HARTRIDGE LTD OPERATING & MAINTENANCE MANUAL
HB385
HL028 Issue 2 (H1407), September 09 7
Health and Safety Data Sheet for Calibration Fluid (ISO 4113)
HEALTH & SAFETY DATA SHEET DATE Pub.
No.
Information regarding the safe handling & storage of the named product. MAR 97
Applicable to employees and customers.
PRODUCT WARNING
CALIBRATION FLUID (ISO 4113) SEEK IMMEDIATE MEDICAL ATTENTION
IF INGESTED
USE CLASSIFICATION
TEST FLUID FOR DIESEL INJECTORS, FLAMMABLE
INJECTION PUMPS & OTHER DIESEL EQUIPMENT
PRODUCT DESCRIPTION - COMPOSITION
THESE FLUIDS ARE PETROLEUM BASED PRODUCTS CONTAINING SIGNIFICANT PROPORTIONS
OF THE MORE VOLATILE PETROLEUM FRACTIONS AND OTHER SOLVENTS USED FOR
LUBRICATION, ANTI-CORROSION AND DERMATITIC INHIBITION.
SAFE HANDLING ADVICE (Protection - Usage, Storage & Transport)
USAGE: 1) Avoid eye splashes and extended skin contact.
2) Do NOT take internally.
3) Keep mist generated by machinery to a minimum, also avoid where possible
vapours caused by elevated temperatures.
4) Protective clothing to be regularly laundered.
STORAGE: These are flammable products which should be stored in closed containers away from
heat in a well ventilated area.
EMERGENCY & FIRST AID PROCEDURE (Eyes, skin, ingestion, inhalation)
INGESTION: Do NOT induce vomiting. Give a glass of water and get immediate medical attention at
Hospital.
EYES: Flush with large amounts of water for 15 minutes. Seek medical help if irritation
persists.
SKIN: Wash thoroughly with soap & water. Seek medical help if irritation or skin rashes occur.
Remove any contaminated clothing.
INHALATION: Inhalation includes oil mists or vapours. Remove victim to fresh air. Seek medical help
if affliction persists.
FIRE HAZARDS & PROTECTION (Flash point, spillage)
SPILLAGE: Contain spillages with sand or mineral absorbent material. Mop up and clean floor to
remove oil residue.
FLASH POINT: Above 75°C.
FIRE: (Extinguisher media)
Use carbon dioxide, dry chemical powder or foam extinguishers. Do NOT use water jets.
ENVIRONMENTAL PROTECTION (Spillage land/water, disposal)
SPILLAGE: Advise authorities if product has entered or may enter sewers, water courses or
extensive land areas.
DISPOSAL: All waste should be put into identified containers and stored at a specific disposal
point.
Arrange for off site disposal in accordance with local regulations for notified waste.
HARTRIDGE LTD
The Hartridge Building, Network 421, Radclive Road
Buckingham, MK18 4FD, United Kingdom
THE INFORMATION AND RECOMMENDATIONS IN THIS PUBLICATION ARE TO THE BEST OF OUR KNOWLEDGE
INFORMATION AND BELIEF ACCURATE AT THE TIME OF PUBLICATION NOTHING HEREIN TO BE CONSTRUED AS A
WARRANTY, EXPRESS OR IMPLIED IN ALL CASES. IT IS THE RESPONSIBILITY OF THE USERS TO DETERMINE THE
SUITABILITY OF ANY PRODUCTS FOR THEIR OWN PARTICULAR PURPOSE. RECOMMENDATIONS FOR HANDLING,
PROTECTION ETC. ARE ADVISORY ONLY.
