2
3 SPEED UNIVERSAL REMOTE CONTROL
- Lock/unlock switch in the unlock position
allows a common code to be sent .
In the unlock position : The transmitter will send a common code.
In lock position : Allows a unique code to be sent to the receiver in the fan. Only the receiver of this fan will be synced with this transmitter in
lock position. More than one fan can be synced with one transmitter, in this case-follow sync instruction for each fan.
Changing unlock/lock position will cause the code change, and the receiver need synchronizing again to have the same code, otherwise the
receiver will not response to the transmitter.
N
Technical Support:
OTE :
- T
If you need any assistance with setup, operation, or parts for your new GOOD HOUSEKEEPING Ceiling Fan, please call us. Our technical support staff is
ready to help! We are open 24 hours, 7 days a week.
USA: 1-888-880-3267 (FANS)
You may also reach us online at OceanAireHomeGoodsCompany.com
An electronic copy of this user manual can also be obtained online at OceanAireHomeGoodsCompany.com
GOOD HOUSEKEEPING is a trademark of Hearst Communications, Inc.
© 2022 Hearst Communications, Inc. All Rights Reserved.
o prevent damage to transmitter, remove the batteries if not used for long periods.
- Replace batteries as a simultaneous set – always replace the whole set of batteries at one time, taking care not to mix old and new ones, or
batteries of different types.
- Please contact your local batteries recycling centre for proper battery disposal information.
This button turns the fan ON or OFF.
" "
This button delays the light turning off
for approximately 5 seconds, enabling
you to exit your room before the light
turns completely off.
" "
This button controls the power to the light and
also controls the dimming settings. Press and
release the button to turn the light ON or OFF.
Press and hold the button to set the desired
brightness: the light will slowly illuminate to
maximum light output and then stop when
holding the button. Release the button and
hold it again until it reaches minimal
illumination where it will automatically stop
again. The light button has an auto-resume,
it will stay at the same brightness as the
last time it was turned off.
Low speed
Medium speed
High speed
Operation indicator
REMOTE FUNCTIONS
"Lock/unlock" switch
O ” and “ I ” dim switch
For this fan, the dim switch should be in the
“I” position, allowing for dimming of the light.
Place the switch in the “0” position to turn the
dimming feature off if you do not want the
dimming feature.
“ Sync ”
This button allows receiver to pair with the code
assigned by transmitter.
NOTE: For convenience, the transmitter has been preset
by the factory and is placed in unlock position initially.
The receiver has been preset with a common code. The
fan is ready for use. This transmitter can control any fan
with this same initial setting.
