FOR OVER 50 YEARS HATCO
HAS MADE DISHWASHING
CLEANER, SAFER & MORE EFFICIENT!
MANCE!
The Quality’s Built-In. The Features Stand Out!
H
Low-water
cut-off
probe.
Front & side
panels are easily
removed for
service.
Stainless steel
top and front.
Tank
insulation.
Stainless
steel tank.
Finned-tube copper
heat exchanger.
Heat exchanger
insulation.
Air vents contributing
to cooling & providing
secondary air.
Pilot lit burner
system (automatic
spark ignition).
Burners.
Manual reset
tank high limit.
System limit
warning light.
On/off
toggle
switch.
On/off
indicator
light.
Security
protective
guard.
Flex water
connections
for ease of
service.
Recirculating
system enhances
temperature
stability.
Powder
coated steel
base & sides.
Temperature
control probe.
Model PMG-60
Unit drain.
atco’s famous 180ºF. (82ºC)
sanitizing hot water and long
life dependability is now
available from a new gas booster water
heater called Powermite.
®With three
models which can operate on natural
or propane gas, Powermite features a
burner system that utilizes both primary
and secondary air for consistent ignition.
PMG-200...for large, conveyor-type
dishwashing operations. This 195,000
BTU gas booster water heater is
equivalent to approximately 45kW and
provides up to 480 GPH (1817 LPH) @
8gpm of hot sanitizing rinse water and
has a 5-gallon (19 liter) storage capacity.
For installer hookup an exhaust venting
is provided by a forced draft system with
a 4" (10 cm) diameter vent pipe adapter
to meet regulatory and local codes.
PMG-100...for 2-tank, conveyor
machines. Has 105,000 BTU heating
capacity with a storage capacity of
5 gallons (19 liters) and is equivalent to
approximately 24kW. For installer hookup
an exhaust venting is provided by a
forced draft system with a 4" (10 cm)
diameter vent pipe adapter to meet
regulatory and local codes.
PMG-60...for single-tank, door-type
dish machines. Has 58,000 BTU heating
capacity with a storage capacity of 3.2
gallons (12 liters) and is equivalent to
approximately 13.5kW. This unit can
naturally and safely vent directly into the
room and does not require through-the-
wall venting to the outside. An optional
hood is available to redirect exhaust to
existing ventilation. Consult local codes
for venting requirements.
Built-in
heat trap.
Stainless Steel
Body & Base...
provides extra
durability and
excellent corrosion
resistance for years of
dependable service.
Shown with optional
hood for redirecting exhaust
(available on PMG-60 only).
