Geko Orbit 110 Manual del propietario
DASH CAMERA Orbit 110
Quick User Manual
Disclaimer
1.Please follow the set-up and usage instructions in the print material that came with this Dashboard
Camera (dash cam) product.
2.You should not set/install this dash cam at a place that would obstruct or reduce a driver’s view; make
sure your usage comply with pertinent vehicle codes of your state, province, territory or country.
3.You should post the required notices of recordation to occupants inside the vehicle, if voices or other
information/signal pertaining to in-vehicle activities will be recorded.
4.You should not change the dash cam’s setting or mode of operation or when the vehicle is in motion.
5.The optional driving warning signals, including any visual or audible reminding signals, should not
replace your decision-making and judgment that are needed for the proper operation of the vehicle.
6.You should not leave the dash cam in a visible spot when no one is inside the vehicle, to avoid
attracting break-ins to steal the unit, or other property.
7.You should avoid extended exposure of the dash cam to direct sunlight or extreme temperatures
(either high or low temperature) which tend to degrade or damage the unit and its normal functionality.
8.You should examine, check and/or verify the dash cam at least every six (6) months, including the
associated memory cards, to ensure the video reception and recording are working properly. For each
use, you should verify that the dash cam unit, the visible lights and the audible sounds are working
normally. If there are signs of non-operation or mal-function, you should immediately seek to replace the
product and check to see if the product is covered under any applicable warranty.
9.The dash cam unit may have additional functionality, such as transmission and recordation of audible
or GPS signal or other identification information. If you have privacy concerns about these functions,
make sure you follow the instruction to disable these functions.
10.You should use the dash cam unit in the way it is intended. You should not use the dash cam unit in a
way that would be illegal or that tends to physically damage the unit, or tends to cause danger to the
safe operation of the vehicle or the occupants.
Thank You!
Product Overview
Package Contents
Thank you for purchasing the Orbit 110 dash camera.
This user manual contains technical specifications and instructions for use, operate, and
install. Please read this manual carefully before using.
This product is a high-definition digital video camera, with high-quality digital audio &
video, and USB charging function.
Orbit 110 Dash Cam
Car Charger
USB Cable
Car Suction Mount
8G Micro SD Card
User Manual and Warranty Card
Product Features
Product Button Function Instruction
1.Mini DVR, 120 degree grade A+ high resolution ultra-wide angle lens
2.Built-in lithium battery can be charged while video recording function
3.Seamless video
4.1.5 inch TFT LCD
5.Built-in Mic/Speaker
6.Support Micro SD card up to 32GB
7.Motion Detection
8.SOS file locking function
9.Loop recording, Time and Date Stamp
10.Parking Mode
Buttons and socket
1.Micro SD Card Slot 2. Speaker
3. Bracket Slot 4. Lens
5. Mini USB Slot 6. Up Button
7. Indicator LED 8. Menu Button
9. Down Button 10. LCD Screen
11. OK /REC 12. Mode/Lock
13. Power button 14. Power LED
Where to Install Your Dash Cam
Settings
POWER LED:
Red - Indicates there is power supplied
INDICATOR LED:
Blue - Flashing indicates recording
Mode/Lock:
Recording Mode: Lock emergency recording
Preview Mode: Return recording mode
Playback Mode: Return preview mode
Up Button:
Preview Mode: Toggle to previous file
Playback Mode: Toggle to previous file
Down Button:
Preview Mode: Toggle to next file
Battery Charge
Micro SD Card Insert and Removal
Caution
Playback Mode: Toggle to next file
OK :
Recording Mode: Start Recording / Standby
Setting Model: OK
Menu Button:
Video Mode: Enter in setting menu
Playback Mode: Delete/Lock/Unlock Menu
Reset:
If the device fails to operate, try resetting the device. Press the reset button using a fine pen
or paperclip.
Power: Press and hold the power button for 3 seconds to turn on; Press and hold for 5
seconds to turn off.
1)Directly connect the car charger with charging cable in USB interface of the device.
2)USB charging, use the USB cable and connect it to the computer
1.Insert the Micro SD card into the Micro SD card slot on the dash cam.
2.To take out the Micro SD card, please gently press down the Micro SD card and it should
pop out of the slot.
3.Please pay attention to the direction of the Micro SD card when inserting.
4.If the device and Micro SD card is incompatible, please insert different Micro SD card to
try again.
5.Please use a high-speed Micro SD card (Class6 or above).
Video Recording Settings
General Settings
In standby mode, press the Menu button to enter in to video settings, then press the
Up/Down button to choose the menu you want. Press the OK button to confirm.
1.Video Resolution: FHD 1080P / HD 720P
2.Loop Recording ：Off / 1 Minute/ 2Minutes / 3 Minutes/ 5 Minutes
3.Exposure: +2.0 / +1 / 0 / -1 / -2
4.Motion Detection: Off / On
5.Date Stamp: Off / On
6.Record Audio : Off / On
7.G-Sensor : Off / High / Medium / Low
1.Parking Mode : Off / On
2.Date/Time: YY/MM/DD
3.Auto Power Off : Off / 1 Minutes / 3 Minutes
4.Screen Saver : Off / 3 Minutes / 5 Minutes / 10 Minutes
5.Beep Sound: Off / On
6.Language: English/Français/Deutsch/Spanish/Chinese/Italian/Japanese/Korean
7.Frequency: 50Hz / 60Hz
8.Format SD Card: Cancel / OK
9.Default Setting: Cancel / OK
10.Version info
In standby mode, press the Menu button repeatedly to enter in to general settings, then
press the Up/Down button to choose the menu you want. Press the OK button to confirm.
Recording:
Playback Mode
Connecting to a PC
When connected to a car charger, the device automatically goes into record mode and
starts recording, the ● icon will display on the screen.
A flashing red dot ● icon flash indicates that the device is recording. To stop recording,
Press OK button and the red dot disappears, indicating that the recording has stopped.
If you want to protect the current recordings, then press the Mode/Lock button, the
emergency icon will appear on the screen, this indicates that those recordings have been
locked and will not be overwritten by new video clips.
In Standby mode, press the Mode/Lock button repeatedly to enter Playback mode. The
device stores video on the Micro SD Card. Playback mode will allow you to review the
saved video and play back the video with sound.
If you wish to delete or protect the file, press the OK button to access the playback setting
menu.
The Orbit 110 can be connected to a PC by using a USB data cable. The supplied USB
cable is for charging and supplying power only. When the device is connected to the PC,
mass storage is displayed on the device’s screen. You can view the Micro SD card content
on the PC. When the device is detected on the PC as an external drive, select the DCIM
folder to view. Recordings and images will be saved in the same folders.
The emergency recording files will have a lock icon on the thumbnail of the file.
Note
Specifications
●Improper operation will cause the device to crash. If the dash cam crashes, press the reset
button to resume the camera.
●Don’t leave the camera in direct sunlight or where the temperature could go above 60
degrees Celsius or 140 degrees Fahrenheit for a long period of time.
Need more information? Visit our website via www.mygekogear.com
additional questions.
LCD Screen
1.5” TFT LCD screen
Video Resoluon
FHD 1920X1080
Lens
120 degree wide angle
Languages
English/ Français / Spanish / Chinese simplified/ Chinese tradional
Photo Format
JPEG
Video Format
AVI
Moon Detecon
YES
G-sensor
YES
Loop Recording
YES
USB Interface
USB 2.0
Working Temperature 0°C~60°C/ 32°F~140°F
Storage Temperature -10°C~70°C / 14 °F ~158 °F
Memory card Micro SD card up to 32GB, Class 6 or above
Power 5V/1.0A
Baery Capacity Li-baery 110mAh
Tabla de contenidos
Idiomas:
Otros manuales de Cámara de salpicadero de Geko
