GSS SDA 521 Manual de usuario
Assembly Instruction
SDA 521
SDA 921
SDA 1321
SDA 1721
- 2 - SDA 521 … SDA 1721
1 Important InformatIon o n the safety and assembly
• Assembly and servicing should be carried out by electricians.
• Check the system for short circuits in the coaxial cables before starting up.
• Only install the system when it is not connected to the mains supply.
• Mount the unit…
- on a non-flammable background (wall),
- in a dust-free, dry environment,
-
in such a manner that it is protected from moisture, fumes, splashing water
and dampness,
- somewhere protected from direct sunlight,
- not within the immediate vicinity of heat sources,
• Earth the unit via the equipotential bonding connector (screws ).
• Make sure the input levels of the SAT stages are as equal as possible.
• Beware of short circuits!
• No liability is accepted for any damage caused by faulty connections or
inappropriate handling.
• Observe the relevant standards, regulations and guidelines on the installa-
tion and operation of antenna systems.
• The standards IEC/EN/DIN EN 61319-1, IEC/EN/DIN EN EN 62368-1
and IEC/EN/DIN EN 60728-11 must be observed.
2 technIcal descrIptIon
a p p l I c a t I o n
Using the amplifier range SDA x21 in conjunction with Multi Switches SDC it
is possible to realize satellite systems for more than 1000 users.
The multi amplifiers have 4/8/12/16 SAT-IF lines (+20 dB) as well as one
terrestrial line (+25 dB; 0…-15dB terrestrial slope correction).
In addition each line is equipped with a 20 dB gain control (attenuation).
po w e r s u p p ly
The power supply is done via the DC power connector by the included exter-
nal power supply unit (SDP
1820
, +18V ).
- 3 - SDA 521 … SDA 1721
3 connectIons and controls
Connection layout for e.g. SDA 521:
terrestrial inputSAT inputs
attenuation controls
SAT outputs terrestrial output
terrestrial slope
DC input 18V
– Potential equalisation (PE) :
Equalise the potential (PE) in accordance with IEC/EN/DIN EN 60728-11.
Connect the PE connection terminal to a PE rail (supplied by customer)
using the PE wire (Cu 4 mm2 - 9 mm2).
– DC input: Via the DC input a 18V ( ) voltage is fed in.
– Attenuation controls: Via these controllers the output level of each line can
be adjusted (attenuation of 0…20dB).
– Terrestrial slope correction: Via this controller the slope of the spectrum of
the terrestrial line can be adjusted (attenuation of 0…15dB).
4 specIfIcatIons
SDA 521 SDA 921 SDA 1321 SDA 1721
Number of inputs 4 x SAT 8 x SAT 12 x SAT 16 x SAT
1 x TERR
Number of outputs 5 9 13 17
Frequency range SAT 950 - 2150 MHz
TERR 47 - 862 MHz
Gain SAT 20 dB
TERR 25 dB
Attenuation SAT 0 - 20 dB
TERR 0 - 20 dB
Slope adjustment TERR 0 - 15 dB
Isolation
TERR/SAT 30 dB
SAT/TERR 15 dB
out – out SAT 30 dB
Return loss
SAT inputs 10 dB
SAT outputs 10 dB
TERR input 10 dB
TERR output 10 dB
Output level SAT (IMD3-35 dB) 110 dBµV
TER (IMD3-60 dB) 105 dBµV
Impedance 75 Ω
Dimensions (mm) 174x125x50 262x125x50 350x125x50 438x125x50
Weight (g) 1000 1100 1300
Order no. G.BB… 10-05 10-09 10-13 10-17
GSS Grundig Systems GmbH • Beuthener Straße 43 • D-90471 Nuremberg
Phone: +49 (0) 911 / 633 240 0 • Fax: +49 (0) 911 / 633 240 98
www.gss.de/en • info@gss.de
Service: Phone: +49 (0) 911 / 633 240 90; [email protected]
Alterations reserved. Technical data E. & O.E. © by GSS Grundig Systems GmbH 002/2020
Este manual sirve para los siguientes modelos
3
Otros manuales de Convertidor de medios de GSS
GSS
GSS PCIM 1000 Manual de usuario
GSS
GSS PHDQ 8008 TSR Manual de usuario
GSS
GSS PHIS 1000 S Manual de usuario
GSS
GSS STC 100 Manual de usuario
GSS
GSS HMPT 1000 T Manual de usuario
GSS
GSS HDMC 1000 SPTS Manual de usuario
GSS
GSS PAIS 5100 Manual de usuario
GSS
GSS GSS.mux SMCIP 401 Manual de usuario
GSS
GSS PTIM 1000 Manual de usuario
GSS
GSS Compact Classic STC 4-16 IPS CI Manual de usuario
GSS
GSS PEDQ 3005 QMX Manual de usuario
GSS
GSS PTIS 1000 Manual de usuario
GSS
GSS PMDQ 1000 Manual de usuario
GSS
GSS HDE 166 Manual de usuario
GSS
GSS Professional PADE 7006 Manual de usuario
GSS
GSS PTDQ 1000 ASI LAN Manual de usuario
GSS
GSS HDM 400 P CI Manual de usuario
GSS
GSS PHDQ 8008 TSR Manual de usuario
GSS
GSS STI 1916 CT Manual de usuario
GSS
GSS SOQ 100 Manual de usuario
