Hachette ALIEN PACK 7 Manual

spectacular

1:2

scale

ALIEN

BUILD THE

TERRIFYING

XENOMORPH

FROM

ALIEN

EASY

ASSEMBLY

PACK 7

KITS 45 - 52

Non contractual visual

Hachette Partworks Ltd, 4 t h F l o o r, J o r d a n H o u s e ,

47 Brunswick Place, London N1 6EB

www.hachettepartworks.com

All parts belong to a kit. Collectors item for adults.

Not suitable for children under 14.

PACK 7 | BUILD INSTRUCTIONS

ALIEN

KIT 45

THE RIGHT HAND &

THE SKULL (II)

KIT 46

THE RIGHT HAND &

THE SKULL (III)

KIT 47

THE RIGHT ARM (I)

KIT 48

THE RIGHT ARM (II)

KIT 49

THE RIGHT ARM (III)

STEPS & TIPS ONLINE

KIT 50

THE RIGHT ARM (IV)

KIT 51

THE RIGHT ARM (V)

KIT 52

THE LEFT HAND (I)

WARNING: Some parts are assembled using magnets. These magnets can cause serious

injury if they are swallowed. Keep away from children. If you suspect a magnet has been

swallowed, seek medical help straight away.

Some parts may have sharp edges, please handle them with care.

The installation of electronic parts must always be carried out by an adult. When replacing batteries,

use the same type of batteries.

Please ensure that the battery compartment is securely fastened before you use the model.

Used batteries should be recycled.

Please make sure to check with your local council how batteries should be disposed of in your area.

Batteries can present a choking danger to small children and may cause serious harm if ingested.

Do not leave them lying around and keep any spare batteries locked away at all times.

PB 1

ASSEMBLY GUIDE

In this kit you will continue to assemble parts of the right hand and install

a second LED assembly in the Xenomorph’s skull.

KIT 45: THE RIGHT HAND

AND THE SKULL (II)

45-1

45-7 45-8 45-9

45-2

45-5 45-645-445-3

PARTS SUPPLIED

Ref. Name Qty.

45-1 Radius O uter S k in 1

45-2 Righ t-b ack Part of Hand 1

45-3 Righ t Finger R4 1

45-4 Righ t Finger R5 1

45-5 Righ t Finger R6 1

Ref. Name Qty.

45-6 Connector 1

45-7 S k ul l LE D B 1

45-8 M agnets 6

45-9 2.3x6mm screws (1 spare) 4

KIT 45: THE RIGHT HAND AND THE SKULL (II)

45-8

44-8

45-8

44-8

44-1

45-1

45-8

45-1

Glue the six Magnets 45-8

into the circular recesses

inside the Radius Outer

Skin 45-1. It doesn’t matter

which way round (polarity)

they are fitted at this stage.

Next, take the six magnets

44-8 and the radius 44-1

which were supplied with

pack 6 - kit 44. Fit the radius

44-1 into the Outer Skin 45-

1. Place the magnets 44-8

into the circular recesses in

radius 44-1 ensuring that

they are attracted to the

magnets positioned below

on Skin 45-1. When certain

of their orientation, glue the

magnets rmly in place. Put

the assembly aside until it is

needed in the next kit.

KIT 45: THE RIGHT HAND AND THE SKULL (II)

45-4 (R5)

45-2

45-5 (R6)

45-3 (R4)

45-2

Take the Hand 45-2 and

check the t of Right

Finger R5 45-4.Once

certain of a good t, glue

in place.

Repeat the previous step

to add Right Fingers R6

45-5 and R4 45-3. As

before, glue in place.

45-9

44-2

44-6

45-2

6.1 6.2

3-13

3-12

45-7

9V 6LR61

KIT 45: THE RIGHT HAND AND THE SKULL (II)

The two halves of the hand are now joined

together. Take the hand assembly 44-2

from pack 6 - kit 44 and t the connector

44-6 over the raised screw socket on

hand assembly 45-2. (The connector may

need to be temporarily loosened whilst

tting.) Fix in place with a 2.3x6mm screw

45-9 (inset above). Keep the assembly

and the Connector 45-6 supplied aside

until it is needed in the next kit.

Next, the Skull LED B 45-7 is

tested. Lay out the LED strip 45-7,

the circuit board 3-12, the battery

connector 3-13 and the 9V battery,

as shown in the diagram. Connect

the Skull LED B 45-7 to the lower

right hand socket and the battery

connector 3-13 to the left socket.

Then connect the battery to test the

LED strip. Once satised that the

LEDs work, disconnect the parts and

store safely.

KIT 45 IS COMPLETE

45-7

44-7

3-1

FURTHER WORK HAS BEEN DONE TO

THE RIGHT HAND, MAGNETS FITTED

TO THE RADIUS AND THE LED LIGHTS

CONTINUED ALONG THE SKULL.

KIT 45: THE RIGHT HAND AND THE SKULL (II)

Study the diagrams carefully

and note the position of the LED

Strip 45-7 in the centre of the

skull 3-1. The socket at one end

of Skull LED B 45-7 connects

to the plug on skull LED A 44-7

which was fitted in the previous

kit. Once certain of the fit, remove

the backing film from the adhesive

strip and secure the Skull LED B

strip 45-7 in place, as shown.

PB 1

ASSEMBLY GUIDE

In this kit you will continue to work on the right hand and radius, plus install

a third LED within the skull assembly.

KIT 46: THE RIGHT HAND

AND THE SKULL (III)

46-1 46-2

46-3

46-7 46-8 46-9 46-10

46-4 46-5 46-6

PARTS SUPPLIED

Ref. Name Qty.

46-1 Righ t Radius 1

46-2 Pal m of Righ t Hand 1

46-3 W rist J oint 1

46-4 Pipe B 1 1

46-5 Pipe B 2 1

Ref. Name Qty.

46-6 B rack et 1

46-7 Pin 1

46-8 S k ul l LE D C 1

46-9 M agnets 6

46-10 2.3x6mm screws (1 spare) 3

KIT 46: THE RIGHT HAND AND THE SKULL (III)

46-3

44-2

45-2

46-7

46-3

46-7

Insert the Pin 46-7

into the central hole

of the Wrist Joint

46-3.

Take the right hand assembly,

which was worked on in the

last kit and t the Wrist Joint

46-3 into the corresponding

slot in the wrist area. The slot

in the hand 44-2/45-2 will

need to be temporarily opened

slightly for the part to t, and

the ends of the Pin 46-7

should rest in recesses on the

hand parts 44-2 and 45-2.

Manuales populares de Juguete de otras marcas

marklin

marklin 37321 Manual de usuario

Canon

Canon PAPER CRAFT Manual de usuario

GREAT PLANES

GREAT PLANES Pitts M-12S Manual de usuario

NOCH

NOCH 14261 Manual de usuario

Hausler

Hausler 450 SE V2 Manual de usuario

Dynaflite

Dynaflite Daydream Manual de usuario

MiniacRC

MiniacRC MIGHTY MINI P40 WARHAWK Manual

Kenner

Kenner Batman 63651 Manual de usuario

LEGO

LEGO 8527 Manual de usuario

iKarus

iKarus ECO 8 Manual de usuario

Multiplex

Multiplex EasyStar II Manual de instrucciones

Walkera

Walkera 38 Manual de instrucciones

Hasbro

Hasbro TRANSFORMERS BUMBLEBEE Manual de usuario

MD MXION SWD Manual de usuario

Mattel

Mattel Disney Pixar Cars Cozy Cone Spiral Rampway Manual de usuario

marklin

marklin 39671 Manual de usuario

Meccano

Meccano 15103 Manual de usuario

LEGO

LEGO TECHNIC 8735 Manual de usuario