Hammond Manufacturing CLHAN-01 Manual de usuario
PAGE OF
REV.
BUL10482
A
2
HARDWARE ASSEMBLY INSTRUCTIONS FOR
INSTALLING CLHAN-01
visit our website @
www.hammondmfg.com
TOOL BOX
1
Phillips
Screw Driver
REMOVE 2 SCREWS
ND RET INING BOLT
PUSH OUT PL STIC
H NDLE SSEMBLY
INSTRUCTIONS FOR
REPLACING LOCK ON DC100 CABINET
**ENSURE TO
HOLD LOCK ROD
SSEMBLY SO IT
DOES NOT F LL
WHEN REMOVING
H NDLE SSEMBLY**
PUSH TOP OF H NDLE
SSEMBLY OUT FIRST
PL CE BOTTOM OF NEW
H NDLE IN FIRST THEN PUSH
TOP INTO LOCK ROD SSEMBLY
INST LL 2 PROVIDED
SCREWS (RET INING
BOLT NOT REQUIRED)
NOTE: Provided back late is not needed on DC100
HARDWARE
REV.
BUL10482
A
ASSEMBLY INSTRUCTIONS FOR
INSTALLING CLHAN-01
PAGE OF 22
INSTRUCTIONS FOR INSTALLING
ON COLO CABINET
PL CE BOTTOM OF H NDLE IN
CUTOUT FIRST THEN PUSH ND HOLD
FLUSH WITH OUTSIDE OF DOOR
INST LL B CK PL TE
WITH 'WINGS' TOW RDS
TOP (SEE PICTURE)
USE SUPPLIED SCREWS
INST LL C M WITH
BUMP TOW RDS INSIDE
OF LOCK H NDLE
USE PROVIDED RET INING
BOLT TO SECURE C M
Este manual sirve para los siguientes modelos
1
Tabla de contenidos
Otros manuales de Cerrar de Hammond Manufacturing
