Grundfos UPM3 Manual de usuario

Assembly instructions | Grundfos UPM3 Auto 15/70

Introduction

Grundfos UPM3 Auto 15/70 is a compact,

energy-saving and high-performance pump spe-

cically developed for the OEM market. LK uses

UPM3 Auto in several products because of its

good characteristics.

The pump has ten different setting options, three

curves for Proportional Pressure, three curves for

Constant Pressure and four curves for Constant

Curve. The recommendation for underoor heat-

ing is Constant Pressure and a curve that is adap-

ted to conditions for the installation. The pump is

set to Proportional Pressure, curve three, on

delivery.

Operating mode / Settings mode

Grundfos UPM3 Auto indicates in normal opera-

tion the setting currently in use by the pump.

Read the selected mode by studying the settings

menu.

To change the pump setting press the button on

the pump. Then the pump shifts to the selected

setting in accordance with the settings menu.

Pressing the button shifts the pump between

the different settings. Adjust to the desired setting

using the menu.

Note that for oor heating Constant Pressure is

recommended with a curve that is suitable for the

installation needs.

CONSTANT PRESSURE 1

CONSTANT PRESSURE 2

CONSTANT PRESSURE 3

MAX

Table, overview of operating mode.

Note!

The pump is set to Proportional Pressure,

curve three, on delivery.

This must be manually changed to Constant

Pressure by the installer when the pump is

used in oor heating installations.

Grundfos UPM3 Auto 15/70

Table of Contents

Introduction 1

Operating mode - Settings mode 1

Settings menu 1

Alarm codes 2

Dimensions 2

Pump diagram 2

Electrical contact 2

Settings menu

OPERATING PANELCONTROL MODE

0PROPORTIONAL PRESSURE AUTO ADAPT

1CONSTANT PRESSURE AUTO ADAPT

2PROPORTIONAL PRESSURE 1

3PROPORTIONAL PRESSURE 2

4PROPORTIONAL PRESSURE 3 - MAX

5CONSTANT PRESSURE 1

6CONSTANT PRESSURE 2

7CONSTANT PRESSURE 3

MAX

8CONSTANT CURVE 1

9CONSTANT CURVE 2

10 CONSTANT CURVE 3 MAX

CON

ROL MODE

NAL PRE

ANT PRESS

APT

NAL PRE

ANT C

VE 2

ANT C

VE 3

Overview of settings options for the UPM3. Relevant set-

tings are marked with a blue triangle, other settings

are shaded.

EN.33.C.178.2021-11-30

All manuals and user guides at all-guides.com

Assembly instructions | Grundfos UPM3 Auto 15/70

Electrical contact

The pump's electrical contact should be connected

to a 230 V 50 hz socket by a qualied electrician in

accordance with the diagram above. This contact

no longer requires a 2-pole switch disconnecter.

The electrical contact should be equipped with a

slow-blow fuse of up to 10 A. The pump should

be disconnected from the mains before any main-

tenance work.

Alarm codes

In the event of an operating problem then a fault

code will be displayed as below.

Display Indication Operation Action

Red LED,

Yellow LED

Blocked

rotor

False start

was 1.33 s.

Wait or re-

lease rotor

Red LED,

Yellow LED

Too low

voltage

Only one

warning, the

pump oper-

ates as normal

Check the

voltage to the

pump

Red LED,

Yellow LED

Electric

fault

Pump stops

because of

low voltage or

serious fault

Check voltage

to pump / Re-

place pump/

impeller*

*Release impeller using screwdriver PH2. Break the

voltage to the pump. Insert the screwdriver into the

center hole of the drive side, press the screwdriver in

about 5 mm, then rotate forward /backward until the

impeller loosens.

Dimensions

72 45

130

128

36 92

G1 Weight 1,9 kg

Grundfos UPM3 Auto 15/70 130

Pumpdiagram

EN.33.C.178.2021-11-30

LK Systems AB, Box 66, 161 26 Bromma | www.lksystems.se

All manuals and user guides at all-guides.com

Otros manuales para UPM3

Otros manuales de Bomba de agua de Grundfos

Grundfos

Grundfos JP Manual de usuario

Grundfos

Grundfos Unilift AP12 Manual de usuario

Grundfos

Grundfos CR Manual de usuario

Grundfos

Grundfos LM Series Manual de usuario

Grundfos

Grundfos APG Series Manual de usuario

Grundfos

Grundfos TPE Manual de usuario

Grundfos

Grundfos SE1 50 Manual de usuario

Grundfos

Grundfos MSS Series Manual de usuario

Grundfos

Grundfos Medium UPM Series Manual de instalación y operación

Grundfos

Grundfos MQ Manual de usuario

Grundfos

Grundfos CRE Manual de usuario

Grundfos

Grundfos SQFlex 11 SQF-2 Manual de usuario

Grundfos

Grundfos DMX 227 Manual de usuario

Grundfos

Grundfos ALLDOS KM 251 Manual de usuario

Grundfos

Grundfos STR2 Manual de usuario

Grundfos

Grundfos MAGNA1 D Manual de usuario

Grundfos

Grundfos CM Booster PM1 Manual de usuario

Grundfos

Grundfos SP Manual de funcionamiento

Grundfos

Grundfos CR 1s Manual de usuario

Grundfos

Grundfos SCALA2 Manual de usuario

Grundfos

Grundfos UPMM 15-95 130 Manual de usuario

Grundfos

Grundfos CM Manual de usuario

Grundfos

Grundfos PACOpaQ Suplemento

Grundfos

Grundfos CRN 95-6-3 Manual de usuario

Manuales populares de Bomba de agua de otras marcas

Neptun

Neptun NPHW 5500 Manual de usuario

Sensidyne

Sensidyne Gilian BDX-II Instrucciones de instalación y funcionamiento

Draper

Draper 47808 Manual de usuario

Trolla

Trolla 12820 Manual de usuario

Sunfab

Sunfab SVH Series Manual de usuario

WilTec

WilTec 50740 Manual de usuario

Fieldmann

Fieldmann FVC 5015 EK Manual de usuario

Everbilt

Everbilt EFSUB5-122HD Manual de usuario

Graco

Graco Husky 3300e Manual de usuario

esotec

esotec 101018 Manual de usuario

moyno

moyno 2000 CC Manual de usuario

Becker

Becker BASIC VASF 2.80/1-0.AC230 Manual de usuario

Sykes AmeriPumps

Sykes AmeriPumps GP100M Guía de solución de problemas

DUROMAX

DUROMAX XP WX Series Manual de usuario

BRINKMANN PUMPS

BRINKMANN PUMPS SBF550 Manual de usuario

Franklin Electric

Franklin Electric IPS Manual de usuario

Xylem

Xylem e-1532 Series Manual de usuario

Milton Roy

Milton Roy PRIMEROYAL Manual de usuario