Super Slicer
Operation
NOTE: BEFORE OPERTATING YOUR
NEW SUPER SLICER MAKE A COMPLETE
INSPECTION OF ALL COMPONENTS TO
INSURE THAT ALL THE NUTS AND BOLTS
ARE TIGHT AND THAT NO DAMAGE HAS
OCCURRED DURING SHIPPING.
HYDRAULIC REQUIREMENTS
Your new DEWEZE SUPER SLICER is de-
signed to be used as a mobile feeding unit
mounted on a trailer or as a stationary unit
in a permanent installation. Regardless of
the type of use the SUPER SLICER WILL
REQUIRE 15 GPM (gallons per minute) of
hydraulic oil ow and a minimum of 1800 PSI
(pounds per square inch) hydraulic pressure
to operate properly. Be sure that the hydrau-
lic system you intend to use is functioning
properly and that the oil is clean and of good
quality.
Two hydraulic remotes are required to oper-
ate the trailer mounted Super Slicer. One is to
control the lift arm for loading the bales and
the other is to operate the slicer table. Each
remote must be capable of reversible ow.
You may want to mark the remotes to make
sure that you hook up the hydraulics the
same way each time you use the machine.
NOTE: When using a hydraulically driven
Super Slicer II continuously (for more than
3 bales in 10 minutes) the following adjust-
ments must be made to tractors equipped
with a high ow, pressure compensated load
sense hydraulic system.
1. Flow (speed) must be controlled on
the tractor remote outlet. To set this
speed rst set the Slicer ow as
outlined in the manual. Secondly,
turn the ow control toward the “turtle”
on the tractor selective control outlet
until the speed begins to decrease.
Stop turning as soon as you can notice
a decrease in speed. Failure to follow
these procedures may result in the
overheating of the tractor hydraulic
system, as the system will be at
maximum ow and pressure. (Load is
sensed at the tractor selective control
valve and if this valve is wide open the
system is at constant maximum
pressure / ow.
2. The alternative to the above is to buy a
“ow limiter valve” and attach it
between the quick disconnect and the
hose on the pressure side.
3. On PTO model Super Slicer II, ow
must also be regulated at the selective
control outlet for the slat motor.
NOTE:
If the above instructions are not fol-
lowed, the following symptoms may develop:
Rapid heating of the tractor hydraulic
oil, this will show up as a loss of speed
on the hydraulic motor speed. These
motorsloseefciencyrapidlywhenoil
over heats.
7
