Graco 240054 Manual de operación

308830E

First choice when

quality counts.t

INSTRUCTIONS-PARTS LIST

Important Safety Instructions

DRead all warnings and instructions in this

manual. Save these instructions.

Frame, Roller

5000 psi (345 bar, 34.5 MPa) Maximum Working Pressure

Model 240054, Series A

3 in. (7.6 cm) length

Model 240055, Series A

12 in. (30.5 cm) length

Model 240005, Series A

9 in. (22.9 cm) length

Pressure Relief Procedure

WARNING

IN INJECTION HAZARD

The system pressure must be manually

relieved to prevent the system from

starting or spraying accidentally. Fluid

under high pressure can be injected through the

skin and cause serious injury. To reduce the risk of

an injury from injection, splashing fluid, or moving

parts, follow the Pressure Relief Procedure

whenever you:

Dareinstructedtorelievethepressure,

Dstop spraying,

Dcheck or service any of the system equipment,

Dinstall or clean the frame.

1. Lock the gun safety latch.

2. Shut off the power supply to the pump and open

any air bleed valves in the system.

3. Unlock the gun safety latch.

4. Hold a metal part of the gun firmly to the side of a

grounded metal waste container, and trigger the

gun to relieve pressure.

5. Lock the gun safety latch.

6. Open the pump drain valve to help relieve fluid

pressure in the pump, hose and gun. Triggering

the gun to relieve pressure may not be sufficient.

Have a container ready to catch the drainage.

7. Leave the drain valve open until you are ready to

spray again.

If you suspect that the frame or hose is completely

clogged or that pressure has not been fully relieved

after following the steps above, VERY SLOWLY

loosen the tip retaining nut or hose end coupling and

relieve pressure gradually, then loosen completely.

Now clear the frame or hose obstruction.

GRACO INC. P.O. BOX 1441 MINNEAPOLIS, MN 55440--1441

http://www.graco.com

Graco Inc. is registered to I.S. EN ISO 9001

7927A

2 308830

Installation

WARNING

Refer to your sprayer and spray gun manuals for

appropriate warnings and instructions for safe op-

eration of this roller frame.

Gasket (7) must be in place before installing frame

(1). If gasket is not in place there is a potential in-

jection hazard which could result in serious injury.

1. Follow Pressure Relief Procedure on page 1.

2. Prime pump.

3. Install roller frame.

Parts

Ref

No. Part No. Description Qty

1 FRAME, roller

220235 Model 240054, 3 in. (7.6 cm) 1

218582 Model 240005, 9 in. (22.9 cm) 1

224378 Model 240055, 12 in. (30.5 cm) 1

2 183420 NUT, retainer, diffuser 1

3 108808 PACKING, u-cup 1

4 DIFFUSER, roller

220233 Model 240054, 3 in. (7.6 cm) 1

218934 Model 240005, 9 in. (22.9 cm) 1

224377 Model 240055, 12 in. (30.5 cm) 1

5 101983 SCREW, set 1

6 192638 FITTING, swivel 1

7 15H622 GASKET, non-metallic 1

9 192637 NUT, retaining, 7/8--14 (f) 1

Wetted Parts: fluoroelastomer, nylon, plated........

steel polyethylene, acetal

Lips of u-cup face

roller diffuser (4)

7926b

All written and visual data contained in this document reflects the latest product information available at the time of publication.

Graco reserves the right to make changes at any time without notice.

This manual contains English. MM 308830

Graco Headquarters: Minneapolis

International Offices: Belgium, Korea, China, Japan

GRACO INC. P.O. BOX 1441 MINNEAPOLIS, MN 55440--1441

http://www.graco.com

12/97, Revised 08/2009

Este manual sirve para los siguientes modelos

Tabla de contenidos

Otros manuales de Pistola pulverizadora de pintura de Graco

Graco

Graco EM 480 Hydra-Spray Manual

Graco

Graco T-Max Applicator 256383 Manual de uso y cuidado

Graco

Graco Gusmer Power-Lock 246045 Manual de lista de piezas

Graco

Graco Ultra 395 Manual de usuario

Graco

Graco Magnum XR5 Manual de usuario

Graco

Graco 980S Manual de operación

Graco

Graco JetRoller 25D229 Manual de instrucciones

Graco

Graco IronMax V Manual técnico

Graco

Graco Series E Manual de operación

Graco

Graco 3A0243A Instrucciones de funcionamiento

Graco

Graco Mark X 249627 Manual de usuario

Graco

Graco Reactor E-10 Manual de usuario

Graco

Graco 30110-500-2 Guía

Graco

Graco 231-575 Manual de usuario

Graco

Graco XM Series Manual de usuario

Graco

Graco AirPro 313869B Manual de usuario

Graco

Graco GM3000 Manual de operación

Graco

Graco Reactor 2 E-30 Manual de uso y cuidado

Graco

Graco Xtreme 309329 Manual de usuario

Graco

Graco SaniSpray HP 65 Manual de uso y cuidado

Graco

Graco GMax 308870 Instrucciones de funcionamiento

Graco

Graco ULTRA AIRLESS 230-963 Hoja de datos

Graco

Graco Contractor King 279005 Manual de usuario

Graco

Graco TapeLazer HP Automatic Guía

Manuales populares de Pistola pulverizadora de pintura de otras marcas

SNOWJOE

SNOWJOE Sunjoe 24V-GS-LTW-RM Manual de usuario

Binks

Binks SV100 Manual de usuario

Fimco

Fimco LG-4-3-1 Manual de usuario

AG SPRAY

AG SPRAY FS-ATV-25BL Manual de usuario

Nordson

Nordson MicroMax 2 Manual de usuario

Bonide

Bonide 051 Manual de operación

zogics

zogics Z-DAS Manual de usuario

KISANKRAFT

KISANKRAFT KK-KBS-165 Manual de usuario

Matrix

Matrix SG 650 Manual de usuario

Anest Iwata

Anest Iwata SGA-3 Guía de inicio rápido

paasche

paasche VV Hoja de datos

Carlisle

Carlisle DeVilbiss JGA-510 Manual de usuario

Gardena

Gardena 11120 Manual de usuario

Conrad

Conrad Hobby Airbrush K3 Manual de usuario

wiwa

wiwa 14025 R/F Manual de usuario

DeVilbiss

DeVilbiss LUNA2i Manual de usuario

WAGNER

WAGNER W 125 Manual de usuario

My Clean Buddy

My Clean Buddy PW018 Manual de usuario