-8- -9-
Note:
Bluetooth connection rangein 10 meters;
The model SoundPiece mini inyour
device was notdeleted;
After 15 minutesin AUXin mode without
music playback status, the speakergo to
sleep status andyou need tohold down
[STANDBY] button for 3 seconds to going to
standby status,then press[STANDBY]
button to wakesup the speaker.
clear the pairedmemory history by
pressing 'standby' buttonfor 2 timesand the
speaker would notrepaired automatically .
BLUETOOTH CONNECTION
The bluetooth pairingmodel of the
speaker is SoundPiece mini ,power on the
speaker then useyour smart phoneto
search the bluetoothsignal of theunit, the
unit will synchronizeto play songson your
smart phone whilethey connected
successfully.
The speaker needto input thepassword
0000 when thematching bluetooth device
under version 2.1.
The bluetooth speakrwill turn tostandby
status after 15minutes without bluetooth
connections, at thistime , thebluetooth
speaker will emitthe voice ofPower Off.
press [STANDBY] button towakes up the
speaker.
When the operationtoo frequently orother
reason to disturbthe bluetooth reconnected,
please use manuallyconnect on the
bluetooth device.
The bluetooth isconnected to yoursmart
phone successfully forthe first time,
disconnect the bluetoothon your smart
phone then reconnectedit, the speakerwill
memories your smartphone and repaired
automatically.
Bluetooth Model:
Sound Piece mini
TROUBLESHOOTING
-10-
No power
Music is not
playing over
bluetooth
Bluetooth
device will not
reconnect with
the speaker
Try and power the
bluetooth speaker using
a different outlet or check
the connection ofthe DC
adapter.
Make sure yourbluetooth
device hasA2DP.
Check if bothdevices are
paired and connected
over bluetooth.Restart
the bluetooth speakerto
reconnect your bluetooth
device.
Navigate to your bluetooth
settings menu on your
bluetooth device, tap
”,and select
“
“Forget”.now follow the steps
to pair your device again.
Sound
Piece mini
means that yourelectrical and
electronic equipment shouldbe
desposed at theend of itslife separately
from your householdwaste.
There are separatecollection systems
for recycling inthe EU. Formore
information, please contactthe local
authority or yourretailer where you
purchased the product.
Industry Canada Notice
This device complieswith Industry Canada
license-exempt RSS standard(s).
Operation is subjectto the followingtwo
conditions:
(1) this devicemay not causeinterference,and
(2)this device mustaccept any interference,
including interference thatmay cause
Undesired operation ofthe device.
This Class Bdigital apparatus complieswith
Canada ICE-003.
CAN ICES-3(B)/NMB-3(B)
FCC STATEMENT:
1.This device complieswith part 15of the FCC
Rules.Operation is subjectto the followingtwo
conditions:
(1) This device may not cause harmful
interference.
(2) This device must accept any interference
received, including interferencethat may cause
undesired operation.
2.Changes or modificationsnot expressly
approved by theparty responsible for
compliance could voidthe user’s authority to
operate the equipment.
NOTE: This equipment has been tested and
found to complywith the limits for a Class B
digital device, pursuantto Part 15 of the FCC
Rules. These limits are designed to provide
reasonable protection against harmful
interference in aresidential installation.
This equipment generatesuses and can radiate
radio frequency energyand,if not installed and
used in accordancewith the instructions , may
cause harmful interferenceto radio
communications.
However, thereis no guarantee that
interference will not occur in a particular
installation . Ifthis equipment does cause
harmful interference toradio or television
reception, which canbe determined by turning
the equipment off and on,the user is
encouraged to tryto correct the interference by
one or moreof the following measures:
Reorient or relocatethe receiving antenna.
Increase the seperationbetween the equipment
and receiver.
Connect the euipmentinto an outlet on a circuit
different from that to which the receiver is
connected.
Consult the dealeror an experienced radio/TV
technician for help.
RF warning statement:
The device hasbeen evaluated to meet general
RF exposure requirement. The device can be
used in portableexposure condition without
restriction.
-11-
-12- -13-
IC:10485A-BL5601
- French:
Le présent appareil est conforme aux CNR d'Industrie
(1) l'appareil ne doit pas produire de brouillage, et
Canada applicables aux appareils radio exempts de
licence. L'exploitation est autorisée aux deux conditions
suivantes :
(2) l'utilisateur de l'appareil doit accepter tout brouillage
radioélectrique subi, même si le brouillage est
susceptible d'en compromettre le fonctionnement."
