HAMPTON BAY DYX1701A Manual de usuario

Page 1

INSTRUCTION MANUAL

1LT Exterior Mini-Pendant or Flushmount

The Home Depot Model DYX1701A(UPC 6940500313795)

Page 2

Thank you for purchasing this Hampton Bay exterior mini-pendant or

flushmount. This product has been manufactured with the highest standards of

safety and quality. The finish of this fixture is weather resistant but over time

will naturally weather and fade.

FEATURES:

1. One-light exterior mini-pendant or flushmount in Oil Rubbed Bronze

finish with Clear Seedy glass.

2. This fixture comes with 2 rods, each 12 inches in length. The height of

the fixture can be adjusted by using fewer rods. This way, the fixture can

be assembled as a mini-pendant or a flushmount.

3. This fixture has been engineered to safely use one 60 watt medium base

incandescent light bulb (do not exceed 60 watts) (not included).

4. For energy savings, this fixture has been engineered to safely use one

standard base compact fluorescent light bulb (for equivalent light output,

do not exceed 15 watts) (not included).

QUESTIONS, PROBLEMS, MISSING PARTS:

Before returning to your local The Home Depot, please call our Customer

Service Team at 1-877-527-0313 or visit www.homedepot.com. Please

reference your Model DYX1701A or UPC 6940500313795.

Page 3

CAUTION:

1. Before starting installation of this fixture or removal of a previous fixture,

disconnect the power by turning off the circuit breaker or by removing

the fuse at the fuse box.

2. CONSULT A QUALIFIED ELECTRICIAN IF YOU HAVE ANY

ELECTRICAL QUESTIONS.

3. If you have any non-electrical questions about this fixture, please contact

our Customer Service Team at 1-877-527-0313 or visit

www.homedepot.com. Please reference your Model DYX1701A or UPC

6940500313795.

4. Keep your receipt and these Instructions for Proof of Purchase.

TOOLS REQUIRED FOR ASSEMBLY & INSTALLATION

(not included):

Light Bulb Safety Goggles Ladder Gloves Wire Strippers

(60 watt maximum)

(or CFL equivalent)

Flathead Screwdriver Phillips Screwdriver Electrical Tape Wire Cutters Silicon Rubber Sealant

for exterior use

Page 4

PARTS INCLUDED FOR ASSEMBLY (parts are not to scale):

1ea Canopy (#1) 1ea Bushing (#5) 1ea Nipple A (#7)

1ea Nipple (#4) 1ea Rod B (#6) 1ea Rod A(#8)

1ea Shade (#12) 2ea Screws (#13) 1ea Decorative Frame (#14) 1ea Bushing A (#23)

ASSEMBLY INSTRUCTIONS:

1. Carefully unpack the fixture. Lay out all parts on a clean surface. This fixture

can be installed as a mini-pendant, or as a flushmount.

2. For a mini-pendant, weave the fixture wires up through Rod A (#8), through

Rod B (#6), and through the Nipple (#4) on the Canopy (#1). The height of the

fixture can be adjusted by using fewer rods (each rod is 12 inches long). For a

flushmount, weave the fixture wires through Bushing A (#23) and then through

the Nipple (#4) on the Canopy (#1).

3. For a mini-pendant, screw Rod A (#8) onto Nipple B (#9). Screw Rod B (#6)

onto Nipple A (#7). Screw the Nipple (#4) into the Bushing (#5). For a

flushmount, screw Bushing A (#23) onto Nipple B (#9). Screw Bushing A (#23)

onto the Nipple (#4).

4. For either fixture, install a 60 watt medium base incandescent light Bulb (#11)

(not included) or an equivalent standard base compact fluorescent light bulb

(not included) in the Socket (#10).

5. For either fixture, screw the Shade (#12) into the Cover (#22). Place the

Decorative Frame (#14) over the Shade (#12), and align the two holes on the top

of the Decorative Frame (#14) to line up with the two holes underneath the Top

Cover (#21). Use a screwdriver to screw the two Screws (#13) through the two

holes on the Decorative Frame (#14) to secure it to the Top Cover (#21).

Page 5

ASSEMBLY:

Page 6

PARTS INCLUDED FOR INSTALLATION (parts are not to scale):

2ea Washers (#2) 2ea Lock Nuts (#3) 3ea Wire Connectors (#16) 1ea Cross Bar (#17)

2ea Outlet Box Screws (#18) 1ea Ground Screw (#19) 2ea Mounting Screws (#20)

INSTALLATION INSTRUCTIONS:

1. Screw the two Mounting Screws (#20) into the Cross Bar (#17). Mount the Cross

Bar (#17) to the Outlet Box (#15) using the two Outlet Box Screws (#18). [Make

sure the threads of the Mounting Screws (#20) are facing outside when the Cross

Bar (#17) is attached to the Outlet Box (#15).]

2. Wrap the ground wire from the fixture around the Ground Screw (#19) on the Cross

Bar (#17), and then connect the ground wire from the fixture to the ground wire

from the Outlet Box (#15). Connect the white wire from the fixture to the white

wire (neutral wire) from the Outlet Box (#15). Connect the black wire from the

fixture to the black wire (live wire) from the Outlet Box (#15). Cover the three

connections using the three Wire Connectors (#16). Wrap the three wire

connections with electrical tape for a more secure connection. Position the wires

back inside the Outlet Box (#15). Note: If you have electrical questions, consult

your local electrical code for approved grounding methods.

3. Place the Canopy (#1) over the Outlet Box (#15). Allow the threads of the

Mounting Screws (#20) to come out through the appropriate holes on the Canopy

(#1). Place the two Washers (#2) over the two Mounting Screws (#20). Screw the

two Lock Nuts (#3) onto the two Mounting Screws (#20) to tighten the Canopy (#1).

4. Once the fixture is mounted on the ceiling, caulk the space between the ceiling and

the whole area around the Canopy (#1) to prevent water seeping into the Outlet Box

(#15).

5. Installation is complete. Turn on the power at the circuit breaker or fuse box. Turn

the light switch on to activate the fixture.

Page 7

INSTALLATION:

Page 8

TROUBLESHOOTING:

PRODUCT MAINTENANCE:

1. To clean the outside of the fixture, use a dry or slightly dampened clean cloth (use clean

water, never a solvent) to wipe the glass and surface of the fixture.

2. To clean the inside of the fixture, first disconnect power to the fixture by turning off the

circuit breaker or by removing the fuse at the fuse box. Next, use a dry or slightly

dampened clean cloth (use clean water, never a solvent) to wipe the inside glass and

interior surface of the fixture.

3. Do not use any cleaners with chemicals, solvents or harsh abrasives. Use only a dry soft

cloth to dust or wipe carefully.

LIMITED WARRANTY

The manufacturer warrants this lighting fixture to be free from defects in materials and workmanship for a period

of three (3) years from date of purchase. This warranty applies only to the original consumer purchaser and only

to products used in normal use and service. If this product is found to be defective, the manufacturer’s only

obligation, and your exclusive remedy, is the repair or replacement of the product at the manufacturer’s

discretion, provided that the product has not been damaged through misuse, abuse, accident, modifications,

alterations, neglect or mishandling. This warranty shall not apply to any product that is found to have been

improperly installed, set-up, or used in any way not in accordance with the instructions supplied with the product.

This warranty shall not apply to a failure of the product as a result of an accident, misuse, abuse, negligence,

alteration, or faulty installation, or any other failure not relating to faulty material or workmanship. This

warranty shall not apply to the finish on any portion of the product, such as surface and/or weathering, as this is

considered normal wear and tear. The manufacturer does not warrant and specially disclaims any warranty,

whether express or implied, of fitness for a particular purpose, other than the warranty contained herein.

The manufacturer specifically disclaims any liability and shall not be liable for any consequential or

incidental loss or damage, including but not limited to any labor / expense costs involved in the

replacement or repair of said product.

Problem

Possible Cause

CorrectiveAction

Light bulb will not

illuminate.

1. Light bulb is burned out.

1. Replace light bulb.

2. Power is off.

2. Make sure power supply is on.

3. Faulty wire connection.

3. Check wiring.

4. Faulty switch.

4. Test or replace switch.

Fuse blows or circuit

breaker trips when

light bulb is

illuminated.

Crossed wires or power wire

is grounding out.

Check wire connections.

Page 9

MANUAL DE INSTRUCCIONES

Mini colgante o Plafón

para exteriores de 1 luz

The Home Depot Modelo DYX1701A (UPC 6940500313795)

Page 10

Gracias por comprar esta mini colgante o plafón Hampton Bay para

exteriores. Este producto ha sido manufacturado con los estándares de

seguridad y calidad más altos. El acabado de esta farola es resistente a la

climatología pero con el tiempo se desgastaráy descolorearánaturalmente.

CARACTERÍSTICAS:

1. Mini colgante o plafón para exteriores de una luz en acabado en Bronce

Frotado con Aceite con cristal Granulado.

2. Esta instalación viene cn 2 varas, cada una de 12 pulgadas de longitud. La

altura de la instalación puede ser ajustada usando menos varas. De esta

forma la instalación puede ser montada como mini colgante o plafón.

3. Esta instalación ha sido diseñada para usar con seguridad una bombilla de

luz incandescente de base medio de hasta de 60 vatios (no exceder de 60

vatios) (no incluido).

4. Por ahorro de energía, esta instalación ha sido diseñada para usar con

seguridad una bombilla de luz fluorescente compacta estándare de base

medio (no exceder de 15 vatios) (no incluido).

PREGUNTAS, PROBLEMAS, PARTES QUE FALTAN:

Antes de devolver a su The Home Depot local, por favor llame a nuestro

Equipo de Atención al Cliente al 1-877-527-0313 o visite

www.homedepot.com. Por favor haga referencia de su Modelo DYX1701A o

UPC 6940500313795.

Este manual sirve para los siguientes modelos

Tabla de contenidos

Idiomas:

Otros manuales de Luz exterior de HAMPTON BAY

HAMPTON BAY

HAMPTON BAY KECP10-LED Manual de usuario

HAMPTON BAY

HAMPTON BAY NXT-1007 Manual de usuario

HAMPTON BAY

HAMPTON BAY NXT-DP02 Manual de usuario

HAMPTON BAY

HAMPTON BAY HD33870 Manual de usuario

HAMPTON BAY

HAMPTON BAY 114-784 Manual de usuario

HAMPTON BAY

HAMPTON BAY 436-243 Manual de usuario

HAMPTON BAY

HAMPTON BAY Home Depot 756-001 Manual de usuario

HAMPTON BAY

HAMPTON BAY CHARLOTTE LDR1603AX-01 Manual de usuario

HAMPTON BAY

HAMPTON BAY 594-817 Manual de usuario

HAMPTON BAY

HAMPTON BAY IWH5301 Manual de usuario

HAMPTON BAY

HAMPTON BAY LVFM-07D3C-05 Manual de usuario

HAMPTON BAY

HAMPTON BAY 84075 Manual de usuario

HAMPTON BAY

HAMPTON BAY LBO-N1BR3000K6B Manual de usuario

HAMPTON BAY

HAMPTON BAY GALE HDP11973 Manual de usuario

HAMPTON BAY

HAMPTON BAY 82140 Manual de usuario

HAMPTON BAY

HAMPTON BAY CA JD-AU10017 Manual de usuario

HAMPTON BAY

HAMPTON BAY NTX-2336 Manual de usuario

HAMPTON BAY

HAMPTON BAY PERDIDO RFSW6300L30RSPC Manual de usuario

HAMPTON BAY

HAMPTON BAY KIF1801LX-01/AL Manual de usuario

HAMPTON BAY

HAMPTON BAY 5284002012 Manual de usuario

HAMPTON BAY

HAMPTON BAY MILLBROOK HDP06527BL Manual de usuario

HAMPTON BAY

HAMPTON BAY 18165-000 Manual de usuario

HAMPTON BAY

HAMPTON BAY KJC2601LM-01 Manual de usuario

HAMPTON BAY

HAMPTON BAY HSP5101LX-03/MB Manual de usuario

Manuales populares de Luz exterior de otras marcas

Sealey

Sealey LED37 Manual de usuario

nordlux

nordlux VEJERS Guía del usuario

SImx

SImx ELITE LED LHTC637 Manual de usuario

GEV

GEV CAROLINE 10833 Manual de usuario

NEBO

NEBO NEB-LSP-0020 Manual de usuario

WE-EF

WE-EF PFL540 LED Manual de usuario

Lindby

Lindby 9949029 Manual de usuario

HEPER

HEPER DOGO Side LW6048.585-US Instrucciones de instalación y funcionamiento

HEPER

HEPER LW8034.003-US Instrucciones de instalación y funcionamiento

Maretti

Maretti VIBE S 14.6080.04.A Manual de usuario

BEGA

BEGA 84 253 Manual

HEPER

HEPER MINIMO Instrucciones de instalación y funcionamiento

LIGMAN

LIGMAN BAMBOO 3 Manual de usuario

Maretti

Maretti TUBE CUBE WALL 14.4998.04 Manual de usuario

Maxim Lighting

Maxim Lighting Carriage House VX 40428WGOB Manual de usuario

urban ambiance

urban ambiance UQL1273 Manual de usuario

TotalPond

TotalPond 52238 Manual de usuario

Donner & Blitzen

Donner & Blitzen 0-02661479-2 Manual de usuario