In Use
Using inputs one and two first; the Three2one will ignore the third input and will only switch
between the two guitars in inputs in use. (Blue and Green). Three2one will then automatically
sense a third input being connected and will cycle through all 3 inputs.
More Guitars, using two Three2one units.
Connect two units together with a ¼” TRS (stereo) cable to connect up to 6 guitars. Pressing the
footswitch on one unit will mute the other unit. You can use either output.
Special Functions
Tip… It’s best to disconnect the output before re-configuring your Three2one, or just turn down
your amplifier if you prefer.
To enter the Special Functions menu simply hold down the footswitch when applying power to the
Three2one. You will then see some of the lights are on and others are off, this tells you the current
configuration.
To change the configuration, press the footswitch once, the red light will flash five times. If you
press the footswitch again whilst the light is flashing the Red function will be toggled, you will see
that the light will have changed state.
The next press will take you to the Green function and the next to the Blue function and the same
applies, press the foot switch again whilst the light is flashing to change its sate. (This change is
remembered by your Three2one.)
Tip, selecting the Blue function immediately takes you to Blend mode, see later.
What do the functions do?
Red ‘on’
This means your Three2one will always step through all three inputs, even if an instrument is not
plugged into input 3, the Red input.
Tip... if you like to count switch presses rather than look at the light, then this mode is ideal for you.
Green ‘on’
This adds a mute to the guitar selection sequence so the new sequence will be Blue, Green, Red,
Mute, Blue, Green, Red, Mute; and so on.
This also applies to the two-guitar setup which will then be Blue, Green, Mute, Blue, Green, Mute;
and so on.
Blue ‘off’
Blue will always be on in the standard modes, but turning it off allows you to blend between the
guitars which have the amplifier/ buffer in the signal path.
This allows two or three guitars to be played at the same time though the Three2one, it will blend
them together with the volume controls as balance controls.
When in Blend Mode the foot switch will cycle through all the combinations of the three inputs.
This setting will not be memorised by Three2one so it won’t affect any of your other settings.
Experiment and have fun; even line level devices such as drum machines or keyboards can be
blended with your guitars.
You can exit back to normal mode, at any time, by simply removing and reconnecting the power.
