Gilis Bebe Stars Explore 911 Manual de usuario

Group 0-1-2

Suitable for 0-25kg

Explore 911

Thank you for trust to our company and our products

For parents:

Welcome to use Bebe Stars children's safety seats.

Please read user manual carefully before installing and using.

This user manual is a great guide to help you use this product.

Don't put rearward facing children's safety car in the front row

seat with the airbag.

IMPORTANT – DO NOT USE FORWARD FACING BEFORE

THE CHILD'S WEIGHT EXCEEDS 9Kg

Only allow apply to the vehicle that is equipped with

three-point safety belts and meet the requirement of ECE R16.

Don't use force-bearing points without marking.

1. This is a “Universal” child restraint. It is approved to

Regulation No.44, 04 series of amendments, for general use in

vehicles and it will fit most, but not all car seats.

2. A correct fit is likely if the vehicle manufacturer has declared in

the vehicle handbook that the vehicle is capable of accepting a

“Universal” child restraint for this age group.

3. This child restraint has been classifies as “Universal” under more

stringent conditions than those which applied to earlier designs

which do not carry this notice.

4. If in doubt, consult either the child restraint manufacturer

or the retailer.

Introduction

ENEN

1. Safe driving is the best way to protect children and children's

safety seats can protect children effectively but cannot completely

eradicate the harms of car accidents.

2. Please be sure to use the right Group of the children's seats with

appropriate methods of application, which refer to the instructions

manual of child injuries.

3. Please make sure the children's safety seat is properly secured in

the car before starting.

4. The child safety seat must not be positioned anywhere where

it is in range of an airbag which is being deployed, otherwise, once

accident happened, airbag can hurt your child.

5. Unauthorized technical modifications or seat coverings may

reduce or entirely void the seat's protective properties.

6. This system only can apply to the vehicle that is equipped with

3-point safety belts and pass requirements of ECE R16.

7. Please do not leave your child alone in the children's safety seat

in the vehicle.

8. Forbid putting safety seat under direct sunshine to avoid skin

burn under high temperature.

9. Once collision happens, please replace a new child safety seat if

it has been damaged.

10. Forbid using safety seats that are not approved to ECE R44/04

or a comparable standard (see test label on belt with an “E” or “e”

in a circle.

11. Forbid using safety seat without its cloth cover.

12. Forbid using materials that manufacturers not recommend.

13. Please do not let your children play with the safety seat in the

vehicle to prevent risk of injury.

14. The steel components and plastic components of safety seat

have to be fixed by referring to manual, which ensure safety seat

not be stuck by car seats and car doors.

15. The more snugly the harness fits over your child's body, the

safer your child will be. Meanwhile, the lap belts must not be twisted.

It should restrict the position of pelvis.

ENEN

Know your car seat

ENEN

Selection Criteria for Children’s safety seats

This type children's safety seat is applied to Group 0+/I/II and the

requirement for weight is from 0 to 25kg. It is suitable for around0 to

6 year old children. The vehicle should be equipped with three-point

safety belts and meet the requirement of ECE R16.

Different installation methods should be applied to children in different

Group. Please check the below standards to match the right group

installations.

Only can apply to Group 0+ after closing the airbag.

Only can apply to the vehicle that are equipped with 3-point safety

belts.

ENEN

Installation for Group 0+

1. The installation for Group 0+ is rearward facing and if your child's weight is below 9kg,

you cannot make the forward facing installation.

2. For Group 0+, there is only one level and it is level 4 in blue.

3. A special cushion for Group 0+ should be place in the seat.

Step 1: Push the red knob and

adjust the angle of seat to be the

level 4. As shown in the picture,

the arrow should point to 4.

Step 2: Place the safety seat

rearward in the car seat and

make it cling to car seat back.

Step 3: As shown in the picture 3-1, the car safety belt passes through

the hole of the safety seat according to the blue direction. As shown in

the picture 4-1, put the car safety belt tongue into the car buckle.

As shown in the picture 3-2, pull horizontal car belt tight and place

oblique car belt into locking device, then pull belt tight again.

As shown in the picture 3-3, next, put oblique car belt into hook for

Group 0+ and pull belt tight again. Finally, shake the safety seat to

ensure it is already fixed.

ENEN

Installation for Group 1

1. The installation for Group I is forward facing and child's body weight have to be over 9kg

and less than 18kg.

2. There are 3 adjustable levels in Red 1/2/3.

3. After adjusting the angle, the safety seat has to cling to car seat back and pull car safety

belt tight.

Step 1: Push the red knob to

adjust the angle of seat to one of

three levels before starting

installation.

Step 2: Place the safety seat

forward in the car seat and make

it cling to car seat back.

Step3: As shown in the picture 3-1/4-1, the car safety belt passes

through the hole of the safety seat according to the red direction.

As shown in the picture 4-2, put the car safety belt tongue into the car

buckle. As shown in the picture 3-2, pull horizontal car belt tight and

place oblique car belt into locking device, then pull belt tight again,

put remainder belt into seat belt retractor. Finally, shake the safety seat

to ensure it is already fixed.

ENEN

Using Method for Group 0+/1

1. Press Central Adjuster and pull

harness strap outward at the same

time to make the strap loose.

2. Press red button to open the

harness buckle.

3. Pull out both of the shoulder belts to both

sides of the child safety seat, or insert buckle

tongues into fixed slots.

4. Place your child into seat and make sure

the lap belt can restrict the position of pelvis.

Please check the height of shoulder belts.

It is better to make shoulder belts be a little

bit higher than child's shoulders.

ENEN

Instruction

5. Harness Buckle: put two latches together and engage them before

putting them into the harness buckle, you can hear a click noise.

The buckle latches will be released if you press the red button.

6. Adjust the straps by pull harness adjustment strap outward and

make sure that the tightness is comfortable for your child.

7. The shoulder belt height adjuster: before adjustment, remove baffle

plate first. According to different heights of children, 4 levels of

shoulder belts heights can be adjusted. Firstly, as shown in picture

1/2/3, separate the shoulder safety belt with strap yoke, and then

according to 4/5, separate the shoulder belt with harness yoke and

correspond to the appropriate harness slots to insert both of shoulder

safety belts (see picture 6). Finally, connect both of the safety belts as

shown in figures (3/2/1 & 5/4).

8. Caution: Do not twist the belts. 9. Adjusting the height of pillow

to fit children's head.

ENEN

Removal of 5-point harness

Step 1: Adjusting the angle of safety seat to level 4, press central

adjuster and maximum loose the shoulder belts.

Then, remove the bracket in the bottom of safety seat and separate it

with safety belt.

Step 2: Firstly, before adjustment, remove baffle plate. As shown in

picture 1/2/3, separate the shoulder safety belt with strap yoke,

and then according to 4/5, separate the shoulder belt with harness

yoke and pull harness strap out; then, pull the strap with buckle out of

the seat as well (see picture 6). Next, pull harness adjustment strap

tight and hide strap under cloth cover. Finally, you can storage

harness strap.

ENEN

Tabla de contenidos

Idiomas:

Otros manuales de Asiento de coche de Gilis

Gilis

Gilis Bebe Stars BABY plus Manual de usuario

Gilis

Gilis Bebe Stars Young Sport Plus Manual de usuario

Gilis

Gilis Bebe Stars LEVANTE 910 Manual de usuario

Gilis

Gilis Bebe Stars LEVANTE plus Manual de usuario

Gilis

Gilis Bebe Stars KBH305 Manual de usuario

Gilis

Gilis Bebe Stars Leon Plus Manual de usuario

Gilis

Gilis Bebe Stars Booster Cindy Manual de usuario

Gilis

Gilis Bebe Stars Milano Isofix Manual de usuario

Gilis

Gilis Bebe Stars Manual de usuario

Gilis

Gilis Bebe Stars EVO ISOFIX Manual de usuario

Gilis

Gilis Bebe Stars MACAN 360 ISOFIX Manual de usuario

Gilis

Gilis Bebe Stars 007-110 Manual de usuario

Gilis

Gilis Bebe Stars Manual de usuario

Gilis

Gilis BebeStars Magic isofix 942 Manual de usuario

Gilis

Gilis BebeStars Leon 943 Manual de usuario

Gilis

Gilis BebeStars Monaco Manual de usuario

Gilis

Gilis Bebe Stars EVOQUE KBH-308 Manual de usuario

Gilis

Gilis Bebe Stars MACAN 360 ISOFIX Manual de usuario

Gilis

Gilis Bebe Stars Evolution Manual de usuario

Gilis

Gilis BebeStars TRANSPORTER 932 Manual de usuario

Gilis

Gilis Bebe Stars Megan Manual de usuario

Manuales populares de Asiento de coche de otras marcas

Britax

Britax PARKWAY SGL Manual de usuario

JANE

JANE nurse cruiser Manual de usuario

Digicom

Digicom Tippy Pad Manual de usuario

Fisher-Price

Fisher-Price Futura 20/60 Manual de usuario

Giordani

Giordani orion 012 Manual de usuario

BRIO

BRIO ZENTO Manual de usuario

Combi

Combi Zeus Turn 8815 Series Manual de usuario

Graco

Graco Car Booster Seat Manual de usuario

Coccolle

Coccolle Atira Manual de usuario

hifold

hifold HF01-GL Manual de usuario

CYBEX

CYBEX SOLUTION X2-FIX Manual de usuario

kiwy

kiwy SLF 123 Manual de usuario

Safety 1st

Safety 1st Summit ISO 30 Manual de usuario

Safety 1st

Safety 1st Grand 2-IN-1 Manual de usuario

Graco

Graco NAUTILUS Manual de usuario

Britax

Britax Multi-Tech BB0-702-00 Manual de usuario

Grammer

Grammer MSG45/421 Instrucciones de funcionamiento

Nuna

Nuna REBL PLUS Manual de usuario