H.Koenig V26 Manual de usuario
Steam ironing
Centrale vapeur
Dampfbügelstation
Stoominstallatie
Central vapor
Centrale Vapore
v26
ENGLISH
Description
1) Heating plate
2) "Iron heating" indicator light
3) Steam request button
4) Thermostat knob
5) Single hase (supply cable + steam hase)
6) On/off indicator light for switch
7) Switch button
8) Steam indicator light
9) Supply cable with plug
10) Storage box for supply cable
11) The cleaning valve of the boiler
12) Storage slot for single hase
13) Boiler
14) Water tank
Safety warnings
Read the following instructions
carefully:
Before use, check that the power supply
corresponds to the voltage shown on the
serial number plate. Connec! the
appliance only to a properly earthed
power outlet (minimum 1OA).
ln the event of incompatibility between
the plug and you socket, have the socket
replaced by a qualified electrician.
The electrical safety of this appliance is
only guaranteed when il is properly
earthed according to current electrical
safety regulations. The manufacturer
declines all responsibility for any damage
resulting from inadequate earthing of the
appliance. If in doubt, consul! a qualified
electrician.
Do not leave water in the machine when
the room temperature is 0°Cor below.
After unpacking , check the appliance for
damage if in doubt, do not use the
appliance; contact a qualified technician.
Packaging materials (plastic bags,
polystyrene foam, etc.) are a potential
source of danger and must be kept out
of reach of children.
Il is inadvisable to use adapters, multiple
sockets and/or extensions. ln cases in
which this is unavoidable, always use
adapters, multiple sockets and
extensions which comply with current
safety regulations. Do not exceed the
maximum power rating shown on the
adapter.
This appliance is designed for domestic
use only. Any other use of the appliance
is considered improper and therefore
dangerous.
The manufacturer declines all
responsibility for any damage resulting
from improper, incorrect or careless use
of the appliance .
The filling aperture must not be opened
during use.
Don't allow children in the front of the
iron when press "Jet button",its 's shot
range is far. Fasten lace is for lashing
the steam tube and power cable .
Il is easy for you to put the long steam
tube and cable on the tube clip, il is easy
for operating.
This device is not intended for use by
persons with reduced capacity on the
physical, mental or sensory or lack of
experience and knowledge (including
children), unless he has them was asked
to monitor or if they have had instructions
on the use of the appliance by a person
responsible for their safety. Children
should be supervised to ensure they do
not play with the device.
If the power cord is damaged, il must be
replaced with an after-sales service to
avoid any danger.
ln particular:
Do not touch the appliance with wet or
damp hands or feet. Do not use the
appliance in bathrooms.
Do not pull the supply cable or the
appliance to remove the plug form the
socket. Do not leave the appliance
exposed to atmospheric agents (rain,
sun, frost, etc.).
Do not allow the appliance to be used by
children or irresponsible persons unless
under supervision.
Do not immerse the appliance in water.
Do not leave the iron unattended when il
is switched on, as this may be a source of
danger.
Before carrying out any cleaning or
maintenance operations or filling water
into container, always disconnect the
appliance from the mains power supply
by removing the plug .
ln the event of failure or malfunction,
switch off the appliance and do not
attempt to carry out repairs. Contact an
authorized Service Centre and insist on
original spare parts. Failure to observe
the above points may affect the safety of
the appliance.
Should you decide not to use the
appliance again, remove the plug from
the socket and eut the supply cable to
render the appliance completely
inaperative.
Installation must be carried out
according to the manufacture's
instructions.
The supply cable must not be replaced by
the user, as this requires the use of
special tools, if the supply cable is
damaged, contact an authorized Service
Centre.
Do not fill the appliance under a running
tap.
Do not allow the supply cable to corne
into contact with the ironing plate.
If the safety eut-out intervenes , the iron
will no longer function. To restore normal
operation. Contac a qualified electrician.
Never direct the steam jet in the direction
of persans, as this may be extremely
dangerous. Do not use the iron on very
wet fabrics.
Do not place the iron on the stand when
the plate is hot.
Do not overfill the boiler and do not add
stain-removers of simllar products to
water.
Remove the plug from the mains socket
when the appliance is not in use. Do not
leave the appliance switched on
unnecessarily.
Never unscrew the safety valve when the
appliance is connected to the power
supply network. Use a funnel to fill the
boiler without causing the water to
overflow.
The boiler must be placed on a fiat
surface that is particularly resistant to
high temperatures.
INSTRUCTIONS
FOR USE
Check the manufacturer's label on the garmen,t and interpret
the symbol on label as follows:
STEAM IRONING
The appliance uses ordinary tap water.
If the water is very hard (hardness higher than27 degrees French).we
suggest using distilled or demineralized water.
When using the iron for the first lime , iron a plain cloth first.
Before using the appliance, taken down the water tank (14) and fill it,
not exceeding MAX waterline.
When you want to take back the water tank(14),firstly put the water
tank base and then push the water tank softly, after hear "click", it
means the water tank in the place.
Connecting the appliance and power cord.
Press the switch button (7), power indicator light (6) and steam
available indicator light (8) bright, il means the boiler and iron start
running.
Feed-water from electromagnetism water pump coming down the
boiler when the boiler (13) heating enough.
Choosing the temperature by temperature knob (4), the steam device
indicate ironing area which can be chose (Fig.3).
Around 2 minutes, heating indicator (2) will die out, il means the
appliance can be using the steam.
Around 3 minutes, steam available light (8) will die out, it means the
appliance can be using the steam.
Obtain steam after pressing the steam button (3). Release the button
( 3) and the steam flow stops.
This appliance is also able to generate steam in a vertical position
and can therefore be used to refresh fabrics easily with a jet of steam.
When you ending the ironing, press the switch button (7), eut down
Steam ironing allowed
For dry ironing, set temperature adjustment knob ( 4) on ...
Steam ironing allowed
For dry ironing, set temperature adjustment knob (4) on ...
Dry ironing
Check the fabric's resistance to steam ironing or dry iron with
temperature adjustment knob (4) set on...
Do not iron
Steam ironing or treatment not allowed
the power, press the steam button (3) to release the residual steam
in the boiler (13)
NOTE: Continue to release steam for long time, when pump adds
water into boiler, soleplate will stop to release steam for short time,
almost 10secs.
DRYIRONING
Connec! the appliance to the mains supply, press the switch
button(7), then select the desired temperature by turning the
thermostat knob(4).Wait until the iron heating indicator light (2) goes
off, indicating that the desired temperature has been reached.
For dry ironing it is not necessary to press the steam button (3).
FILLING THE TANK
Thanks to the self-filling function, there is no longer any need to stop
and wait while the boiler fills up again.
When the water in the boiler is at minimum level, the pump is
automatically activated which fills the boiler once again.
If you hear the loud feed-water sound when you ironing, it means
there is no water in the water tank (14).Press the switch button (7)
and eut down the power. After fill the water tank (14), then press the
switch button (7) again, go on ironing.
To keep on working, simply restore the water level in the self--refilling
tank as described in the "Preparation for use" paragraph.
PUTTNG THE APPLIANCE AWAY
First ensure that the appliance has cooled down completely. Empty
the water tank ( 14) .
lt is not necessary to drain the boiler after ironing.
Steam line (5) and power cord (9) could be receipt into the wire
groove (12) and line box (10).
LOCKING IRON
To Iock the iron it must be set on the rear part of the rest mat (Fig11).
NOTE: make sure to firmly hook the iron to prevent it falling
accidentally.
Otros manuales para V26
1
Tabla de contenidos
Idiomas:
Otros manuales de Hierro de H.Koenig
H.Koenig
H.Koenig V26 Manual de usuario
H.Koenig
H.Koenig V24 Manual de usuario
H.Koenig
H.Koenig V5i Manual de usuario
H.Koenig
H.Koenig V5i Manual de usuario
H.Koenig
H.Koenig OptiV8 Manual de usuario
H.Koenig
H.Koenig V24 Manual de usuario
H.Koenig
H.Koenig V26 Manual de usuario
H.Koenig
H.Koenig V34 Manual de usuario
H.Koenig
H.Koenig V5i Manual de usuario
H.Koenig
H.Koenig V24 Manual de usuario
