HR120038G2_02_EN
Technical Data
• Battery CR2032, 3 V
• Frequency 433,92 MHz ± 100 KHz
• Ambient temperature: -10°C to 50°C
Notes
Attention!
Please carefully read the operating instructions of the emitter as well as the instructions of the tubular motor with built-in receiver / external receiver before commissioning and
observe ist instructions.
Important notes!
The emitter described is exclusively intended for the transmission of radio signals to our tubular motors and external receivers with radio code G2. Information on which
emitters have radio code G2 is available at www.heicko.de or www.heicko-bewegt.de.
All operating and most important setting functions of the above-mentioned radio motors / radio receivers can be carried out with the HR120038G2. Only various special
additional functions are not possible. Information on this can be found in the respective instructions for the radio motors or receivers. Except when connecting the motor /
external receiver, this affects the functions in which 2 buttons must be pressed simultaneously.
The scope of this manual is limited to the description of the mini emitter as a control element. The description of the programming (“connecting“, etc.) with respect to the above
mentioned tubular motors with built-in receiver as well as the external receivers is given in the instructions for the tubular motors with built-in receiverse and external receivers.
Observe the operation notes on the next page.
Attention! - When not in use, always push the cover over the buttons to avoid unintentional operation of the buttons (for example, in the trouser pocket.) If a drive is put into
operation unnoticed, it can create a dangerous situation for people.
User manual
User manual
• Transmission power: 10 mW
• Transmitter range: 100 m (outdoors)
35 m, through max. 2 walls
Radio code G2
-1-
• If the transmitter range or signal strength decreases, a battery replacement is required.
• Moisture, excessive temperature, dust and force will damage the device and destroy it.
User manual
QR-Code for
Back: Battery compartment - Loosen screws
and lift the cover, lift the circuit board and
turn around.
Cover
HR120038G2 - 1-channel mini emitter
Up Down
Stop Button without function
