Goldmedal 2626 Manual de usuario

Part No. 17027

Revised: February 2010

KARMEL BABY CORN TREAT

Instruction Manual

Model #2626

SAFETY PRECAUTIONS

KARMEL BABY

MODEL# 26263

INSTALLATION INSTRUCTIONS

Inspection of Shipment:

Unpack all cartons and check thoroughly for any damage that may have occurred during

transit. Damage claims should be filed immediately with the transportation company. Gold

Medal Products is not responsible for damage that occurs in transit.

Setup:

Your new KARMEL BABY is completely assembled and tested at the factory.

Remove all packing material and tape before starting operation.

Electrical Requirements:

Voltage for the 2626 is 120 volt, 60 cycle single phase. The machine will draw a maximum of

15amps. Your electrician must finish sufficient current for the proper operation of your machine. We

recommend this machine be on a dedicated and protected circuit line.

The 2626 has a current draw of 15 amps

Your electrician must furnish sufficient power for proper machine operation. We recommend

this popper be on a dedicated and protected circuit. Failure to wire properly will void the

warranty and may result in damage to the machine.

It is Gold Medal Products Company’s recommendation that this machine be plugged directly

into a wall outlet. The use of extension cords is not recommended due to safety concerns,

and may cause sacrificed and/or reduced performance.

KARMEL BABY

MODEL# 26264

CONTROLS AND THEIR FUNCTION

HEAT and MOTOR SWITCH

This rocker switch in the “ON” position energizes the heating elements in the bottom of the kettle.

I = ON and O = OFF

MOTOR SWITCH

With this rocker switch in the “ON” position, the agitator motor will run continuously.

HEAT CONTROL

The machine comes from the factory preset at 280°F for Corn Treat Centers. If more or less heat is

required, remove the silver hole plug or cover plate located on the front panel of the control box. This will

allow you to access the heat control adjustment potentiometer. Turn the potentiometer clockwise to

increase the temperature.

To calibrate the heat control for corn treat, Fill the mixing bowl with enough corn oil to cover the heat

sensor (around 1-1/2”) . Use an accurate thermometer to measure the temperature of the oil in the mixing

bowl. Stir the oil while it heats. When the oil reaches 310F slowly turn the potentiometer counter clockwise

until the buzzer sounds. If the buzzer sounds before the temperature reaches 310F turn the potentiometer

clockwise until the buzzer stops and continue to turn an additional 1/8 of turn.

Note: The sound of the buzzer always signals temperature cut-off.

KARMEL BABY

MODEL# 26265

INSTRUCTIONS FOR MAKING CARAMEL CORN

1. Turn the motor / heat switch "ON".

2. Add 4 ounces of water, one package of Gold Medal 2157 2.5 gal caramel complete mix.

3. Turn the motor switch "ON" and mix for approximately one minute. Turn the motor switch "OFF". (With

the heat switch "ON" the motor will run for 15 seconds every minute.)

4. Allow the mix to cook until the buzzer sounds at 280° F product temperature.

5. Turn the motor / heat switch "OFF".

6. Turn the motor switch "ON".

7. Add two and a half gallons of pre popped corn.

8. Allow the corn to mix for approximately thirty (30) seconds with the kettle in the upright position.

9. Move the kettle to the mix position and mix the popcorn until it is thoroughly coated.

10. Dump the caramel corn into the cooling pan.

CARE AND CLEANING

STEAM CLEANING

The easiest way to clean the kettle is to pour 8 ounces of water into the kettle while it is still hot. Place the

lid back on the kettle. Let it steam for approximately ten minutes. Remove the lid and dump out the water.

You will probably have to steam the kettle twice to remove all traces of product. Releasing the draw latch

makes the mixing drum easy to remove for cleaning. The mixing drum can be taken to the sink to clean.

The cabinet of your machine should be wiped cleaned daily; or more, depending on your usage.

KARMEL BABY

MODEL# 26266

NEW PADDLE & HUB SEAL KIT INSTALLATION

1. Unscrew the wing bolts and remove both mix paddles.

2. Remove the old hub seal assembly.

3. Clean the area around the center hub. Clean up all food and carbon residue.

4. Remove any burrs on the top edge of the center hub. Use a fine grit emery paper to lightly sand the

surface. If the burrs are not removed, damage may occur to the hub assembly during installation.

5. Lightly lubricate the center hub of the kettle with a small amount of vegetable oil to allow for easy

installation of the hub seal assembly.

6. Slide the hub seal assembly down the agitator shaft. Apply pressure to ease the assembly over the

center hub of the kettle until it seats properly. (See diagram below.)

7. After the hub seal assembly has been properly installed, place the new mix paddle on the bottom and

one existing paddle on the top of the agitator shaft.

8. Replace the wing bolts and finger tighten.

KARMEL BABY

MODEL# 26267

KARMEL BABY

MODEL# 26268

ORDERING SPARE PARTS

1. Identify the needed part by checking it against the photos, illustrations, and/or the parts list.

2. When ordering, please include part number, part name, and quantity needed.

3. Please include your model name, serial number, and date of manufacture (located on the machine

nameplate) with your order.

4. Address all parts orders to:

Parts Department

Gold Medal Products Co.

10700 Medallion Drive

Cincinnati, Ohio 45241-4807

(800) 543-0862

(513) 769-7676

Fax: (513) 769-8500

or, place orders at:

E-mail: [email protected]

Web Page: www.gmpopcorn.com

KARMEL BABY

MODEL# 26269

Assembly Parts

Drive Shaft

p/n 16732

Mix Paddles

p/n 16737

Kettle Casting

p/n 16766

Mixing Drum

p/n 16761

Blending Strip

p/n 16765

RTD Senso

p/n 46299

Hub Seal Assy (Includes O-Ring)

p/n 16752

Lid Assembly

p/n 16810

Internal Kettle Parts (Not Shown)

1720W Element – p/n 67889

525F Thermostat – p/n 76702

Kettle Drive Shaft O-ring – p/n 16747

Mix Paddle Lock Stud (2)

p/n 16761

KARMEL BABY

MODEL# 262610

Assembly Parts (Con’t)

Retaining Ring And Seal

(See Zoomed View Below)

Dump Handle

p/n 41139

Handle

p/n 16985

Bottom Plate

p/n 16760

Motor Mount

p/n 16897

Moto

p/n 16723

Lead In Cord

p/n 87085

Drum Seal

p/n 16764

Motor Stop

p/n 16926

Retaining Ring

p/n 16762

Tabla de contenidos

Otros manuales de Electrodoméstico de cocina de Goldmedal

Goldmedal

Goldmedal 2666 Manual de usuario

Goldmedal

Goldmedal 2656KC Manual de usuario

Goldmedal

Goldmedal G-Whiz 5908 Manual de usuario

Goldmedal

Goldmedal PINTO POP Manual de usuario

Goldmedal

Goldmedal Pop-O-Gold Manual de usuario

Goldmedal

Goldmedal 4008 Manual de usuario

Goldmedal

Goldmedal The Breeze 3030-00-000 Manual de usuario

Goldmedal

Goldmedal 5021 Series Manual de usuario

Goldmedal

Goldmedal Unifloss 3034 Manual de usuario

Goldmedal

Goldmedal 2552 Manual de usuario

Goldmedal

Goldmedal 2396 Series Manual de usuario

Goldmedal

Goldmedal Mighty-Mite 2035BG Manual de usuario

Goldmedal

Goldmedal cornado Manual de usuario

Goldmedal

Goldmedal Deluxe Citation Series Manual de usuario

Goldmedal

Goldmedal 2488 Manual de usuario

Goldmedal

Goldmedal Gay 90 Whiz Bang Manual de usuario

Goldmedal

Goldmedal Master Pop 2451 Manual de usuario

Goldmedal

Goldmedal Citation 2001 Manual de usuario

Goldmedal

Goldmedal Econo-Floss Manual de usuario

Goldmedal

Goldmedal 2408 Manual de usuario

Goldmedal

Goldmedal Pop-O-Gold Manual de usuario

Goldmedal

Goldmedal 1617 Manual de usuario

Goldmedal

Goldmedal Citation Manual de usuario

Goldmedal

Goldmedal Econo-Floss Manual de usuario

Manuales populares de Electrodoméstico de cocina de otras marcas

Tayama

Tayama TYG-35AF Manual de usuario

AEG

AEG 43172V-MN Manual de usuario

REBER

REBER Professional 40 Guía del usuario

North American

North American BB12482G / TR-F-04-B-NCT-1 Manual de usuario

Presto

Presto fountain popper Manual de usuario

Westmark

Westmark 1035 2260 Manual de usuario

Zanussi

Zanussi ZCG64396XA Manual de usuario

HOFFEN

HOFFEN SM-9302M Manual de usuario

Philips

Philips HD3133 Manual de usuario

Ronco

Ronco Beef Jerky Manual de usuario

Hendi

Hendi 470411 Manual de usuario

Livoo

Livoo MEN386 Manual de usuario

Vogue

Vogue D446 Manual de usuario

croydon

croydon WR-10313-700 Manual de usuario

ADE

ADE AUTOMATIC-L Manual de usuario

Chefman

Chefman RJ43-SQ Series Manual de usuario

Vacmaster

Vacmaster VP680 Manual de usuario

Jetmaster

Jetmaster 900HG Manual de usuario