TROUBLESHOOTING
PROBLEM POSSIBLE CAUSE CORRECTIVE ACTION
Item will not
activate.
• 5.9V 2A adapter is not plugged in.
• Compressor is not plugged in.
• Compressor is not operating
at an output of 50-90 psi.
• Human sensor on the front of the shirt is
obstructed.
• Human sensor wire located under the shirt
is damaged.
• Switch on control box is not in the ON position.
• Check 5.9V 2A adapter is securely
plugged in.
• Check that your compressor is running.
• Check that your compressor is on and
output gauge reads between 50-90 psi.
• Remove any debris, leaves or other
obstructions blocking human sensor
located on front of shirt.
• Check human sensor wire for damage.
• Move control box switch to ON position.
You only hear
item sound but no
item activation.
Only one side of the
item is moving during
activation or you hear
hissing air.
Item has no sound while
operating.
• Air hose is not secured to your compressor.
• Air hose is not secured to the item control box.
• Your compressor is not switched on.
• Your compressor tank has not reached
50-90 psi for item activation.
• Air line connected to piston is loose.
• Air line connected to piston is disconnected.
• Air line connected to the control box is loose
or disconnected.
• Volume knob is turned all the way down. • Adjust volume knob to desired volume.
DISCONNECT ITEM FROM
AIR AND POWER.
• Lift shirt and inspect and secure air
line connections.
• Inspect that the air lines connected to
the pistons are securely fastened into
press fit connections.
• Make sure air line is secured to the
control box.
• Check that your air hose is securely
fastened to your compressor and item
control box.
• Check your compressor is running and
output gauge to confirm the gauge
reads above 50 psi for operation.
Page 8
