10
MAIN MENU – Screen Overview
AUTO RUN
This screen allows the operator to run a quick job once the job has been created in the job program screen.
The blade speed, quantity and any cutting operation options, such as extra vises, step feed, etc. can be
adjusted from this screen. Refer to the “Auto Run” section of this manual for further instructions.
PROGRAM A JOB
The operator can create a job program by inputting the desired blade pitch, blade speed, length, height,
and quantity. After creating a job program the operator can run it as a quick job or save it to the Job
Library to recall the information at a later time. Refer to the “Program a Job” section of this manual for
further instructions.
VIEW JOB LIBRARY
The Job Library displays information stored by the operator in an interactive data base that contains up to
1000 jobs including the “Quick Job”, along with specific job information such as length, quantity, blade
speeds, etc. It stores a list of programmed jobs that can be reviewed, edited, or called up to run, either as a
single job, or a series of jobs to be run in consecutive order. Refer to the “View Job Library” section of
this manual for further instructions.
PROGRAM A SERIES
To save time and material, the saw has the ability to run a sequence of up to 12 job numbers (cuts) in a
sequence up to 99 times using the “Program Series” icon. 100 sequences can be saved to recall at a later
time. The operator can enter the job information into the Series Overview screen to create these
sequences. There must be jobs programmed in the “JOB LIBRARY” to program a series. Refer to the
“Program A Series” section of this manual for further instructions.
SEMI AUTO CUT
The Semi Auto Cut allows the operator to make a single, semi-automatic cut without creating a job
number or a job program. This is a good option when performing a one-time cut. Refer to the “SEMI
AUTO CUT” section of this manual for further instructions.
MORE
The “MORE” icon provides access to additional setting and features. The operator can adjust settings for
various functions such as arm and feed calibration, review information on the blade life and motor hours,
or access help files that give instructions on changing the saw blade. Refer to the “Control Panel” and
“Help Files” section of this manual for further instructions.
