Hama 00184154 Manual de usuario
TX
RX
00
184154
BLUETOOTH®AUDIO TRANSCEIVER
Bluteooth®-Audio-Sender/Empfänger
GOperating Instructions DBedienungsanleitung FMode d‘emploi
EInstrucciones de uso NGebruiksaanwijzing PInstrukcja obsługi
MManual de utilizare CNávod k použití QNávod na použitie
RРуководство по эксплуатации
TX
RX
1
2
3
4
5
2
Thank you for choosing a Hama product.
Take your time and read the following instructions and information completely. Please keep these
instructions in a safe place for future reference. If you sell the device, please pass these operating
instructions on to the new owner.
1. Controls and displays
1. TX/RX switch
2. Multi-function button (MFB)
3. Status LED
4. Audio input (3.5 mm)
5. Micro-USB connection
2. Explanation of warning symbols and notes
Warning
This symbol is used to indicate safety instructions or to draw your attention to specic hazards
and risks.
Note
This symbol is used to indicate additional information or important notes.
3. Package contents
•1x "BT-Senrex" Bluetooth audio transmitter / receiver
•1x micro-USB charging cable
•1x 3.5 mm AUX cable
•1x operating instructions
4. Safety instructions
•The product is intended for private, non-commercial use only.
•Protect the product from dirt, moisture and overheating and use it in dry environments only.
•Do not use the product in the immediate vicinity of heaters, other heat sources or in direct
sunlight.
•While driving a car or using sports equipment, do not allow yourself to be distracted by your
product and keep an eye on the trac situation and your surroundings.
•Do not drop the product and do not expose it to any major shocks.
•Do not operate the product outside the power limits given in the specications.
•Do not open the device or continue to operate it if it becomes damaged.
•The battery is permanently installed and cannot be removed; dispose of the product as a whole in
accordance with the statutory regulations.
•Dispose of packaging material immediately in accordance with the locally applicable regulations.
•Do not modify the device in any way. Doing so voids the warranty.
•Use the product only for the intended purpose.
TX
RX
TX
RX
GOperating Instructions
3
•Only use the article under moderate climatic conditions.
•Do not use the product in areas in which electronic products are not permitted.
•Do not attempt to service or repair the product yourself. Leave any and all service work to qualied
experts.
•Do not incinerate the battery or the product.
•Do not tamper with or damage/heat/disassemble the batteries/rechargeable batteries.
•Take care that components such as airbags, safety areas, controls, instruments, etc. and visibility
are not blocked or restricted.
•Ensure that the product is securely mounted before every journey.
Warning - rechargeable battery
•Only use suitable charging devices or USB ports to charge the product.
•Do not use defective chargers or USB ports and do not attempt to repair them.
•Do not overcharge the product or allow the battery to completely discharge.
•Avoid storing, charging and using in extreme temperatures and at extremely low atmospheric
pressures (such as at high altitudes).
•When stored over a long period of time, batteries should be charged regularly (at least every
three months).
5. Switching on/off
Press the MFB button (2) for around 3 seconds until the LED (3) lights up blue.
To switch off, press the MFB button (2) for around 3 seconds until the LED (3) ashes red
twice and then goes out.
Note - Automatic product switch-off
The product is equipped with an automatic switch-off mechanism. If there is no connection to your
device within 10 minutes, it switches itself off automatically.
ON
OFF
TX
RX
ON:
OFF:
3s
3s
zZz
STANDBY
10min
4
6. Charging
Fully charge the product once before using it for the rst time.
Connecting the product
Connect the USB charging cable included to the charging socket (5). Connect the free plug
on the micro-USB charging cable to a suitable USB charger. To do this, consult the operating
instructions for the USB charger you are using.
TX
RX
Micro-USB
Charging process
The LED (3) lights up solid red during the charging process. Once the charging process is
complete, the LED (3) goes out.
CHARGING CHARGED
red off
1h:00m
It can take up to 1 hour for the battery to be fully charged.
Battery capacity
When battery levels are low, the LED (3) starts to ash red.
1
2
3
5
7. Bluetooth®pairing
Note - pairing
•Ensure that the Bluetooth®-enabled device is switched on and that the Bluetooth® function
is activated.
•Please refer to the operating instructions of your device for more information.
•When the product is switched on for the rst time, pairing begins automatically.
•The product and the device should not be more than 1 metre apart. The shorter the distance, the
better.
•Switch the product on using the MFB button (2).
•This product has an integrated Bluetooth®function that allows streaming (e.g. from a
•smartphone) to the product. The product also has a further function that enables transmission to
Bluetooth®devices (such as Bluetooth®headphones/speakers).
7.1 RX receive mode
You can pair your devices with the product using Bluetooth®and use it as a playback device. You can
control playback directly on the terminal device. When used as a receiver, up to 8 transmitters can be
stored, the audio signal from which can each be received by a Bluetooth®device.
Connection to the device
To connect to your device, connect it using the 3.5 mm AUX cable and the audio input (4) on
the product.
Select RX mode by pushing the switch (1) to the right.
Press the MFB button (2) twice.
•If the LED (3) is ashing alternately red and blue:
the product is searching for a Bluetooth®connection.
•If the LED (3) lights up blue:
the product is already paired with a Bluetooth®device.
Search using your device for the product (only required on the rst connection)
Open the Bluetooth®settings on your device and wait until the list of found Bluetooth®
devices shows Hama BT-Senrex.
Select Hama BT-Senrex and wait until product is listed as connected in your device's
Bluetooth®settings.
Note - Bluetooth®password
Some devices require a password in order to connect to another Bluetooth®device.
•Enter the password 0000 to connect the headphones if your device prompts you to
enter one.
1
2
2x
6
Bluetooth
Hama BT-Senrex
ON
Password
0000
Multi-point technology
This product can connect to two Bluetooth®-enabled audio devices simultaneously
(multi-point). The product automatically names the two devices A and B and establishes a
connection.
•First connect the rst device to your product.
•Put your product in Bluetooth®pairing mode by pressing the
MFB button (2) twice.
•Then connect the Bluetooth®function on the second device.
•Then connect the second device to your product.
7.2 TX transmitter mode
You can connect this product to other Bluetooth®devices via Bluetooth®and transfer audio content
to them. This means that many speakers and headphones can be used in combination with this
product. When used as a transmitter, up to 4 receivers can be stored and the audio signal can be sent
simultaneously to 2 Bluetooth®devices.
Connection to the device
To connect to your chosen device, connect it using the 3.5 mm AUX cable and the audio input
(4) on the product. Switch on the Bluetooth®device you want to connect to the product.
Please refer to the operating instructions of your device for more information. Connection now
takes place automatically.
Select TX mode by pushing the switch (1) to the left.
Press the MFB button (2) twice.
•If the LED (3) ashes blue:
the product is searching for a Bluetooth®connection.
•If the LED (3) lights up blue:
the product is already paired with a Bluetooth®device.
1
2x
3
7
Note
•If necessary, you may need to carry out a setting on the device in order to allow
automatic connection to the paired product.
Multi-point technology
This product can connect to two Bluetooth®-enabled audio devices simultaneously
(multi-point).
• First connect the rst device to your product.
• Put your product in Bluetooth®pairing mode by pressing
the MFB button (2) twice.
• Put your second audio device in pairing mode and follow
the device's operating instructions.
•Connection now takes place automatically.
7.3 Deleting the pairing list
Switch the product off in its current mode. After around 3 seconds, move the switch (1) to the other
mode and switch the product back on. This will delete all paired devices from the list.
8. Technical data
Bluetooth®version 5.0
Max. transmitter operating time 13h
Max. receiver operating time 12h
Charging time 1h
Prole A2DP, AVRCP
Current consumption 5V 240mA
Battery type Li-polymer / 3.7V
Min. capacity 240mAh
Weight 20g
Size 44 x 44 x 13 mm
2
8
9. Care and maintenance
Only clean this product using a lint-free, slightly damp cloth and do not use any harsh cleaners.
10. Warranty disclaimer
Hama GmbH & Co KG assumes no liability and provides no warranty for damage resulting from
improper installation/mounting, improper use of the product or from failure to observe the operating
instructions and/or safety notes.
11. Service and support
Please contact Hama Product Consulting if you have any questions about this product.
Hotline: +49 9091 502-0 (German/English)
Further support information can be found here: www.hama.com
12. Declaration of conformity
Hama GmbH & Co KG hereby declares that the radio equipment type [00184154] is in
compliance with Directive 2014/53/EU. The full text of the EU declaration of conformity is
available at the following Internet address:
www.hama.com ->00184154-> Downloads.
Frequency band(s) 2402 – 2480MHz
Maximum radio-frequency power transmitted 3.94mW E.I.R.P.
Tabla de contenidos
Idiomas:
Otros manuales de Transceptor de Hama
