figure8
如图8
3. 控制推进器的速度
Speed control
推进器手柄上印有电机正反行驶的指示档位
（0 档为
停止运行状态，前进档数有5位，
后退有3位）。由
顺时针方向转动手柄为进，逆时针为退。档数越高速
度越快。(如图.8)
figure9
如图9
如图10
figure10
4．如何固定船只的行驶方向
Tension the steering
5．调节推进器的吃水深度
Adjust the motor depth
Loosen the steering tension screw, set the motor
to a desired direction and fasten it again. (figure.9)
7
操作方式
How to operate the motor
松开深度定位套上的螺栓。将定位套调节至合适
的
位置再上紧螺栓固定。用手握住推进器支杆，然
后松开方向定位螺栓调节吃水深度。（如图.10）
Steady the motor shaft and set the depth collar to a
desired position then secure it. Loosen the steering
tension screw and deploy the motor carefully.
(figure.10)
The speed controller is integrated in the handle. It offers
5 levels of forward speed and 3 levels of reverse
speed.Turning the handle to the neutral position will
shut down the motor from running. (figure.8)
电源安装及电量指示：
Battery connection and
power reader
figure.3
如图3
船舶安装
Mounting the trolling motor
在接通电源前，务必确保变速手柄上的档
位为0档。
Make sure the motor is off (handle on
neutral), while connecting the battery.
选择合适电源 — 请使用深循环蓄电池。使用
电压不符或不稳定蓄电池都可能导致电机或电
池的损坏。
Select a compatible battery --- Please use deep
cycle battery for your motor. Improper use of
battery would cause damage to the motor.
Make sure the motoris battery
disconnected during the mounting and
dismounting or onshore period.
请勿在安装及卸载推进器时接通电源或启
动电机，以防意外发生。
1.电源安装
Battery connection
连接电源—请将红色（+）正极电源线末端连
接至电池的正极处（+），黑色（-）负极电源
线末端连接至负极处（-）并固定。（如图.4）
Connecting the battery - connect the red motor
cable (+) to the positive battery terminal (+),
black cable (-) to the negative terminal and
fasten it. (figure.4)
把电池放置在通风干爽的位置。
Put the battery in a ventilated place.
Mounting the trolling motor on the centerline of
the boat, tighten the clamp screws. (figure.3)
请将推进器安装在船尾板的中段位置,再上紧推进
器支架上的两个螺栓。（如图.3）
4
安装
Installation
figure.4
如图4
Deep cycle
Battery
BLACK B-RED B+
