Haier GE CleanSpeak WE04X20528 Guía de configuración

31-16703-2

Part Install Instructions

When replacing the control board, the dryer will not operate

until the replacement control board personality has been set.

GE CleanSpeak™ Dryer Control Board Personality Instructions

Once the control board has been replaced, follow all of the

steps below to properly set the personality. If The control

powers up with all of the user interface (UI) LEDs blinking,

only follow steps 5-8.

Step 1- Begin with the dryer in idle mode (No LED’s or display on).

Step 2- Simultaneously press and hold the Start pad (in some models press Start/Pause pad)

and rotate the cycle select knob 8 clicks clockwise or counter clockwise to enter Field Service

Mode.

Step 3- Upon entering the service mode, the Control will be in test selection mode and

display the test number according the knob position; the default test number is t1.

Rotating the knob counter clockwise will decrease the test number in the display. Rotating the

knob clockwise will increase the test number in the display.

Step 4- Rotate the knob counter clockwise or clockwise until the display shows td, then press

the [Start or Start/Pause] button to initiate the “Set Model” Procedure. All LED’s will begin

blinking.

Continued on reverse side….

!IMPORTANT SAFETY NOTICE

The information in this part instruction is intended for use by

individuals possessing adequate backgrounds of electrical,

electronic and mechanical experience. Any attempt to repair a

major appliance may result in personal injury and property

damage. The manufacturer or seller cannot be responsible for the

interpretation of this information, nor can it assume any liability in

connection with its use.

!WARNING

To avoid personal injury, disconnect power before servicing

this appliance. If electrical power is required for diagnosis or

test purposes, disconnect the power immediately after

performing the necessary checks. RECONNECT ALL

GROUNDING DEVICES If grounding wires, screws, straps,

clips, nuts, or washers used to complete a path to ground are

removed for service, they must be returned to their original

position and properly fastened.

WE04X20528, WE04X20527, WE4M544, WE04X20529,

WE04X25174, WE04X25175

Step 5- Simultaneously press and hold both the “Time” & “Level” buttons for three seconds to

prepare the Seven Segment Display for selecting the model..

Step 6- Press the “Time” button to increase or press the “Level” button to decrease the model

number selection until the correct model number is displayed.

Select 1 for model GTDP740EDWW

Select 2 for model GTDP740GDWW.

Select 3 for model GTDL740EDWW.

Select 4 for model GTDL740GDWW.

Select 5 for models GTDS810EDWS, GTDS815EDMC, GTDS820EDWS, GTDS825EDMC,

GHDS830EDWS and GHDS835EDMC.

Select 6 for models GTDS810GDWS, GTDS815GDMC, GTDS820GDWS, GTDS825GDMC,

GHDS830GDWS and GHDS835GDMC.

Select 7 for models GTDS850EDWS and GTDS855EDMC.

Select 8 for models GTDS850GDWS and GTDS855GDMC.

Select 9 for models GTD81ESPJMC and GTD81ESSJWS.

Select 10 for models GTD81GSPJMC and GTD81GSSJMC.

Select 13 for models GTD86ESPJMC and GTD86ESSJWS.

Select 14 for models GTD86GSPJMC and GTD86GSSJWS.

Step 7- When the proper personality is selected, press-hold [Start or Start/Pause] button for

three seconds to reset the micro. The board will then return to an idle state and will exit the

Service Mode.

Step 8- Test Dryer for proper operation.

Note: If an error is made in selecting the correct model number for the control, repeat steps

1-8.

Este manual sirve para los siguientes modelos

Tabla de contenidos

Otros manuales de Secadora de Haier

Haier

Haier GDZ3.5-1 Manual de usuario

Haier

Haier Ginesis HLF103Q Manual de usuario

Haier

Haier GDZ22-2 Manual de usuario

Haier

Haier I-Pro 5 Series Manual de usuario

Haier

Haier Ginesis HLF103Q Manual de usuario

Haier

Haier HDY60M Manual de usuario

Haier

Haier HLP140E - 2.6 cu. Ft. Portable Vented Electric... Manual de usuario

Haier

Haier HDY-D70-F Manual de usuario

Haier

Haier HDV70E1 Diagrama de cableado

Haier

Haier HD80-01-U Manual de usuario

Haier

Haier HDY60M Manual de usuario

Haier

Haier RDE350AW - 6.5 Cu. Ft. Electric Dryer Manual de usuario

Haier

Haier GDZ13-0677 Manual de usuario

Haier

Haier HLF11PC - 06-04 Manual de usuario

Haier

Haier Genesis CGDE700AW Manual de usuario

Haier

Haier HDY6-1 Manual de usuario

Haier

Haier HLTD500AGW Manual de usuario

Haier

Haier Ginesis HLF103Q Manual de usuario

Haier

Haier GDE560BW Manual de usuario

Haier

Haier HD80-01 WH HA AA Manual de usuario

Haier

Haier HDY-C70 WH HA AA Manual de usuario

Haier

Haier HLF11PC Manual de usuario

Haier

Haier RDE350AW - 6.5 Cu. Ft. Electric Dryer Manual de usuario

Haier

Haier GDZ22-1 Manual de usuario

Manuales populares de Secadora de otras marcas

Bosch

Bosch WTA79200GB Manual de usuario

Amana

Amana W10233410A Manual de usuario

Miele

Miele TWH 780 WP Manual de usuario

Asko

Asko T760 Manual de usuario

Alliance Laundry Systems

Alliance Laundry Systems 25 Series Manual de usuario

Bosch

Bosch Logixx 10 WTB76556GB Hoja de especificaciones

STIEBEL ELTRON

STIEBEL ELTRON Ultronic S Manual de instrucciones

Electrolux

Electrolux EW2H328R2 Manual de usuario

Beko

Beko DS8433RX1M Manual de usuario

Dawlance

Dawlance Spinner DS 6000 C Manual de usuario

Electrolux

Electrolux TP5080TW Manual de usuario

AEG

AEG TR838P4OB Manual de usuario

Indesit

Indesit IDV 75 Manual de usuario

Infiniton

Infiniton SD-DG85C Manual de usuario

BOMANN

BOMANN WT 5019 Manual de usuario

Alliance Laundry Systems

Alliance Laundry Systems TMB795C Manual de usuario

Asko

Asko T793C Manual de usuario

Kenmore

Kenmore 8041 - 5.8 cu. Ft. Capacity Electric Dryer Manual de usuario