GW Instek PFR-100MGP Manual de usuario

Multi-Range DC Power Supply

PFR-100 Series

USER MANUAL

ISO-9001 CERTIFIED MANUFACTURER

This manual contains proprietary information, which is protected by

photocopied, reproduced or translated to another language without

prior written consent of Good Will company.

The information in this manual was correct at the time of printing.

However, Good Will continues to improve products and reserves the

rights to change specification, equipment, and maintenance

procedures at any time without notice.

Good Will Instrument Co., Ltd.

No. 7-1, Jhongsing Rd., Tucheng Dist., New Taipei City 236, Taiwan.

TABLE OF CONTENTS

Table of Contents

SAFETY INSTRUCTIONS ...................................................5

GETTING STARTED...........................................................9

PFR-100 Series Overview...................... 10

Appearance .......................................... 13

Theory of Operation ............................. 20

OPERATION ................................................................... 32

Set Up.................................................. 33

Basic Operation ................................... 44

Test Scripts .......................................... 58

CONFIGURATION...........................................................66

Configuration Overview ....................... 67

ANALOG CONTROL ........................................................ 83

Analog Remote Control Overview......... 84

Remote Monitoring ............................ 102

COMMUNICATION INTERFACE .................................... 107

Interface Configuration ...................... 108

FAQ.............................................................................. 134

APPENDIX .................................................................... 136

PFR-100 Factory Default Settings ....... 136

Error Messages & Messages .............. 138

LED ASCII Table Character Set ........... 139

PFR-100 Specifications....................... 140

PFR-100 Dimensions.......................... 146

Declaration of Conformity .................. 147

PSU Series User Manual

INDEX .......................................................................... 148

SAFETY INSTRUCTIONS

This chapter contains important safety

instructions that you must follow during

operation and storage. Read the following before

any operation to insure your safety and to keep

the instrument in the best possible condition.

Safety Symbols

These safety symbols may appear in this manual or on the

instrument.

WARNING

Warning: Identifies conditions or practices that

could result in injury or loss of life.

CAUTION

Caution: Identifies conditions or practices that

could result in damage to the PFR-100 or to other

properties.

DANGER High Voltage

Attention Refer to the Manual

Protective Conductor Terminal

Earth (ground) Terminal

PFR-100 Series User Manual

Do not dispose electronic equipment as unsorted

municipal waste. Please use a separate collection

facility or contact the supplier from which this

instrument was purchased.

Safety Guidelines

General

Guideline

CAUTION

Do not place any heavy object on the PFR-100.

Avoid severe impact or rough handling that

leads to damaging the PFR-100.

Do not discharge static electricity to the PFR-

100.

Use only mating connectors, not bare wires, for

the terminals.

Do not disassemble the PFR-100 unless you are

qualified.

Power Supply

WARNING

AC Input Voltage: 100Vac-240Vac

Frequency: 47Hz to 63Hz

To avoid electrical shock connect the protective

grounding conductor of the AC power cord to

an earth ground.

Cleaning the PFR-

100

Disconnect the power cord before cleaning.

Use a soft cloth dampened in a solution of mild

detergent and water. Do not spray any liquid.

Do not use chemicals containing harsh material

such as benzene, toluene, xylene, and acetone.

Operation

Environment

Location: Indoor, no direct sunlight, dust free,

almost non-conductive pollution (Note below)

Relative Humidity: 20%~ 80% (no condensation)

Altitude: < 2000m

Temperature: 0°C to 40°C

SAFETY INSTRUCTIONS

(Pollution Degree) EN61010-1:2010 specifies the pollution degrees

and their requirements as follows. The PFR-100 falls under degree 2.

Pollution refers to “addition of foreign matter, solid, liquid, or

gaseous (ionized gases), that may produce a reduction of dielectric

strength or surface resistivity”.

Pollution degree 1: No pollution or only dry, non-conductive

pollution occurs. The pollution has no influence.

Pollution degree 2: Normally only non-conductive pollution

occurs. Occasionally, however, a temporary conductivity caused

by condensation must be expected.

Pollution degree 3: Conductive pollution occurs, or dry, non-

conductive pollution occurs which becomes conductive due to

condensation which is expected. In such conditions, equipment

is normally protected against exposure to direct sunlight,

precipitation, and full wind pressure, but neither temperature

nor humidity is controlled.

Storage

environment

Location: Indoor

Temperature: -20°C to 70°C

Relative Humidity: 20 to 85%(no condensation)

Disposal

Do not dispose this instrument as unsorted

municipal waste. Please use a separate collection

facility or contact the supplier from which this

instrument was purchased. Please make sure

discarded electrical waste is properly recycled to

reduce environmental impact.

PFR-100 Series User Manual

Power cord for the United Kingdom

When using the power supply in the United Kingdom, make sure

the power cord meets the following safety instructions.

NOTE: This lead/appliance must only be wired by competent persons

WARNING: THIS APPLIANCE MUST BE EARTHED

IMPORTANT: The wires in this lead are coloured in accordance with the

following code:

Green/ Yellow:

Earth

Blue:

Neutral

Brown:

Live (Phase)

As the colours of the wires in main leads may not correspond with

the coloured marking identified in your plug/appliance, proceed

as follows:

The wire which is coloured Green & Yellow must be connected to

the Earth terminal marked with either the letter E, the earth symbol

or coloured Green/Green & Yellow.

The wire which is coloured Blue must be connected to the terminal

which is marked with the letter N or coloured Blue or Black.

The wire which is coloured Brown must be connected to the

terminal marked with the letter L or P or coloured Brown or Red.

If in doubt, consult the instructions provided with the equipment

or contact the supplier.

This cable/appliance should be protected by a suitably rated and

approved HBC mains fuse: refer to the rating information on the

equipment and/or user instructions for details. As a guide, a cable

of 0.75mm2should be protected by a 3A or 5A fuse. Larger

conductors would normally require 13A types, depending on the

connection method used.

Any exposed wiring from a cable, plug or connection that is

engaged in a live socket is extremely hazardous. If a cable or plug is

deemed hazardous, turn off the mains power and remove the cable,

any fuses and fuse assemblies. All hazardous wiring must be

immediately destroyed and replaced in accordance to the above

standard.

GETTING STARTED

This chapter describes the power supply in a

nutshell, including its main features and front /

rear panel introduction. After going through the

overview, please read the theory of operation to

become familiar with the operating modes,

protection modes and other safety considerations.

PFR-100 Series Overview ......................................... 10

Series lineup ................................................................................... 10

Main Features................................................................................. 10

Accessories..................................................................................... 11

Appearance.............................................................. 13

Front Panel..................................................................................... 13

Display Area................................................................................... 16

Rear Panel....................................................................................... 18

Theory of Operation ................................................ 20

Operating Area Description ........................................................ 20

CC and CV Mode.......................................................................... 22

Slew Rate ........................................................................................ 23

Bleeder Control ............................................................................. 24

Sink Current Table ........................................................................ 25

Alarms............................................................................................. 26

Considerations ............................................................................... 27

Grounding...................................................................................... 30

PFR-100 Series User Manual

PFR-100 Series Overview

Series lineup

The PFR-100 series consists of 2 models, covering a number of

different current, voltage and power capacities:

Model name

Operation Voltage

Operation Current

Rated Power

PFR-100L

0-50V

0-10A

100W

PFR-100M

0-250V

0-2A

100W

Main Features

Performance

Variable voltage and current combinations with

5 times of coverage ratio of its range within the

rated power.

Constant voltage/constant current with

automatic crossover.

Active Power Factor correction.

Universal Input Voltage 85 - 265Vac, continuous

operation.

Natural convection cooling.

Features

Preset memory function.

Output ON/OFF delay function.

CV, CC priority start function. (prevents

overshoot with output ON)

Adjustable voltage and current slew rates.

Bleeder circuit ON/OFF setting. (to prevent

over-discharging of batteries)

OVP, OCP, AC FAIL, OPP and OTP protection.

Supports test scripts.

Este manual sirve para los siguientes modelos

Tabla de contenidos

Otros manuales de Fuente de alimentación de GW Instek

GW Instek

GW Instek PSP-603 Manual de usuario

GW Instek

GW Instek PSM-2010 Manual de usuario

GW Instek

GW Instek PEL-3000 Series Manual de usuario

GW Instek

GW Instek GPS-2303 Manual de usuario

GW Instek

GW Instek SPS-1230 Manual de usuario

GW Instek

GW Instek PSW-Multi Series Manual de usuario

GW Instek

GW Instek GPE-1326 Series Manual de usuario

GW Instek

GW Instek ASD Series Manual de usuario

GW Instek

GW Instek GPP-2323 Manual de usuario

GW Instek

GW Instek GPD-3303 Series Manual de usuario

GW Instek

GW Instek GPS-1830 Manual de usuario

GW Instek

GW Instek GCP-206P Manual de usuario

GW Instek

GW Instek PFR Series Guía

GW Instek

GW Instek PRP Series Manual del propietario

GW Instek

GW Instek GPD-303S Series Manual de usuario

GW Instek

GW Instek PSP-603 Manual de usuario

GW Instek

GW Instek GPS-2303 Manual de usuario

GW Instek

GW Instek PSU Series Manual del propietario

GW Instek

GW Instek PPH-1503D Manual de usuario

GW Instek

GW Instek PSB-2000 series Manual de usuario

GW Instek

GW Instek SPS Series Manual de usuario

GW Instek

GW Instek PSW Series Manual de usuario

GW Instek

GW Instek PSU Series Manual de usuario

GW Instek

GW Instek SPD-3606 Manual de usuario

Manuales populares de Fuente de alimentación de otras marcas

Monacor

Monacor PS-12CCD Manual de usuario

VOLTIMA

VOLTIMA MagicBox 15 Manual de usuario

Agilent Technologies

Agilent Technologies 6032A Manual de usuario

Miller

Miller Auto Deltaweld 452 Manual de usuario

BCP

BCP PUOUBK Hoja de instrucciones

HC 2210 Manual de usuario

Puls

Puls CT5.241 Manual de usuario

OCZ

OCZ ZX1250W Manual de usuario

iseg

iseg ECH 238 Manual de usuario

Power

Power XXL A Series Manual de usuario

Agilent Technologies

Agilent Technologies 6631B Manual de usuario

Renogy

Renogy PHOENIX 300 Manual de usuario

HP 6200B Manual de servicio

Epson

Epson Stylus Scan 2500 Manual de funcionamiento

Pulsar

Pulsar GREEN POWER CCTV PoE POE044816 Manual de usuario

Puls

Puls MiniLine ML50.100 Manual de usuario

Puls

Puls AS-Interface SLA4.100 Manual de usuario

Kenwood

Kenwood PS-60 Manual de usuario