Haier V700 Manual de usuario
Technologies Co..,Ltd
Technologies
to as the refevence
Technologies
Do not switch the phone on when Mobile Phone use is prohibited or
when it may cause interference or danger.
Do not place your phone and its accessories in containers with strong
electromagnetic field.
Obey all local laws. Always keep your hands free to operate the vehicle
while driving. Your first consideration while driving should be road safety.
Hospitals or health care facilities may be using equipment that could be
Sensitive to external radio frequency energy. Follow any regulations or
rules in force.
Do not use the phone at a refueling point. Do not use near fuel or
chemicals.
Follow any restrictions. Wireless devices can cause interference in aircraft.
Keep the phone and all its parts, including accessories, out of the reach
of small children.
Use only approved batteries and chargers. Disconnect the charger from
the power source when it is not in use. Do not leave the battery connected
to a charger for more than a week, since overcharging may shorten its lift.
Only qualified personnel should service the phone or install the phone
in a vehicle. Faulty installation or service may be dangerous and may
invalidate any warranty applicable to the device.
Safety Instructions
These instructions are intended for safe and effective use of your phone. Please
follow these guidelines. Failure to do so might cause the product to malfunction or
even a potential hazard to your health.
CONTENTS
About The Phone..................................................................................................1
Quick Operating Guide..........................................................................................6
Message................................................................................................................8
Contacts..............................................................................................................13
Logs.....................................................................................................................16
Settings...............................................................................................................17
Media..................................................................................................................24
Apps....................................................................................................................30
Services..............................................................................................................30
Tools....................................................................................................................32
Bluetooth.............................................................................................................33
Trouble Shooting.................................................................................................35
1
About the Phone
Appearance
Note: the pictures are only for reference, the actual product may vary from the
pictures.
2
Description of theFunctions of Keys
Phonebook list.
Shortcuts.
FM radio.
W
Call Logs.
3
Battery
Remove and install the battery
Dismantle by following procedures:
Remove cover of battery of the mobile phone.
Lift the bottom of battery upward and remove it from battery box.
Warning: power off before removing the battery. When the phone is power on or
connected to external power supply, it is forbidden to remove the battery.
Install by following procedures:
Align the metal contact point of battery with that of battery box, and snap the
battery in the box and press the battery downward until it is installed well.
Charge
Insert the charger on the supply.
Connect the right end of charger to the side port of mobile phone.
After connection, the screen of mobile phone displays Charger Connected ,
and it is charging, the battery icon shows the process of charge; if the phone is
power off, the screen will show the process of charge dynamically.
In low battery state, overusing the mobile phone will cause low voltage, and
the phone enter low voltage lock mode and can't power on normally. Charge the
battery, and the battery enters pre-charge mode process (about ten minutes);
4
after the voltage rises, the phone can be powered on normally.
In the power on state, when the power indicator in the icon area is full and
doesn't flash, the battery is fully charged. In the power off state, the complete
charge will be displayed on the screen if the battery is fully charged.
Insert and Remove the SIM Card
The function of dual card and one in using is provided, two SIM card slots are
available.
Power off, and then move away the external power supply and battery.
Insert SIM card into the box correctly.
Power off before removing the SIM card. Firstly remove the external power supply
And battery, and then remove to take out the SIM card.
Insert and Remove the Memory Card
Power off, and move away the external power supply.
Insert the memory card correctly.
Power off before removing the memory card, and move away the external power
supply, and then remove the card.
Note: Please carry your phone along with you during purchase of
T-Flash card to buy a compatible card. As a wide range of T-Flash cards
are available in the market, In order to ensure your data safety, we advice
5
usage of T-Flash card which is offered by Branded manufacturers, like
Kingston SanDisk and so on.
Power On/Off
Press and hold the ON/OFF key to power on/off.
If the SIM card hasn t been inserted, the screen will display Insert SIM card
please when the user powers on the phone. Insert the SIM card and check if it
is available.
Input the phone lock password: if it is set up.
Input the PIN code: if it is set up.
Greetings: if it is set up and the phone provides this function.
Emergency call (112): means it is registered in other network, only emergency
call (112) is available.
Search: the phone will search automatically until the proper network is linked.
This phone may be inserted with two cards and they may be used by switching,
after registering successfully, the network names are displayedin two rows, the
network name of card 1 is displayed in the first row while that of card 2 is displayed
in the second row. If only one card is inserted into, Insert SIM card will be
displayed in one row.
1.Unlock the Phone/SIM Card
6
phone and SIM card is provided. The default lock code is 0000.
Note: if the user inputs the PIN code of SIM card wrongly for three times, the SIM
card will be locked by network, and the PUK code is required after that.
2.Camping to Network
After the SIM is unlocked, the phone will search available networks automatically
(the process is displayed on the screen). Once the available network is found, the
name of the network provider will be displayed on the middle of the text and picture
area, and the phone is camped to the service network successfully.
Note: Emergency displayed on the screen means the user is out of the
service area, but the user can dial emergency number according to the strength
of signal.
Connect Phone with USB Data Line
Three modes are provided when the phone is connected to computer with USB
data line: Mass Storage , Web Cam and COM prot .
Quick Operating Guide
Make a Call
To keep the user s information safe, the setup of lock code and PIN code for
Este manual sirve para los siguientes modelos
1
Tabla de contenidos
Otros manuales de Teléfono móvil de Haier
Haier
Haier V3 Manual de usuario
Haier
Haier A70 Manual de usuario
Haier
Haier C55 Manual de usuario
Haier
Haier G7s Manual de usuario
Haier
Haier D1200P Manual de usuario
Haier
Haier A7 Manual de usuario
Haier
Haier Z360 Manual de usuario
Haier
Haier HaierPhoneG11 Manual de usuario
Haier
Haier D1100P Manual de usuario
Haier
Haier Smart Phone Manual de usuario
Haier
Haier C5000 Manual de usuario
Haier
Haier X76 Manual de usuario
Haier
Haier C2020 Manual de usuario
Haier
Haier HC-C300 Manual de usuario
Haier
Haier C3010 Manual de usuario
Haier
Haier M560C Manual de usuario
Haier
Haier V5 Manual de usuario
Haier
Haier HG-Z1600 Manual de usuario
Haier
Haier C1000 Manual de usuario
Haier
Haier W860 Manual de usuario
