3
Important terms
helvenco AG assumes that the user has read, understood and accept the terms below
before operating the engine. They are helpful for a better understanding of the product
and useful to prevent and to minimize the risks.
helvenco AG only supplies OEM’s and specialized aviation engine distributors that have
sufficient technical knowledge to ensure the AERO products of helvenco AG are installed and
serviced/repaired correctly.
helvenco AG emphasizes that the AERO product line is not certified and is made for
experimental aircraft only. It is important the user understands that the engine can stall/or break
with an emergency landing as a result; this can occur to injuries or death! The AERO1000/1500
should be used in open spaces only and during daylight. This product is neither covered by
product nor public liability.
Who flies with a paramotor/experimental aircraft/ULM or even just starts it, automatically
assumes all the risks inherent to these sports and all the responsibilities for damages to yourself
or to third parties, accidents, injuries or death caused by using such products.
To fly with a paramotor/experimental aircraft/ULM always needs great attention. Be aware that
you fly at your own risk; always check if your machine is in good condition before use.
helvenco AG doesn’t assume any responsibility for damages caused by poor servicing or wrong
assembly.
Any modification on the standard AERO product made by any party other than helvenco AG can
make the product dangerous to be used and is on own risk.
Wrong mounted, bad balanced or unproportioned propellers can lead to serious damage of the
AERO1000/1500 products.
The engine can’t be used for acrobatic maneuverings.
Don’t use the AERO1000/1500 in bad weather conditions such as rain or snowfall.
Not limitative list of possible reasons leading to premature engine failures:
•Engine modifications not approved by helvenco AG.
•Carelessness, lack of servicing, accidents, installations or wrong maintenance.
•Accidental falls or engine drop or drop of its components.
•Improper use or misusage of the engine.
•Assembly of parts or components not specified for the engine use.
•Engine overheating or stop after long usage, beyond the term indicated by helvenco AG.
•Use of improper petrol or oils, presence of dirty parts or foreign bodies in the engine.
•Permanent/ too long running into the rpm limiter.
•Engine or parts deterioration because of improperly storage.
•Wrong engine assembly, including the use of not original helvenco AG parts.
•Damages to the engine caused by foreign bodies.
•Usage of wrong spark plugs.
•Not respecting the manual in general.
