H3C LSWM18QC Manual de usuario
1
H3C LSWM18QC interface card
user manual-6PW104
▌Introduction
Overview
The LSWM18QC interface card provides eight QSFP+ ports.
Figure 1 LSWM18QC interface card front panel
(1) QSFP+ port LED (2) QSFP+ port
QSFP+ ports
You can install the following transceiver modules and cables in the
QSFP+ ports on an LSWM18QC interface card:
•QSFP+ modules in Table 1 and Table 2.
•QSFP+ DAC cables in Table 3.
•QSFP+ to SFP+ DAC cables in Table 4.
•QSFP+ fiber cables in Table 5.
Table 1 QSFP+ transceiver modules available for the QSFP+
ports (1)
QSFP+ transceiver module Central wavelength
(nm) Connector
QSFP-40G-SR4-MM850 850 MPO
QSFP-40G-CSR4-MM850 850 MPO
2
QSFP+ transceiver module Central wavelength
(nm) Connector
QSFP-40G-LR4-WDM1300
Four lanes:
•1271
•1291
•1311
•1331
LC
QSFP-40G-LR4L-WDM1300
Four lanes:
•1271
•1291
•1311
•1331
LC
Table 2 QSFP+ transceiver modules available for the QSFP+
ports (2)
QSFP+
transceiver
module
Cable/fiber
diameter
(µm)
Modal
bandwidth
(MHz × km)
Max
transmission
distance
QSFP-40G-SR4
-MM850
Multi-mode,
50/125
2000 100 m (328.08 ft)
4700 150 m (492.12 ft)
QSFP-40G-CSR
4-MM850
Multi-mode,
50/125
2000 300 m (984.25 ft)
4700 400 m (1312.33
ft)
QSFP-40G-LR4
-WDM1300
Single-mode,
9/125 N/A 10 km (6.21
miles)
QSFP-40G-LR4
L-WDM1300
Single-mode,
9/125 N/A 2 km (1.24 miles)
3
Table 3 QSFP+ DAC cables available for the QSFP+ ports
QSFP+ DAC cable Cable length Data rate
LSWM1QSTK0 1 m (3.28 ft)
40 Gbps
LSWM1QSTK1 3 m (9.84 ft)
LSWM1QSTK2 5 m (16.40 ft)
Table 4 QSFP+ to SFP+ DAC cables available for the QSFP+
ports
QSFP+ to SFP+ DAC cable Cable length Data rate
LSWM1QSTK3 1 m (3.28 ft)
40 Gbps
LSWM1QSTK4 3 m (9.84 ft)
LSWM1QSTK5 5 m (16.40 ft)
Table 5 QSFP+ fiber cables available for the QSFP+ ports
QSFP+ fiber cable Cable length Data rate
QSFP-40G-D-AOC-7M 7 m (22.97 ft)
40 Gbps
QSFP-40G-D-AOC-10M 10 m (32.81 ft)
QSFP-40G-D-AOC-20M 20 m (65.62 ft)
IMPORTANT:
When an LSWM18QC interface card is installed on an S6800-4C
switch, its QSFP+ ports do not support QSFP+ to SFP+ port
splitting.
4
NOTE:
•As a best practice, use H3C transceiver modules and cables
for the interface card.
•The transceiver module and cable types supported by an
interface card vary by device model. For more information, see
the installation guide or contact H3C Support or marketing staff.
For more information about H3C transceiver modules and cables, see
H3C Transceiver Modules User Guide at www.h3c.com
LEDs
Table 6 describes QSFP+ port LEDs on the front panel.
Table 6 QSFP+ port LED description
LED status Description
Steady green
A transceiver module is installed in the port. The
port is operating at 40 Gbps, and a link is present
on the port.
Flashing green The port is sending or receiving data at 40 Gbps.
Steady yellow
A transceiver module is installed in the port. The
port is operating at 10 Gbps, and a link is present
on the port.
Flashing
yellow The port is sending or receiving data at 10 Gbps.
Off No transceiver module is installed in the port, or no
link is present on the port.
NOTE:
For an LSWM18QC interface card installed on a service module o
f
an S12500X-AF switch, its port LEDs are in green when the ports
are operating correctly and they do not indicate the port speed.
5
▌Installing and removing an interface card
CAUTION:
•Before you install or remove an interface card, wear an ESD
wrist strap and make sure the strap makes good skin contact
and is reliably grounded.
•To avoid device damage, do not use excessive force when
you install or remove an interface card.
•The LSWM18QC interface card is hot swappable. However,
do not install or remove it during the startup of the switch.
Installing an interface card
Before you install an interface card, remove the filler panel (if any)
from the target slot. Keep the removed filler panel secure for future
use.
To install an interface card:
1. Unpack the interface card.
Figure 2 LSWM18QC interface card
(1) Ejector lever (2) Latch
2. Press the latch on the interface card to release the ejector lever.
3. As shown by callout 1 in Figure 3, insert the interface card slowly
into the slot along the guide rails.
4. Rotate inward the ejector lever as shown by callout 2 in Figure 3
until the latch locks the ejector lever in place.
6
Figure 3 Installing an LSWM18QC interface card
Removing an interface card
CAUTION:
•Before you remove an interface card, remove the cable from
it to avoid cable damage.
•After removing an interface card, if no new interface card is
to be installed, install the filler panel as soon as possible to
prevent dust and ensure good ventilation in the device.
To remove an interface card:
1. Prepare an anti-static bag.
2. Press the latch to release the ejector lever
3. Rotate outward the ejector lever as shown by callout 1 in Figure 4.
4. Pull out the interface card slowly out of the interface card slot, as
shown by callout 2 in Figure 4.
5. Place the removed interface card in the anti-static bag.
Figure 4 Removing an LSWM18QC interface card
7
Installing and removing QSFP+ transceiver modules
and cables
For information about installing and removing QSFP+ transceiver
modules and cables, see H3C Transceiver Modules and Network
Cables Installation Guide at www.h3c.com.
Verifying the installation
After the installation is complete, identify whether the interface card is
operating correctly.
If the interface card fails to operate correctly, perform the following
steps:
1. Reinstall it following the installation procedures described in this
document.
2. If the problem persists, contact H3C Support.
▌Technical support
New H3C Technologies Co., Ltd. provides customers with
comprehensive technical support and service. If you purchase the
products from the sales agent of New H3C Technologies Co., Ltd.,
please contact our sales agent or technical personnel.
Website: http://www.h3c.com
BOM: 3101A0HH
Tabla de contenidos
Otros manuales de Equipo de grabación de H3C
H3C
H3C LSQM1QGS8A0 Manual de usuario
H3C
H3C LSWM2ZQP2P Manual de usuario
H3C
H3C LSWM2ZSP8P Manual de usuario
H3C
H3C LSW1XGT4P0 Manual de usuario
H3C
H3C LSWM18CQMSEC Manual de usuario
H3C
H3C LSPM4G4T6P Manual de usuario
H3C
H3C LSWM116FC Manual de usuario
H3C
H3C LSPM2SP2P Manual de usuario
H3C
H3C S12500 Series Manual de usuario
H3C
H3C LSWM4SP8PM Manual de usuario
Manuales populares de Equipo de grabación de otras marcas
Strymon
Strymon NIGHTSKY Manual de usuario
Mitsubishi Electric
Mitsubishi Electric 16CH DIGITAL RECORDER DX-TL5000U Manual de usuario
Tews Technologies
Tews Technologies TPMC465 Manual de usuario
Honeywell
Honeywell Excel 50 Manual de usuario
SeaLevel
SeaLevel COMM+8.LPCI Manual de usuario
Arturia
Arturia AUDIOFUSE STUDIO Manual de usuario
