User manual Integra Mini 300
5HENSEL-VISIT International GmbH
3 Safety indication
In addition to the general rules for the use of electrical equip-
ment, the following cautionary measures must be observed.
Please read and observe the following information before use.
Supply a copy of the safety information when selling, leasing, or
otherwise distributing this device.
ATTENTION!
Improper use of this device, disregard of the safety instructions,
or manipulation of the safety features can cause damage, bodily
harm, electric shock, or even death.
The compact flash unit Integra Mini 300 is intended for profes-
sional use by a photographer. It is only intended to be used with
the HENSEL-VISIT approved accessories listed in this manual.
The unit is not to be used for applications other than those de-
scribed herein, especially not for other electrical applications.
Set-up and initial use
• Do not use the flash unit in environments that include explo-
sion hazards.
• Make sure that the power supply corresponds with the infor-
mation on the labelling.
• Compact flash units and generators must only be connected
to a grounded power supply.
• Check the protective conductor function before initial use.
• Only use plugs/connectors with intact contacts. Burned or
corroded plug-contacts can be the cause of fires. Defective
plugs can cause substantial damage to sockets.
• Do not connect accessories manufactured by other compa-
nies even when these look similar or alike.
• Avoid placing the cables on the studio floor to prevent trip-
ping points and damage. If this cannot be avoided, make
Proper use
Improper use
