its assembly time is 1-1,5h for one person. Its
installation doesn't require any additional tuning. Thanks to its small and compact
structure its turning requires only a small light rotor. The antenna works properly
even when it's installed relatively low over the ground.
Both antennas are equipped with all parts, required for a one, five or
six bands beam in range from 6 to 20 meters. The HEXBEAM SP7IDX
TECHNOLOGY offers mounted on the ground gain for front –to –back huge
amplify. The antenna offers the same values as a full size YAGA antenna. Has
unique shape: is much smaller, stiffly and makes less noise than typical
beams, it is lighter, easier to montage.
Please see its possible assembly methods on:
http://sp7idx-hexbeam.eu/hexbeam/mounting-suggestion
The antennas are tested at 7,3m height with analyser RigExpert AA-
1000 + Keysight E5061B ENA Vector Network Analyzer
24,8 m AIRCELL 7 + RG400/U HEW-Kabel GmbH Germany Filial Nordic-
Örebro-Cable
Test connections conducted with transceiver SDR - Flex Radio
System 6600M + EXPERT ELEKTRONICS SunSDR2 DX
PA Team SPE EXPERT 1,3K + 2K
It is helpful if you completely read through the instructions a couple of time before
you start.
The antenna is assembled intuitively, but please READ the manual carefully.
Please pay special attention to the red inscriptions.
