Haier XQB50-10A Manual de usuario
Automatic Washing Machine
XQB50-10A
User's manual
This manual is for
Please read this manual
carefully before using.
Retain it for future reference.
Names of the parts.............the 2nd cover
Safety precautions .......................1
Installation and adjustment ..................3
Install the water inlet hose............5
Preparation before washing .............6
Put in the laundries .........................7
Put in the detergent .......................8
Use the operation buttons ................9
Close the top lid ........................13
Finish washing ............................14
Disposal after washing ....................14
Trouble shooting Answer to questions....15
Packing list ..................................16
Specifications................................17
Contents
Using process
Meaning and description of the symbols
Before Using
Before Using
Names of the parts
Warning sign
Forbidden sign
Contents marked with that symbol
are related to the safety of the
product and the personal safety
of the users. Please operate in
strict conformity to the contents,
otherwise it may cause damage
of the machine or injure the
personal safety of the user.
Contents marked with that symbol
are actions forbidden to perform.
Performing of those actions may
result in damage of the machine
or injure the personal safety of
the user.
Accessories
Bottom plate
(one)
water inlet hose
(one)
ST4X16
tapping screws
(eight)
Lint filter
(two)
Adjustable foot
fixed foot (3)
back cover
Cabinet
base frame
Drain hose
Control panel
film
Control panel
Filter cover
Power line
Pulsator
Inner tub
Detergent box
Lint filter
Top lid B
Cabinet handle
water valve
Top lid A Sop mat
(Installed by user)
Drain hose
support
Drain hose
Before Using
Before Using
Safety precautions
Please plug the plug on special 120V AC
receptacle.Please guarantee that the
earthing wire is ear-thed reliably.
The power cord plug should be convenient
to be pluged in or pluged out with hand
while the washing machine runs normally.
Be sure to pull the plug out and close the
water tap when the machine is idle,when
moving the machine,or when cleaning
the machine.Do not use wet hand to ins-
ert or pull out the power plug.
In case the washing machine is installed on ground with
carpet, do not block the ventilation hole with carpet.
Do not let the machine share one receptacle with other electric appliances. If the power plug is damaged, or the
plugging into the receptacle is loose, do not use the plug any more.
Do not wash water-proof laundries like the raincoat,
bike covers etc. to avoid abnormal vibrations in spinning.
Do not use water hotter above 50 C .
Do not put the machine at damp place like
the bathroom. Never wash it with water.
Do Not put wet laundries on the control panel.
soft items
The ventilation holes
at the bottom
Do not bend ,extend,twist,bind by force.Do not press or nip it with weight.
Keep the pin of the power plug clean,if the power plug is polluted with dust,
please wipe with dry cloth carefully.
A tierra
Do not decompose, repair or alter the
machine by yourself.
Do not put any hot or heavy items (such
as the kettle with hot water ) on the
washing machine.
Do not wash laundries with volatile
materials (such as thinner, petrol etc.)
The handicapped or children without
care shall not use the machine.
Keep the machine away from direct
sunlight and heat source like the heater.
Before Using
Before Using
Do not stretch hands into the working
machine. It is dangerous even if the
rotation is slow. Take special care of
the children.Do not let the children
climb the washing machine.
Petrol
Thinner
.
To prevent your laundries and washing
machine from damage,be sure to take
out all of the foreign materials from your
pocket,such as coins,buttons,sand or
hairpins etc.
Before washing,please check if the water
tap is open ,and if the water inlet pipe is
connected properly.
It is suggested to use low-foaming was-
hing powder
To prevent the lint in the tub from blocking
the cascade outlet and influencing the
cascade effect, please keep the lint filter
in good condition, and install it to proper
position during washing.
The largest allowed slope of the
shank base of the machine is 2 .
The slanting or rough ground will
result in unstable running or
stoppage of the machine. Please
adjust it with following methods:
Adjust the adjustable foot:
Adjust the installation position
Before Using
Before Using
Installation and adjustment
Please install and adjust the machine according to the requirement of the manual. It is
very important to your security and correct operating the machine.
1.Press downward to assmble.
2.Pull upward to detach.
1.To twist the adjustable foot, please
first lift up the side of the foot slightly,
loosen the adjustable nut, and twist
the foot.
2.Fasten the nut after adjustment.
Loosen Fasten
High Low
adjustable nut
adjustable foot
Install the bottom plate
After you open the package,
please lean the washing
machine gently down on soft
items ( like the towel cloth,
blanket, etc. ). Install the
bottom plate to the bottom of
the machine with the eight
screws by a cross screwdriver,
then lift the machine up gently.
See to the figure:
Back
Front
Bottom plate
Screw
Soft items
Pull down Put up
Pull down Put up
Install the lint filter
Before Using
Before Using
Usage of the drain hose
The drainage shall be smooth with the drain hose.
1.put the drain hose up to suitable position. Do not put it
on ground
2.Do not step on or press the drain hose.
Notes: the highest point of drain pipe should be higher than
the water level of washing tub for avoiding to siphon
phenomenon during drain.
The highest point
0.8m<H<1.2m
Water absorption cushion
Nut of the water inlet hose
Jointer of the water inlet valve
Install the water inlet hose
1. Insert a new flat washer into each end of the inlet hoses. Firmly put the
washers in the coupling.
2. Connect the water inlet hoses to the water faucet.
Use the new hose sets supplied with the washer.
Any other old hose sets should not be used.
You may have to use pliers to tighten the coupling.
Do not over tighten because you may cause
damage to the valve.
Note:
3. Connect the other ends to their respective cold and hot water inlet valve
located at the rear of the washer
Check the connection between the water inlet
hose and the water tap
1.Swaying the hose gently to confirm if it is fastened
stable.
2.After installation, open the tap to check if it leaks.
3.Do not bend the hose with overstrain.
4.Before each usage please check if the connection
between the water inlet hose and the water tap,
and the connection between the water inlet hose and
washer are firm, so as to prevent dropping from
improve Installation position.
1.Close the water tap.
2. Pull off the water inlet hose from the water tap
and washer
Take down the water inlet hose
Before using
Before using
Install the water inlet hose
4.Fasten the nut. Swing it gently to confirm if it's suitable.
Confirm if
there's special
requirment for
the laundries.
Clear the pocket.
Take out the
coins , sand,
hairpins etc.
Fasten the
buttons and
zippers.
When the pulsator
is running , the
buttons of the
laundries may
cause noise. For
the sake of
discretion,please
put the laundries
with buttons into
other laundries.
The quantity of
the laundries
shall not exceed
the rated value.
The big laundries
like the jeans
shall be put in
loosely.
Using process
Using process
1 Preparation before washing
Pay attention to followings before washing the laundries
A. Check if the laundries are applicable for washing with machine.
b. Divide the laundries that are not colorfast from other laundries.
c. Put those laundries difficult to absorb water into water with hand.
d. For those laundries with heavy soil, please first remove the dirt like mud or dust.
For the parts with heavy soil, please apply detergent on them in advance, which
can make it easier to remove the soil.
e. For those laundries that may get lint ball and those with long fur, turn it over before
putting in.
f. Do not put those laundries polluted by chemicals into the washing machine directly.
Preparation before washing
1. Connect the water inlet hose.
2. Confirm that the washing machine is earthed
reliably. Then insert the power plug into the
receptacle. Do not connect the earth terminal
to the gas pipe and tap water pipe.
3. Hang up the drain hose.
Reference weight of the laundries:
working suit up,down
jeans about 800g
shirt jacket
single bed sheet
Socks
underpants
undershirt
pajamas
blanket
cotton,about 900g
cotton,about
300g
cotton,about
800g
cotton,about 600g
blending,about 50g
cotton,about 70g
cotton,about 180g
The capacity of washing and spinning of the
machine refer to the largest weight of the standard
laundries under dry condition that can be washed
or spinned in one time. One time washing quantity
shall be lower than the rated capacity. The largest
capacity of this machine is 5.0kg.
The thickness, size, type of the cloth will influence
the actual washing capacity. It is suitable for one
time washing to put in reasonable amount of
laundries and the laundries can be turned round in
washing.
Do not select "High" water level for laundries small
than 0.5kg, so as to avoid splashing of water.
Using process
Using process
2 Put in the laundries
cotton,about 1120g
blending coat
(about 800g)
Tabla de contenidos
Otros manuales de Arandela de Haier
Haier
Haier HLT364XXQ - Genesis Washer Manual de usuario
Haier
Haier WM7003A Manual de usuario
Haier
Haier HW70-B1426 Manual de usuario
Haier
Haier HWM85-7288 Manual de usuario
Haier
Haier HWM25-0623S Manual de usuario
Haier
Haier HWM60-Z918 Manual de usuario
Haier
Haier HW80-BD1626 Manual de usuario
Haier
Haier JW-K42B Manual de usuario
Haier
Haier HWM20-0701 Manual de usuario
Haier
Haier HW100-1411N-F Manual de usuario
Haier
Haier HW80-IM12826TNZP Manual de usuario
Haier
Haier WMS402 Manual de usuario
Haier
Haier XPB150-0623S Manual de instrucciones
Haier
Haier HW-CS850TXVE Manual de usuario
Haier
Haier HWD-C1200TXVE ME Manual de usuario
Haier
Haier XPB82-187 Series Manual de usuario
Haier
Haier HWM100-FD10829 Manual de usuario
Haier
Haier A6-707 Manual de usuario
Haier
Haier XQB100-96 Manual de usuario
Haier
Haier HTW130-186S Manual de usuario
