hattrick I-CONCEPT Manual de usuario
- 1 -
I-CONCEPT TREADMILL USER MANUAL
- 2 -
INDEX
1. OUTLOOK INSTRUCTION ..............................................................................................................3
2. SAFETY INSTRUCTION...................................................................................................................4
3. GROUNDING WIRES INSTRUCTION ..............................................................................................5
4. ASSEMBLE PART LIST ....................................................................................................................6
5. ASSEMBLE STEPS ..........................................................................................................................7
6. CAUTION ....................................................................................................................................10
7. MAINTENANCE...........................................................................................................................11
8. COMPUTER OPERATION INSTRUCTION......................................................................................12
- 3 -
1. OUTLOOK INSTRUCTION
電子表
電源開關
電源線
過載保護開關
底座
修飾蓋
安全插銷/夾子
電源線
機台主架
后調整盒
Computer
Power switch
Power cord
Circuit breaker
Safety clip
Power wire
Frame
Base
Rear end cap
Decorative cover
- 4 -
2. SAFETY INSTRUCTION
When using this product, basic precautions should always be followed, including the
following:
Please read the instruction carefully before starting to use this product.
DANGER –To reduce the risk of electric shock：
1. Always unplug this product from the electrical outlet immediately after using and before
cleaning.
WARNING –To reduce the risk of burns, fire, electric shock, or physical injury：
1. The product should never be left unattended while plugged in. Unplug the product from the
outlet when not in use.
2. Close supervision is necessary when this product is used by or near children, invalids, or
disabled persons.
3. Be sure to use the product only for its intended use as described in this manual. Do not use
any attachment not recommended by the manufacturer in order to avoid any danger or
accidents.
4. Never operate the product if it has a damaged cord or plug, if it is not working properly, if it
has been damaged, or dropped into water. Please return the product to the service center of
seller for examination and repair.
5. Do not carry this product by the supply cord or use the cord as a handle.
6. Keep the cord away from hot surfaces or ground.
7. Never operate the product with the air vents blocked. Keep the air vents free of lint, hair, etc.
8. Never drop or insert any objects into any openings.
9. Do not use or operate outdoors.
10. Do not operate where aerosol (spray) products are being used or where oxygen is thin.
11. Before turning the product power off, turn all controls to the off position then remove the
plug from the outlet.
- 5 -
12. Connect the product to a properly grounded outlet only.
13. If the power cord is damaged, be sure to ask the manufacturer for replacement to avoid
accidents. The seller and correlative qualified professionals are as well as eligible.
3. GROUNDING WIRES INSTRUCTION
The products must be grounded first. If malfunction or breakdown occurs, grounding will provide a
path of least resistance for electric current to reduce the risk of electric shock.
The product is equipped with a cord having an equipment-grounding conductor and a grounding
plug.
The plug must be plugged into an appropriate outlet that is properly installed and grounded in
accordance with all local codes and ordinances.
DANGER –Improper connection of the equipment-grounding conductor can result in a risk of
electric shock. Check with a qualified electrician or serviceman if you are in doubt as to whether
the products are properly grounded. Do not modify the plug provided with the product –if it will
not fit the outlet, have a proper outlet install by a qualified electrician.
The product is for use on nominal 220V-240V and has a grounding plug that looks like the plug
illustrated in the figure. Make sure that the product is connected to an outlet having the same
configuration as the plug.
There is no need to use any adapter for this product.
Grounding methods
GROUNDED
OUTLET
GROUNDING END
6
4. ASSEMBLE PART LIST
abce
dfghi
A
B
C
D
E
j
ITEM
DESCRIPTION
Q'TY
ITEM
DESCRIPTION
Q'TY
A
Frame
1
a
Nylon nut M6×P1.0
4
B
Computer console set
1
b
Truss hex screw M8xP1.25x40
4
C
Decorative cover left
1
c
Truss hex screw M8xP1.25x90
2
D
Decorative cover right
1
d
Safety key set
1
E
I-PAD Sucker
2
e
Truss Philips screw M5xP0.8x15
6
F
f
Wrench
1
G
g
Hex wrench+screwdriver 5mm
(70mmX70mm)
1
H
h
L-hex wrench
1
I
i
SLILCON
1
J
j
Washer Ø16xØ6x1.0t
4
7
5. ASSEMBLE STEPS
WARNING:
After assembly the treadmill, then you
can untie the loincloth.
A
© T© w§ô±a
Two persons are required to finish the
assembly steps.
Caution: Please follow exactly the
assembly steps below to avoid injury.
1. Put up the handrail tubes of Frame(A)
as the arrow shows in the right
drawing and tighten with Hex
Screw(b).
Ps. To avoid unexpected accident,
always assemble the treadmill with
more than two workers, do not
assemble by yourself.
b
b
Loincloth
8
2. Put up Upright (L&R) as shown in
the right drawing and tighten with
Hex Screw(b),(c).
Ps. To avoid unexpected accident,
always assemble the treadmill with
more than two workers, do not
assemble by yourself.
b
b
c
c
3. After finished the above steps and
you can untie the loincloth, then
wedge decorative cover(C,D) into
the frame respectively as shown in
the right drawing and tighten with
Philips screw(e).
e
e
C
D
9
4. Connect the middle control wire with
the upper control wire, then put the
computer set as right image and
tighten with nylon nut (a) and
washer(j)
a
B
j
5. When you need to use the IPAD,
Please paste the suction cups for
suitable place on the computer,
then you can put your IPAD on the
holder and sucked with suction cups
to avoid the IPAD falling out
§l½ L I-PAD
Sucker
10
6. CAUTION
This treadmill has the foldable mechanism for
storage. Stop all the movements (including stop the
running belt and take off the power cord) before
storage, then pull out the POP-Pin of the folding
fixing mechanism as the direction shown in the
drawing and then lift up the frame until the
POP-Pin inserts into the frame. When doing this
action, two persons are needed. One puts up the
frame and another pulls out the POP-Pin of the
folding fixing mechanism. On the contrary, if you
want to use the treadmill, pull out the POP-Pin of
the folding mechanism as the arrow shows in the
drawing and put down the frame slowly
Ps.1.To prevent from danger, be careful if the kids
are around.
Ps.2. If you want to move the treadmill, fold the
treadmill at first, hold the rear adjust cap with your
hands, then lean the treadmill and do not move
the treadmill until the roller can be moved
smoothly.
Ps.3. To avoid the injury, do not move the treadmill
on uneven ground.
Tabla de contenidos
Otros manuales de Rueda de andar de hattrick
hattrick
hattrick STYLE M Manual de instrucciones
hattrick
hattrick Energy Manual de usuario
hattrick
hattrick MATRIX Manual de instrucciones
hattrick
hattrick Sensation Manual de usuario
hattrick
hattrick VISION Manual de instrucciones
hattrick
hattrick TRENDY M Manual de usuario
hattrick
hattrick OLYMPIC Manual de usuario
hattrick
hattrick ARENA Manual de usuario
hattrick
hattrick EVOLUTION Manual de usuario
hattrick
hattrick TRAINER Manual de usuario
Manuales populares de Rueda de andar de otras marcas
Smooth Fitness
Smooth Fitness EVO 3i Manual de usuario
NordicTrack
NordicTrack NETL81810.0 Manual de usuario
Schwinn
Schwinn 830/Journey 8.0 Manual de usuario
Keys Fitness
Keys Fitness HealthTrainer HT-740T Manual de usuario
Spirit
Spirit XT8 Manual de usuario
NordicTrack
NordicTrack T 14.0 Treadmill Manual de usuario