For the remote programmable thermostat mode:
To use this feature refer to attached Thermostat manual included with this heater.
But here are some basic instructions so you can override some functions to operate
your heater.
1.-To ignite your heater simply press the ON/OFF power button and the heater
automatically will start the ignition sequence within approximated 30 second of
self checking the heater will ignite.
2.-The heater will always start in the low heat setting and the heater will warm-up
for at least 2 minutes before automatically going to the higher flame setting.
3.-The fan will not start until the heater has reached the minimum operating
temperature. To select fan speed or the heat setting press the up or Down
buttons in the remote controller, to decrease or increase differential temperature
between room and thermostat and flame and fan speed will increase or decrease
as desired. (The bigger the temperature differential the bigger the flame and fan
speed
Note: In the Maximum heat setting the fan speed will be locked in high and can
not allow to be set to medium or low speed , at least your change the heat
setting to medium or low.
TURNING THE APPLIANCE OFF
For either manual or remote mode press the on/ off switch once. The room fan will
continue to operate for a short period while the heater cools down.
Please note:
1.- This appliance can not be operated without the fan running
2.- Due to the performance and efficiency of the heater, steam may be noticed coming
from the flue terminal on cool days
3.- As this appliance has a luminous effect some slight carbon deposition may
Occur in the logs.
4.- During first time firing of this appliance, an odour may be noticed for a short
period as the paint cures. It is advisable to leave the windows open during the first
few hours of the very first operation only.
SAFETY PRECAUTIONS
IMPORTANT POINTS
! DO NOT place articles or clothing on or against this appliance
! DO NOT use or store flammable materials near this heater
! DO NOT place any item containing liquid on the heater
! DO NOT spray aerosol in the vicinity of this appliance when it is in operation
! ALWAYS supervise young children near the appliance
It is recommended that a secondary guard be used,to prevent access to appliance by
children, as outer panels of this appliance may reach high temperatures.
NOTE: In the event the electricity supply cord is damaged it must be replaced with
the original Heatmaster part obtainable from your authorized dealer.
6
