Z
2
© 2013 Herman Miller, Inc. Zeeland, Michigan. Printed in the U.S.A.
® Y, Zand Canvas Office Landscape are among the registered trademarks of Herman Miller, Inc.
Illustrations and specifications are based on the latest product information available at the time of publication.
The right is reserved to make changes in design and specifications at any time, without notice, and also to discontinue products.
Part no. 1b3cxn rev H.
C
C
C
C
A
A
A
C
C
C
D
D
D
D
C
D
D
D
Frame
Frame
Hole
Hole
Slot
Do not
use
Frame
1. Align 3 Frames.
2. Connect Frames to Connector Tube (A) using Screws (C) and Washers (D) at Top
Hole location. Do not tighten Screws.
For change of Height Conguration, see next page.
3. Assemble Connector Tube (A) to Frames at Slot location second from bottom with
Screws (C) and Washers (D). Do not tighten Screws.
4. For Frames 57” and taller: install Connector (A), Screws and Washers in Middle
Hole.
5. Important: Torque Screws to 200 in-lbs. Start with Top Connector Tube, then
Bottom and Middle last.
Assembly Instructions:
Notice:
For proper trim alignment:
Threaded holes in connector Tube (A) to be oriented at the bottom of the parts as shown.
