GeoVision GV-CS1320 Manual de usuario
GV-CS1320 Camera Access Controller
Quick Start Guide
CS1320V211-Q-G-A
Thank you for purchasing GV-CS1320 Camera Access Controller. This guide is designed to assist the new
user in getting immediate results from the controllers. For advanced information on how to use GV-CS1320,
please refer to GV-CS1320 Camera Access Controller User's Manual on Software CD / DVD.
© 2017 GeoVision, Inc. All rights reserved.
Under the copyright laws, this manual may not be copied, in whole or in part,
without the written consent of GeoVision.
Every effort has been made to ensure that the information in this manual is
accurate. GeoVision, Inc. makes no expressed or implied warranty of any kind
and assumes no responsibility for errors or omissions. No liability is assumed
for incidental or consequential damages arising from the use of the information
or products contained herein. Features and specifications are subject to
change without notice.
Note: No memory card slot or local storage function for Argentina.
GeoVision, Inc.
9F, No. 246, Sec. 1, Neihu Rd.,
Neihu District, Taipei, Taiwan
Tel: +886-2-8797-8377
Fax: +886-2-8797-8335
http://www.geovision.com.tw
Trademarks used in this manual: GeoVision, the GeoVision logo and GV
series products are trademarks of GeoVision, Inc. Windows is the registered
trademark of Microsoft Corporation.
November 2017
Contents
Installation Considerations ..................................................................ii
Optional Accessories ..........................................................................iii
1. Introduction ....................................................................................1
1.1 Packing List ........................................................................................................... 2
1.2 Compatible Software Versions............................................................................... 3
1.3 Overview................................................................................................................ 4
2. Installation ......................................................................................6
3. Connecting the Camera .................................................................8
3.1 Connecting RS485 Readers .................................................................................. 8
3.2 Connecting Network Readers ................................................................................ 9
3.3 Connecting Input Devices .....................................................................................10
3.4 Connecting Output Devices ..................................................................................11
3.5 Connecting GV-CS1320 to PC..............................................................................12
3.6 Connecting the Power...........................................................................................14
4. Accessing the GV-Fisheye Camera.............................................15
4.1 Web Browser ........................................................................................................15
4.2 Looking Up the Dynamic IP Address.....................................................................16
4.3 Configuring the IP Address ...................................................................................18
5. The Web Interface.........................................................................20
6. Upgrading System Firmware .......................................................21
i
7. Restoring to Factory Default........................................................22
Installation Considerations
To make sure the finger and face of the cardholder can be detected, follow the instructions
below to set up GV-CS1320.
Bell Button Recognition:
The bell button cannot be responded with gloves on.
Installation Height:
When placed at a building gate, GV-CS1320 should be about 1.4-1.5 meters above the
ground.
When placed at a parking lot gate, GV-CS1320 should be about 1.2 meters above the
ground to match the height of vehicles.
Face Detection Limitations
GV-CS1320 cannot detect the face of cardholders wearing facial masks or sunglasses.
GV-CS1320 is designed to detect front-view faces only. If the face is slightly tilted
horizontally or vertically, the tilt angle cannot exceed 15° degree.
Lighting Conditions
Avoid placing GV-CS1320 where the light source is directly behind the subject.
ii
Prevent light from directly falling onto the GV-CS1320’s camera lens.
Optional Accessories
Optional devices can expand the capabilities and versatility of your GV-CS1320. Contact your
dealer for more information.
Name Details
GV-Reader 1352 V2 GV-Reader 1352 V2 is a card reader that uses a 13.56 MHz
frequency. It has both Wiegand and RS-485 outputs that can
be connected to any standard access control panel.
GV-RK1352 GV-RK1352 is a card reader with keypad that uses a 13.56
MHz frequency. The reader has both Wiegand and RS-485
outputs that can be connected to any standard access control
panel.
GV-R1352 GV-R1352 is a card reader that uses a 13.56 MHz frequency.
The reader has both Wiegand and RS-485 outputs that can
be connected to any standard access control panel.
GV-DFR1352 GV-DFR1352 is a card reader that uses a 13.56 MHz
frequency. The reader has both Wiegand and RS-485
outputs that can be connected to any standard access control
panel.
GV-GF Fingerprint
Readers
GV-CS1320 is compatible with GV-GF1921 / 1922. The
reader supports three operation modes: Fingerprint Only,
Fingerprint + Card and Card Only. In Fingerprint Only mode,
the fingerprints are enrolled through GV-ASManager. In
Fingerprint + Card mode, the fingerprint templates are stored
on the user card. In Card Only mode, the users only need to
swipe the card to be granted access. Readers with optical
and capacitance sensors are available.
GV-FR2020 GV-FR2020 is a face recognition reader that uses a 13.56
MHz frequency. The reader supports two operation modes:
Face Recognition and Card. In Face Recognition mode, the
user data are distributed through GV-ASManager to the
assigned reader where the face templates are stored. In
Card mode, the users must first have an ID number enrolled
using GV-ASManager connected with the reader.
iii
iv
Name Details
GV-CR420 GV-CR420 is a card reader with a built-in 4MP wide angle IP
camera. The card reader recognizes identification cards and
transmits live view through network connection.
Push Button Switch The push button switch can be integrated with access control
system, allowing door exit by momentarily activating or
deactivating the electric locking device. Both American
standard and European standard push buttons are available.
GV-IB25 / 65 / 85 Infrared
Button
The GV-IB25 / 65 / 85 Infrared Button detects infrared
movement within 3 to 12 cm and allows you to open the door
with a wave of hand.
Electric Lock Three types of electric locks are available: electromagnetic
lock, electric bolt and electric strike.
GV-AS ID Card & GV-AS
ID Tag
GV-AS ID Cards and GV-AS ID Tags are ideal for business
and residential environment, where access control is
important for security reasons. 13.56 MHz cards and tags are
available.
Power Adapter Contact your sales representative for the countries and areas
supported.
GV-I/O Box 4 Ports V1.2 A small but capable device, the GV-I/O Box 4 Ports V1.2
provides 4 inputs and 4 relay outputs. It supports both DC
and AC output voltages, and provides a USB port for PC
connection.
Introduction
1
1. Introduction
Welcome to the GV-CS1320 Camera Access Controller Quick Start Guide. In the following
sections, you will learn the basic installations and configurations of GV-CS1320. For a
detailed user manual, see the GV-CS1320 Camera Access Controller User’s Manual on the
Software DVD.
1
1.1 Packing List
GV-CS1320
Mounting Plate
Standard Screw x 2
Plastic Screw Anchor x 2
Security Tube
Torx Wrench
Silica Gel Bag
Software DVD
Micro SD Card 2 GB
Warranty Card
2
8
1.3 System Requirements
To access the functions and settings of GV-CS1320 on the Web interface, ensure your PC
has good network connection and use one of the following web browsers:
•Internet Explorer 9 x or later
•Microsoft Edge
•Google Chrome
•Firefox
Note: For users of non-IE browsers, download GV-Web Viewer to access full functioning
user interface. See 3.1 Accessing Your Surveillance Images.
Compatible Software Versions
The GeoVision software versions compatible with GV-CS1320 are listed below.
GV-CS1320 Firmware Version
Software V1.0 V1.10 V1.11 V2.00 V2.11
GV-ASManager V4.3.5.0 V4.3.5.0
V4.4.0.0 V4.4.2.0
V4.4.3.0 V5.0.0.0 V5.0.1.0
GV-VMS V15.10 V15.11 V16.10.3 V16.11.0.0
GV-System (DVR/NVR) V8.6.2.0 with Patch
GV-Control Center V3.3.0.0 with Patch
GV-Failover Server V1.1.0.0 with Patch
GV-Redundant Server V1.1.0.0 with Patch
GV-GIS V3.1.1.0 with Patch
GV-Recording Server V1.2.5.0 with Patch
GV-Edge Recording
Manager V1.1.0.0 with
Patch V1.2.0.0
1.3 Overview
No. Name Function
1 Lens Receives image.
2 Microphone Receives sound from GV-CS1320.
3 Card Reader Reads ID cards or ID tags.
4 IR LEDs Automatically illuminates for night time use.
5 Speaker Talks to the surveillance area from the local computer.
6 Touch pad and LED
status
Touch to activate the talk mode. See the LED and Beeper
Status below.
7 Default Button Resets all configurations to default factory settings. See 7
Restoring to Factory Default.
8 Power Cable Connects to power supply. See 3.6 Connecting the Power.
9 Ethernet Port Connects to network and power supply. See 3.5 Connecting
GV-CS1320 to PC.
4
Otros manuales para GV-CS1320
3
Tabla de contenidos
Otros manuales de Controladores de acceso IP de GeoVision
GeoVision
GeoVision GV-CS1320 Manual de usuario
GeoVision
GeoVision GV-FR Manual de usuario
GeoVision
GeoVision GV-QR1352 Manual de usuario
GeoVision
GeoVision GV-FR2020 Manual de usuario
GeoVision
GeoVision GV-FR Manual de usuario
GeoVision
GeoVision GV-CS1320 Manual de usuario
GeoVision
GeoVision GV-Reader 1251 Manual de usuario
GeoVision
GeoVision GV-FWC Manual de usuario
