GE IO61X-BAT-KIT Manual de usuario
GE
Measurement and Control
© 2015 General Electric Company. All Rights Reserved. Specifications are
subject to change without notice. GE is a registered trademark of General
Electric Company. Other company or product names mentioned in this
document may be trademarks or registered trademarks of their respective
companies, which are not affiliated with GE.
IO61X-BAT-KIT
Li-ion Battery and Adaptors for DPI611/2
Safety and Quick Start Guide –109M7337 Rev -
Safety and Quick Start Guide IO61X-BAT-KIT
Page 2of 11 [EN] English –109M7337 Rev -
Battery Specification
Technology / Configuration Lithium Ion / 1S2P
Nominal Voltage: 3.7V
Nominal Capacity: 3800mAh
Minimum Capacity: 3610mAh
Charge Temperature Range : 0°C to +45°C
Discharge Temperature Range: -10°C to +60°C
Storage Temperatures: 12 months: -20°C to +20°C
3 months: -20°C to +45°C
1 month: -20°C to +60°C
Charge Voltage: 4.20V
Maximum Charge Current: 2000mA
Maximum Discharge Current: 2000mA
Battery Cradle Specification
Technology: Lithium Ion Battery Charger
Operating DC Input Voltage: 5Vdc
Operating DC Input Current : 540mA (nominal)
Typical Charge Voltage: 4.20V (± < 1%)
Nominal Charge Current: 540mA
Typical Output Voltage: 9.00V
Operating Temperature: -20°C to +60°C
Safety and Quick Start Guide IO61X-BAT-KIT
Page 3of 11 [EN] English –109M7337 Rev -
GENERAL WARNINGS
Before using this instrument, read and understand the “Safety” section the
DPI611 or DPI612 user manual and the instructions for the accessories /
options / equipment you are using it with.
Read and understand the applicable local safety procedures.
It is dangerous to ignore the specified warnings.
It is dangerous to ignore the specified limits for the instrument or to use
the instrument when it is not in its normal condition. Use the applicable
protection and obey all safety precautions.
Do not use the instrument in locations with explosive gas, vapour or dust.
There is a risk of an explosion.
Do not use damaged equipment and use only original parts supplied by
the manufacturer.
CC3800GE Li-ion RECHARGEABLE BATTERY WARNINGS
Do not disassemble or modify the battery pack. The battery pack can leak
electrolyte, overheat, emit smoke, burst and/or ignite.
Do not short-circuit the battery.
Do not transport or store the battery pack together with metal objects.
If short-circuiting occurs, over-current will flow, causing the battery pack
to leak electrolyte, overheat, emit smoke, burst and/or ignite.
Do not discard the battery pack into fire or heat it.
Do not expose cells or batteries to heat or fire. Do not Store in direct
sunlight.
Do not use or leave the battery pack near a heat source (+80ºC or higher).
Do not immerse the battery pack in water. Do not allow it to get wet.
Do not recharge the battery pack near fire or in extremely hot weather.
To recharge the battery use the DPI611 and DPI612 internal charging
function or the CX6100GE desktop charger. Do not use any other charger.
Do not subject the battery pack to mechanical shock.
Do not use an apparently damaged or deformed battery pack.
Do not directly solder the battery pack.
Safety and Quick Start Guide IO61X-BAT-KIT
Page 4of 11 [EN] English –109M7337 Rev -
Do not reverse the positive (+) and negative (-) terminals. Otherwise, during
recharging, the battery pack will be reverse-charged, abnormal chemical
reactions may then occur, or excessively high current can flow during
discharging, leading to electrolyte leakage, overheating, smoke emission,
bursting and/or ignition.
Do not force the connection if you cannot easily connect the battery pack
terminals to the battery pack charger. Confirm that the terminals are
correctly oriented.
Do not use the battery pack for a purpose other than powering either
DPI611/DPI612 products.
Do not use any battery which is not designed for use with the equipment.
Do not connect the battery pack to any other electrical outlet, vehicle
cigarette lighter, etc.
Do not mix batteries of different manufacture, capacity, size or type within
the DPI611 or DPI612.
If recharging operation fails to complete even when a specified recharging
time has elapsed, immediately stop further recharging.
Do not put the battery pack into a microwave oven. Rapid heating or
disrupted sealing can lead to electrolyte leakage, overheating, smoke
emission, bursting and/or ignition.
If electrolyte leaks from the battery pack or gives off a bad odour, remove
it from any exposed flame. Otherwise, the leaking electrolyte may catch
fire and the battery pack may emit smoke, burst or ignite.
If the battery pack gives off an odour, generates heat, becomes
discoloured or deformed, or in any way appears abnormal during use,
recharging or storage, immediately remove it from the equipment or
battery pack charger and stop using it. Otherwise, the problematic battery
pack can develop electrolyte leakage, overheating, smoke emission,
bursting and/or ignition.
Remove the battery from the equipment when not in use.
Safety and Quick Start Guide IO61X-BAT-KIT
Page 5of 11 [EN] English –109M7337 Rev -
Do not remove the battery from its original packaging until required
for use.
Secondary batteries need to be charged before use. Always use the
correct charger and refer to the user manual for proper charging
instructions.
Do not leave a battery on prolonged charge when not in use.
After extended periods of storage, it may be necessary to charge and
discharge the battery several times to obtain maximum performance.
Do not subject the battery pack to intense sunlight or hot
temperatures, for example in a car during hot weather. Otherwise,
electrolyte leakage, overheating and/or smoke emission can occur.
Also, its guaranteed performance will be lost and/or its service life will
be shortened.
The battery pack incorporates built-in safety devices. Do not use it in a
location where static electricity is present.
The guaranteed recharging temperature range is 0°C to +45ºC. A
recharging operation outside this temperature range can lead to
electrolyte leakage and/or overheating of the battery pack and may
cause damage to it.
In the event of a cell leaking, do not allow the liquid to come in contact
with the skin or eyes. If contact has been made, wash the affected
area with copious amounts of water and seek medical advice.
Seek medical advice immediately if material or content from a battery
has been swallowed
Keep the battery out of the reach of children.
Keep batteries clean and dry.
Wipe the battery terminals with a clean dry cloth if they become dirty.
If you find rust, a bad odour, overheating and/or other irregularities
when using the battery pack for the first time, return it to your supplier
or vendor.
For further information contact the nearest distributor or
representative.
Retain the original product literature for future reference.
Safety and Quick Start Guide IO61X-BAT-KIT
Page 6of 11 [EN] English –109M7337 Rev -
50ABL001 RECHARGEABLE BATTERY CHARGER WARNINGS
Do not disassemble or modify the charger module or DC Power Supply.
The equipment is equipped with built-in safety/protection features. Should
these features be disabled, the battery pack under charge can leak
electrolyte, overheat, emit smoke, burst and/or ignite.
If recharging operation fails to complete even when a specified recharging
time has elapsed, immediately stop further recharging. Otherwise, battery
electrolyte leakage, overheating, smoke emission, bursting and/or ignition
can occur.
The equipment incorporates built-in safety devices. Do not use it in a
location where static electricity (greater than the manufacturer’s
guarantee) may be present. Otherwise, the safety devices can be
damaged, possibly leading to overheating, smoke emission, bursting
and/or ignition.
The guaranteed recharging temperature range is 10°C to +45ºC. A
recharging operation outside this temperature range can lead to battery
electrolyte leakage and/or overheating of the battery pack and may cause
damage to it.
Store the equipment in a location where children cannot reach it. Also,
make sure that a child does not take the battery pack out of the
equipment.
Before use, carefully study these Precautions. For further information
contact the nearest distributor or representative. Retain the original
product literature for future reference.
For recharging procedures, refer to the Operation Manual of your
DPI611/612 device.
Do not charge a battery if the battery displays rust, a bad odour,
overheating and/or other irregularities. If the battery is new, it must be
returned to the supplier or vendor.
Safety and Quick Start Guide IO61X-BAT-KIT
Page 7of 11 [EN] English –109M7337 Rev -
Parts List1.1
Figure 1 Content
Item
No.
Part
Number
Description
1
CC3800GE
BATTERY Li-ion 3V7 380OmAH
2
50ABL001
DPI611/DPI612 BATTERY CRADLE
3
IO620-PSU
MAINS ADAPTOR
4
109M9587
DPI611/612 RECHARGEABLE BATTERY COVER
ASSEMBLY
5
196-224
FOAM FOR DPI611/2 ALKALINE BATTERY
COMPATIBILITY
6
109M7337
QUICK START GUIDE
3
4
5
6
1
2
Safety and Quick Start Guide IO61X-BAT-KIT
Page 8of 11 [EN] English –109M7337 Rev -
Install Rechargeable Battery and Cradle in DPI611 Units1.2
1. Remove the battery cover by loosening the captive battery cover
fixing screw and lifting the cover upwards.
2. If fitted, remove the white battery holder by pulling straight up to
reveal charging cable. Keep this battery holder to keep
compatibility with dry cells.
3. Connect the charging cable to the mating connector on the back
of the rechargeable battery cradle. Do not force the connection,
verify the pin alignment.
4. Push the cradle firmly into the battery compartment.
5. Insert the rechargeable battery CC3800GE into the cradle.
6. Refit the battery cover. Close the battery compartment by
pressing the lugs inside the slots (A) and bring down the cover at
an angle, securing by tightening the fixing screw. (See Figure 2).
7. The battery can be charged by connecting the wall adapter to
the unit or by using the optional desk top charger.
Figure 2 Fit Rechargeable Battery Kit
Safety and Quick Start Guide IO61X-BAT-KIT
Page 9of 11 [EN] English –109M7337 Rev -
Install the rechargeable battery in DPI612 units.1.3
1. Remove the battery cover by unscrewing the retaining screw and
lifting the cover upwards.
2. Remove the old CC3800GE battery if fitted.
3. Insert the CC3800GE rechargeable battery into the compartment
as shown in Figure 3.
4. Refit the battery cover by locating the lugs of the cover (A) at an
angle into the slots and close the compartment as shown in
Figure 3.
5. Refit the battery cover retaining screw.
Figure 3 Fit Rechargeable Battery
Fit Rechargeable Battery Kit
Safety and Quick Start Guide IO61X-BAT-KIT
Page 10 of 11 [EN] English –109M7337 Rev -
Install Dry Cell Batteries1.4
1. Remove the battery cover by loosening the captive battery
cover fixing screw and lifting the cover upwards.
2. If the rechargeable battery has been fitted, remove it.
3. If the rechargeable battery cradle has been fitted, remove it by
gently pulling it straight up. Avoid touching the metal contacts
on the cradle. Note the cradle is attached to the unit with the
charging cable.
4. Disconnect the charging cable from the back of the cradle and
keep it loose in the small compartment then fit battery holder.
5. Fit the foam block to the battery cover.
6. Place the batteries in the battery compartment with the correct
+/–orientation. Incorrect Insertion of batteries can cause
battery failure.
7. Replace the battery cover by pressing the lugs inside the slots (A)
and bring down the cover, securing by tightening the fixing
screw. (See Figure 4).
Figure 4 Fit Dry Cell Batteries
Tabla de contenidos
Idiomas:
