gio H2 VOLT Manual de usuario
DO NOT RETURN TO STORE!
Illustrations may not be exact appearance of actual product.
Please contact GIO Customer Care Center @ 1-877-274-0480 for any concern or/and inquiry.
Table of Contents
SECTION 1: Introduction ............................................................................................................................... 3
Recording Your E-bike Info........................................................................................................................ 4
SECTION 2: Electric bicycle and its components........................................................................................... 5
SECTION 3: ASSEMBLY .................................................................................................................................. 7
Front wheel installation: ........................................................................................................................... 7
Unfolding the Frame ................................................................................................................................. 7
Unfold the Handlebars.............................................................................................................................. 8
Adjusting the Seat..................................................................................................................................... 9
Brake Adjustment ..................................................................................................................................... 9
Pedals Installation................................................................................................................................... 10
Pedals folding..........................................................................................................................................10
SECTION 4: Important Instructions ............................................................................................................. 11
SECTION 5: Safety Precautions ...................................................................................................................12
SECTION 6: General Operating Instructions ............................................................................................... 13
BEFORE YOU RIDE ...................................................................................................................................13
SECTION 7: Battery charging and precautions............................................................................................13
Battery Precautions ................................................................................................................................ 14
Removing the Battery from the Bike ......................................................................................................15
SECTION 8: Specific Operating Instructions................................................................................................15
SECTION 9: MAINTENANCE......................................................................................................................... 16
Wheels .................................................................................................................................................... 16
Rims - ...................................................................................................................................................... 16
Spokes ..................................................................................................................................................... 16
Tires......................................................................................................................................................... 16
Brakes...................................................................................................................................................... 16
Batteries.................................................................................................................................................. 16
Chain ....................................................................................................................................................... 16
SECTION 10: Troubleshooting.....................................................................................................................17
SECTION 11: Warranty ................................................................................................................................18
SECTION 1: Introduction
Dear Customer,
Wow! Aren’t you excited! You have just received your brand new e-bike. We, too, are excited because
as designers and developers of our bikes, we love to make you happy, and we believe your new e-bike
will give you lots of fun. I am sure you want to get this bike on the road immediately, but please STOP!
Why? Well, first of all, you need to charge your batteries fully before using them. So, follow instructions
in section 7 and while your e-bike is charging, take the time to read this entire manual. This manual will
help prevent injury and teach you how to care for your new e-bike.
It is the owner’s responsibility to carefully read all of the contents of this manual and to comply with all
laws pertaining to the operation of bicycles and/or electric bicycles in your local jurisdiction. If you have
any questions, please consult with local authorities or the Ministry of Transportation for clarification.
These electric bikes are not classified as motor vehicles. They are considered a motorized bicycle or
power assisted bicycle. With proper care, maintenance and attention to bicycle safety rules, your e-bike
will give you years of enjoyment.
Please read the instructions carefully before using your e-bike. Do not ride this bicycle until you have
read and thoroughly understand the owner’s manual. It contains information critical to your safety. If
you have questions about the operation of this electric bicycle, consult your authorized dealer.
It is extremely important that you follow the safety guidelines contained in this manual in order to
ensure your maximum safety. If you loan your bike to anyone, make sure they also know how to operate
it safely. When using, the load should not be greater than the maximum capacity, and please pay
attention to increase the braking distance during rainy or snowy days.
This e-bike can operate in the rain and snow, but it CANNOT be submerged in water. When the motor is
submerged in water, it may short circuit and fail, which is NOT covered by the warranty. Unless suitably
qualified, please don't dismantle or attempt to repair yourself, go to the local dealer.
Please take time to record the following information:
Recording Your E-bike Info
Serial Number: _______________________________________________________
Model: ___________________-________________________________
Color: _______________________________________________________
Date of Purchase: _______________________________________________________
Dealer’s Name: _______________________________________________________
Dealer’s Ph. #: _______________________________________________________
Dealer’s Email: _______________________________________________________
SECTION 2: Electric bicycle and its components
5
4
3
2
6
7
8
20
13
14
15
11
10
12
16
28
27
1
26
25
24
23
22
9
21
19
18
17
29
No’
Component
No’
Component
1
Left brake lever (Rear Brakes)
15
Saddle height adjustment clamp
2
Handlebar folding hinge
16
Saddle
3
Headlight
17
Rear reflector
4
Front mudguard
18
Rear sprocket
5
Front rotor
19
Chain
6
Front wheel quick release handle
20
Kick stand
7
Front disc brakes
21
Front sprocket
8
Foldable pedal
22
Front suspension adjustable
9
Pedal crank
23
Handlebar height adjuster
10
Hub motor
24
Throttle
11
Rear brakes (pads)
25
Right brake lever (Front Brakes)
12
Rear mudguard
26
Digital Display
13
Battery lock
27
Frame quick release safety latch
14
Battery
28
Frame quick release latch
29
Battery connector
A
B
C
D
F
E
F
SECTION 3: ASSEMBLY
Only minimal assembly is required for your new e-bike. You will be required to do the following:
Front wheel installation:
First, make sure all hardware is exists. You should have front axle + spacer + 2 springs (some models will
have only 1 spring) + nut.
Attach the wheel based of illustration below –Make sure that the rotor sitting properly inside brake
caliper.
Unfolding the Frame
The frame of your bike folds in the middle. The quick-release latch is released and lifted up to allow the
locking pin to release and unfold the bike.
Insert Upper Handlebar Stem
Quick-release latch locked
Quick-release latch unlocked
and locking pin released
Frame is folded
Front axle
Spacer
Spring
Front Wheel
Rotor
Spring
Nut
Left Fork
Right Fork
Brake caliper
Released
Adjust
Locked
Quick
release
lever
Your bike upper handlebar stem is inserted into the lower stem and is tightened with the quick-release
handle as in picture. You can snug up the quick release with the hand nut opposite the handle to get the
proper tightness.
Unfold the Handlebars
Unfold the handlebars and lock into place. The hinge has a quick-release that is released and slid off the
base and then needs to be slid to one side to unlock the hinge.
Quick-release handle
Quick-release hinge locked
Quick-release hinge
unlocked
Handlebar is folded
Adjusting the Seat
The seat is adjusted with the quick-release. The tightness of the quick-release clamp can be adjusted
with the hand nut on the opposite side of the handle.
Brake Adjustment
Your bike’s front and rear brakes have a pad that ride on the rim of the wheel for braking. These are
adjusted by tightening the cable and by adjusting the stem of the pad. The front brake should be
adjusted so that it slows the tire but cannot make it skid. The rear brake should be adjusted so that if
necessary it can skid the tire. Adjust the pads on both sides of the bike. Cables also have adjustment at
the brake levers on the handlebars. Take note that the rear brake is on the left side of the handlebar,
and the front brake is on the right side of the handlebar.
Front Brakes Adjustment
Rear Brakes Adjustment
1. Unscrew nut (1)
2. Pull brake cable (2) forward until pads
touching rotor.
3. Tighten nut (1) and check the brakes
1. Unscrew nut (1).
2. Pull brake cable to the right side until pads
touching rim.
3. Tighten nut (1) and check the brakes
Quick-release clump
Hand nut
Pedals Installation
Attached the pedals by screwing them on to the crank,
Note, there are Left and Right pedals. Left pedal attached to the
left side crank by screwing it counter-clockwise.
Right pedal attached to the right side crank by screwing it clockwise
Pedals folding
(L) Left
(R) Right
Press knobs and push the pedal inside
Push inside to fold the pedal
Fold the pedal
Front Brakes
Rear Brakes
1
2
1
2
3
Tabla de contenidos
Otros manuales de Scooter de gio
