GSM Bellini BBF145BI Instrucciones de instalación
GSM Retail Australia Pty Ltd ABN: 53 007 582 475
For Technical queries: 1300 373 199 Aust OR 0800 764 912 NZ
Model: Beverage Cooler - BBF145BI / BBF145BI-F
INSTALLATION & OPERATION
INSTRUCTIONS
Compressor Beverage Cooler
Model No. BBF145BI
Model No. BBF145BI-F
FINELINE: 133507
V3 July20
Thank you
for purchasing
Bellini Beverage Cooler, the appliance
carries a 2year replacement warranty, be
sure to retain this Instruction Manual and
receipt.
For Technical, queries please contact
Aust: 1300 373 199
NZ: 0800 764 912
GSM Retail Australia Pty Ltd ABN: 53 007 582 475
For Technical queries: 1300 373 199 Aust OR 0800 764 912 NZ
Model: Beverage Cooler - BBF145BI / BBF145BI-F
Content
Safety instructions & warnings………………………………..…………………………….1-2
Description of the appliance………………………………..………………………………..3
Installation & operation………………………………..……………………………………….5-6
Troubleshooting………………………………..…………………………………………………..7
Maintenance and cleaning………………………………..…………………………………..8
Technical parameters………………………………..…………………………………………..9
GSM Retail Australia Pty Ltd ABN: 53 007 582 475
For Technical queries: 1300 373 199 Aust OR 0800 764 912 NZ
Model: Beverage Cooler - BBF145BI / BBF145BI-F
1
Safety instructions & warnings
Your safety is of the utmost importance to our company. Please make sure that
you read this instruction booklet before attempting to install or use this
appliance. If you are unsure of any of the information contained in this booklet,
please contact the Technical Department.
●This appliance is not intended for use
by person(including children) with
reduced physical,sensory or mental
capabilities or lack of experience and
knowledge,unless they have been
given supervision or instruction
concerning use of the appliance by a
person responsible for their safety.
●Children should be supervised to
ensure that they do not play with the
appliance.
●This appliance is intended for
HOUSEHOLD USE ONLY and not for
commercial or industrial use.
●Keep ventilation openings, in the
appliance enclosure or in the built-in
structure, clear of obstruction.
●Do not use mechanical devices or other
means to accelerate the defrosting
process, other than those
recommended by the manufacturer.
●Do not damage the refrigerant circuit.
●Do not use electrical appliances inside
the storage compartments of the
appliance, unless they are of the type
recommended by the manufacturer.
●Make sure that the appliance is
connected to power supply in
accordance with the rating label.
●Connect appliance directly to Domestic
earthed 10A power outlet , do not plug
in to extension cords , double adapters
or power boards .
●Do not modify the cord and plug set
fitted to the appliance .
●Ensure plug is fully inserted into the
Domestic Power Outlet
●Plug should be within reach for easy
disconnection after the appliance
positioned in case of accidents
occurred.
●Do not store or burn gasoline or other
inflammables near the appliance in
case of possible fire.
●Do not store inflammables, explosives,
acid & alkaline liquids etc.in the
compartment of the appliance
Child Safety
●Do not allow children to play with the
appliance,open doors or hide
inside,they should be supervised at all
times.
●Do not allow children to open and hang
on the doors that may damage or tip
over the appliance that may cause
injury .
2
●Do not allow children to access or play
behind the rear of the appliance,
exposed metal components can cause
injury.
Keep away from water
●Do not spray water on the appliance or
wash the appliance by pouring or filling
water in case of invalid insulation and
possible electric shock.
Be careful of freezing
●Do not touch surface of the liner inside
the compartment, especially with wet
hand, in case of frozen injury while the
appliance is in operation.
Modification on the appliance
not allowed
●Do not reconstruct the appliance by
yourself which might cause damages to
the appliance.
Unplug the appliance under
certain conditions
●Unplug the appliance before cleaning &
maintenance.
●Unplug the appliance when power cut
occurred.
Disposal of the appliance
●Please adhere to local regulations
regarding disposal of the appliance for
its flammable refrigerant and gases.
●Before you scrap the appliance, please
take off the doors to prevent children
being trapped.
●Send the appliance to the designated
disposal location.
Do not damage the power cord
●Do not disconnect the appliance by
pulling power cord rather than pulling
the plug.
●Do not trap the power cord underneath
the appliance and keep clear to avoid
accidental damage to cord or plug.
●Keep power cord clear from the
appliance when moving .
When the power cord is damaged
●Do not use damaged power cord, and
get it replaced immediately by
manufacturer service agent or by
qualified electrician.
●If needed, extend the power cord with
cord of 0.75mm2 or bigger by qualified
electrician.
3
Description of the appliance
Accessories & name
Note: Shelves, door frame, handle and other accessories could be different according to different
models and configuration. All photos in this manual are for reference. The appliance you buy might
not be exactly the same as shown here. Please refer to the actual product.
Installing the handle
1. Install handle to the door frame of the appliance.
The handle is packaged separately with the mounting
hardware inside the carton and handle must be fitted
prior to installation.
(1)Expose the mounting holes in the door frame (2) by
lifting portion of the door seals (3) upwards. Align the
screw posts of the door handle with the holes in the door
frame and secure the handle with 2 screws (4) with the
aid of a screw driver tightly to the door frame.
Fold sections of door seal back in place to conceal screw
heads .
1. Housing
2. Display panel
3. Shelf
4. Cover board
5. Grill
6. Adjustable foot
7. Lower hinge cover
9. Door
10. Door seal
11.Upper hinge
8. Handle
4
Installation & operation
Position
Do not angle the appliance over more than 45 degrees when moving into position .
The appliance must be placed on a level and flat surface.
酒柜结构及安装示意图
Do not place appliance in damp/wet area.
Do not place appliance in area where it will be exposed to frost or weather conditions.
Do not use outdoors unless placed in fully covered areas that avoids exposure to direct
weather conditions.
The appliance is designed so it can be build in under counter /bench
tops or be positioned and operated stand alone .
Refer to illustration below for dimensions required to position appliance under counter/bench top.
After installation , run the appliance for approximately 1 Hour to allow the internal compartment to
get cool before placing beverage cans or bottles inside compartment.
5
Start operation
1. Before switching appliance On for the first time , clean the internal surfaces of the compartment
by wiping with damp cloth as per Maintenance & Cleaning instruction further in this instructions
booklet and check that drainage pipe is connected properly
2. Let the appliance settle for at least 30 minutes after it was moved into position before switching
appliance On ( To allow for refrigerant to normalize )
3. Switch the power On and operate for 1 Hour and check if it is cooling properly after this period of
time, before placing any beverage cans or bottles in the appliance cooling compartment.
Control panel
Note: None of the Control panel keys can be operated if appliance is in Locked Mode. ( To Lock or
Unlock refer to key function details below )
ON/OFF
1. Hold down the on/off key for 3 seconds to power down, unit will go into stand-by mode.
2. Hold down the on/off key again 3 seconds to return unit back to normal working operation.
Light
Press this Key to turn LED light On or Off inside the cooling compartment .
In Stand-By mode the light cannot be activated.
UP
Press the key once, LED display will begin flashing showing current set temperature.
Continue pressing to adjust set temperature, one press increases 1℃. Flashing will cease
after 5 seconds of no activity and new set temperature will be saved. LED display will return
to show actual temperature inside.
Down
Press the key once, LED display will begin flashing showing current set temperature.
Continue pressing to adjust set temperature, one press reduce 1℃. Flashing will cease after
5 seconds of no activity and new set temperature will be saved. LED display will return to
show actual temperature inside.
Child Lock（Combination key）
1. Lock：Hold down both keys at the same time for 3 seconds to lock.
2. Unlock：Hold down both keys at the same time for 3 seconds to unlock.
Fahrenheit/Celsius display interchange
Switch temperature display between Fahrenheit and Celsius by pressing both keys.
6
Attention
1. The cooling temperature could be set from 0℃-10℃.
2. Alarm sound: when a system malfunction occurs and alarm sounds, press any key on the
control panel to cancel the alarm sound.
3. Temperature sensor failure:
If a temperature sensor failures occur, error code displays. E1 for open circuit; E2 for short
circuit..
Beverage storage
This appliance is equipped with chromed wire shelves to store your beverages.
3 chromed wire shelves loading capacity: 178 cans. (standard can with Φ66x123H’mm’)
Loading capacity will vary in terms of different way of cans arrangement or different can sizes.
Each shelf can pull out partly to place cans easily.
Open the door wide enough before pulling out shelves.
If the beverage cooler is not in use for long periods of time, it is recommended to power it off,
clean it carefully, and open the door for ventilation
7
Troubleshooting
The appliance make a
noise during operation?
If unit is not level vibration will cause noise, level
appliance by adjusting the adjustable feet
underneath the appliance. Allow for a little space
between rear of appliance and back wall.
Liquid flowing sound
inside the cabinet?
This is normal because of the refrigerant circulating
inside.
The appliance does not
start？
Make sure the appliance is connected to the power
properly.
Make sure switch on the power.
The compressor re-starts after 5 minutes after a
power cut.
Compressor runs
continuously?
If no cold air is being produced, call the after-sale
service.
Door does not seal tightly
？
After a long period of use, the door seal might get
stiff & distorted partially.
1. Heat the door sea slightly with heat gun or with
or hot towel.
2. The door seal will soften and then close the
door.
The appliance does not
cool sufficiently?
Please adjust temperature setting.
Keep the appliance away from sunlight or heat.
Please do not open the door frequently.
Unpleasant smells inside
cabinet？
A little bit of plastic smell for newly purchased
appliance is normal and will disappear after a short
time.
Clean the compartment and ventilate it for a few
hours.
Condensate on the glass
door？
Please do not open the door frequently or for a
long time.
Please do not set the temperature too low.
High ambient temperature and humidity will cause
condensation
The light is not working？
Check the power supply first.
Call the retailer’s after-sale service if the light is
broken.
Este manual sirve para los siguientes modelos
1
Tabla de contenidos
