Gourmet Dispensing D300 Manual de usuario
Quick Start Guide for 1, 2 & 4 Faucet D300 Dispensers
1
High Volume Heated Dispensing Systems
Specs, Benefits and Contact Information
General Information
2
D300 Dispenser –Overview
Keeps Food Lines Moving
¤Dispenses 96 ounce or 6 -16oz. tumblers
an minute at constant 175 degree
temperature.
¤Available in single, double hot, hot &
cold and double hot / double cold
faucet versions.
¤Can be set up to use CO2, compressed
air or Nitrogen.
¤Easy to clean, easy maintain
¤ETL and UL listed & NSF approved
Models available in single, double hot, hot & cold and 2 hot & 2 cold
faucet versions.
3
D300 –System Specifications
4
Dispenser –Points of Contact
May have up to 2 hot and 2 cold (4 total) faucets.
5
6
Putting it all together
Installation Guide
Required Tools and Supplies
7
¤Flat bladed screw driver –to adjust gas and set screw clamps
¤Faucet Wrench (included) to secure faucets during initial setup
¤Channel locks or stem wrench to secure Gas tank connection
¤Three -5 or 6 quart buckets –for start up and cleaning
¤Hot Water –for cleaning and shutdown
¤Gas Supply –to operate pumps or pressurize tanks
¤Refrigeration –if required to keep product fresh
¤Tanks, kegs or BiBs of product to be served
¤220 volt / 30 amp electrical supply
Important Notes –Read First
DO NOT TURN MACHINE ON WITHOUT FIRST ADDING WATER
TO THE RESERVOIR!
THE WATER IN RESERVOIR WILL BE HOT AFTER SHUTDOWN. Use
extreme caution if moving dispenser during or after use.
Drain water from dispenser before shipping or transporting.
8
Set-up -Leg Installation
Leg installation
¤Gently lay dispenser down on it’s left
side.
¤Screw all four legs into the four leg
sockets located in each corner of the
bottom of the dispenser unit.
¤Carefully turn unit onto it’s feet.
Turning machine on left side will help avoid damaging power switch and fittings.
9
Set-up -Faucet Installation
Faucet installation
¤Place faucet head onto faucet stem
coming out of machine.
¤Secure faucet head by first finger
tightening it into place by turning the
ring.
¤Use included faucet wrench to secure
the faucet into place.
¤Be sure faucets are straight before
securing to unit. If the need to be
adjusted, loosen faucet nut, twist
faucet left or right until straight and
retighten nut.
Faucet styles may very, but they are all attached the same way.
10
Tabla de contenidos
Otros manuales de Dispensador de Gourmet Dispensing
