Furuno FAX-410 Manual de usuario
この取扱説明書には本機を安全に使用していただくために必要な
注意事項、使用方法が記載されています。
本機を使用する前に、この取扱説明書をよく読んで、十分に理解
したうえで使用してください。
また、これらの書類はいつでも参照できるところに大切に保管
し、使用方法がわからなくなったときにお読みください。
ファクシミリ受画装置
FAX-410
PUB.NO. OMC-62610-A
(0601,YOSH) FAX-410
This manual is printed with
soy ink.
Busse-Yachtshop.de [email protected]
IMPORTANT NOTICE
• This manual is intended for use by native speakers of English.
• No part of this manual may be copied or reproduced without written permission.
• If this manual is lost or worn, contact your dealer about replacement.
• The contents of this manual and equipment specifications are subject to change without
notice.
• The example screens (or illustrations) shown in this manual may not match the screens
you see on your display. The screen you see depends on your system configuration and
equipment settings.
• FURUNO will assume no responsibility for the damage caused by improper use or
modification of the equipment or claims of loss of profit by a third party.
• Store this manual in a convenient place for future reference.
Busse-Yachtshop.de [email protected]
SAFETY INSTRUCTIONS
WARNING
Do not open the equipment except to
replace paper.
Only qualified personnel should work
inside the equipment.
Immediately turn off the power at the
switchboard if water leaks into the
equipment or something is dropped
into the equipment.
Continued use of the equipment can cause
fire or electrical shock. Contact a FURUNO
agent for service.
Do not disassemble or modify the
equipment.
Fire, electrical shock or serious injury can
result.
Do not place liquid-filled containers on
the top of the equipment.
Fire or electrical shock can result if a liquid
spills into the equipment.
Immediately turn off the power at the
switchboard if the equipment is emitting
smoke or fire.
Continued use of the equipment can cause
fire or electrical shock. Contact a FURUNO
agent for service.
Make sure no rain or water splash leaks
into the equipment.
Fire or electrical shock can result if water
leaks in the equipment.
Safety Instructions for the Operator
CAUTION
Do not use commercial cleaners to
clean the main unit.
Commercial cleaners may remove paint
and markings. Remove dust from the main
unit with a soft cloth. For stubborn dirt, use
water-diluted mild detergent and a soft
cloth.
Be careful not to catch fingers between
upper lid and chassis when changing
recording paper.
Injury may result.
WARNING
Use the proper fuse.
Use of a wrong fuse can result in damage
to the equipment or cause fire.
Handle the LCD with great care. Strong
shock may break it.
If the LCD breaks, LCD liquid may leak out.
Do not swallow or touch the liquid - it is
toxic if swallowed. If it is swallowed or
contacts eyes, rinse the contacted area
thoroughly with water and contact a
physician immediately.
Dispose of the main unit according to
appropriate regulations.
The main unit contains a battery. It should
also be disposed of according to
appropriate regulations.
The power supply shall conform to
the recommended rating.
Fire or electrical shock may result if an
improper power supply is used.
Busse-Yachtshop.de [email protected]
Safety Instructions for the Operator (con't)
WARNING
To avoid electrical shock, do not
remove cover. No user-serviceable
parts inside.
WARNING LABEL
A warning label is attached to the main unit.
Do not remove the label. If the label is missing or
damaged, contact a FURUNO agent or dealer
about replacement.
Name: Warning Label 1
Type: 86-003-1011-1
Code No.: 100-236-231
Safety Instructions for the Installer
CAUTION
Observe the following compass safe
distances to prevent interference to a
compass:
Do not install the main unit in direct
sunlight or where it may be subjected
to vibration or shock.
Inappropriate mounting location may affect
performance or damage the unit.
Magnetic Steering
compass compass
1.0 m 0.7 m
Main unit
Securely attach protective
earth to the ship's body.
The protective earth is required
to the power supply to prevent
electrical shock.
WARNING
Busse-Yachtshop.de [email protected]
i
Page
1. OUTLINE ・・・・・ ・・・・・・・・・・・・・・・・・・・・・・・・・・・・・・・・ 1
1.1 Characteristics ・・・・・・・・・・・・・・・・・・・・・・・・・・・・・ 1
1.2 List of Standard Components ・・・・・・・・・・・・・・・・・・・・・ 2
1.3 System Components ・・・・・・・・・・・・・・・・・・・・・・・・・・・・ 3
2. OPERATION
2.1 Description of key ・・・・・・・・・・・・・・・・・・・・・・・・・・・ 4
2.2 Contrast and brightness ・・・・・・・・・・・・・・・・・・・・・・・・ 7
2.3 Basic operation ・・・・・・・・・・・・・・・・・・・・・・・・・・・・ 7
2.3.1 Channel setting ・・・・・・・・・・・・・・・・・・・・・・・・・・・ 7
2.3.2 Fine-adjustment of frequency,
and selection of a desired frequency ・・・・・・・・・・・・・・ 7
2.3.3 Start and stop of recording ・・・・・・・・・・・・・・・・・・・ 8
2.3.4 Manual phasing ・・・・・・・・・・・・・・・・・・・・・・・・・・・ 8
2.3.5 Synchronization ・・・・・・・・・・・・・・・・・・・・・・・・・・・ 8
2.3.6 Selection of reception mode ・・・・・・・・・・・・・・・・・・・・ 9
2.3.7 Timer release and release of key lock in the timer mode ・・ 9
2.4 Description of setting mode ・・・・・・・・・・・・・・・・・・・・・ 10
2.4.1 Switching of receiver (audio) ・・・・・・・・・・・・・・・・・・ 10
2.4.2 Setting of timer reception ・・・・・・・・・・・・・・・・・・・・・ 11
2.4.3 Sleep timer setting ・・・・・・・・・・・・・・・・・・・・・・・・・ 12
2.4.4 Registration of new frequency ・・・・・・・・・・・・・・・・・・・ 13
2.4.5 Time setting ・・・・・・・・・・・・・・・・・・・・・・・・・・・・・ 14
2.4.6 Setting of ISB frequency ・・・・・・・・・・・・・・・・・・・・・・ 15
2.4.7 Adjustment of contrast ・・・・・・・・・・・・・・・・・・・・・・・ 15
2.4.8 RAM clearance function ・・・・・・・・・・・・・・・・・・・・・・・ 16
2.4.9 Attention at the time of operation ・・・・・・・・・・・・・・・・ 16
2.5 Operation with external receiver ・・・・・・・・・・・・・・・・・・ 17
3. MAINTENANCE
3.1 Back-up battery ・・・・・・・・・・・・・・・・・・・・・・・・・・・・ 18
3.2 Lubrication and Cleaning
・・・・・・・・・・・・・・・・・・・・・・・ 18
4. INSTALLATION
4.1 Main unit ・・・・・・・・・・・・・・・・・・・・・・・・・・・・・・・・・ 19
4.2 Wiring ・・・・・・・・・・・・・・・・ ・・・・・・・・・・・・・・・・・・・ 20
4.2.1 DC power supply built-in type ・・・・・・・・・・・・・・・ 20
4.2.2 AC power supply built-in type ・・・・・・・・・・・・・・・ 20
4.3 Terminal board ・・・・・・・・・・・・・・・・・・・・・・・・・・・・・ 21
4.3.1 Connection of BK ・・・・・・・・・・・・・・・・・・・・・・・・ 21
4.3.2 Connection with external receiver ・・・・・・・・・・・・・ 21
4.4 Grounding ・・・・・・・・・・・・・・・・・・・・・・・・・・・・・・・・ 22
4.5 Receiving antenna ・・・・・・・・・・・・・・・・・・・・・・・・・・・ 22
CONTENTS
Busse-Yachtshop.de [email protected]
ii
4.6 Exchange of a recording paper ・・・・・・・・・・・・・・・・・・・ 23
5. SPECIFICATIONS ・・・・・・・・・・・・・・・・・・・・・・・・・・・・・・・・ SP-1
5.1 Receiver ・・・・・・・・・・・・・・・・・・・・・・・・・・・・・・・・・・ SP-1
5.2 Recorder ・・・・・・・・・・・・・・・・・・・・・・・・・・・・・・・・・ SP-1
5.3 Automatic Control ・・・・・・・・・・・・・・・・・・・・・・・・・・・・ SP-1
5.4 Power, Dimension ＆ Weight ・・・・・・・・・・・・・・・・・・・・・・ SP-1
APPENDIX
TABLE OF FACSIMILLE STATION
Area map of existing stations ・・・・・・・・・・・・・・・・・・・・・・ SP-2
Facsimile station table
・・・・・・・・・・・・・・・・・・・・・・・・・・ SP-3
PACKING LIST ・・・・・・・・・・・・・・・・・・・・・・・・・・・・・・・・・ A-1～2
Outside view ・・・・・・・・・・・・・・・・・・・・・・・・・・・・・・・・・・・D-1
Layout diagram ・・・・・・・・・・・・・・・・・・・・・・・・・・・・・・・・・ D-2
Busse-Yachtshop.de [email protected]
1
１．OUT LINE
FAX-410 is the high sensitive weather facsimile receiver using electronic scanning
thermal head recording system.
１．１ Characteristics
(1) Electronic scanning with thermal head recording system provides clear image, quiet
operation.
(2) Pre-programmed all existing weather facsimile stations in the world. Vacant
channels for new station are provided, and rewriting of the memory data is possible
for changing frequency of existing station.
(3) 9-tones gradation recording function provides clear and detailed weather photo from
satellite.
(4) Timer programming function up to 16 programs in a week provides operation free
for reception of each program.
(5) ISB shift function is equipped for corresponding to simultaneous broadcasting of
fax/teletype by a multiple method of SSB by the station of the U.S. Marines
management to which the frequency irregularly changes by 1-2kHz.
(6) Possible to record the data receiving signal from external receiver.
(7) Automatic start/stop circuit is equipped in accordance with WMO standard.
(8) Easy operation by automatic selection of phase matching and recording speed.
Busse-Yachtshop.de [email protected]
2
１．２ List of Standard Components
Facsimile receiver. List of Standard Components
Standard Components
Name Model nam
e/Code No.
Q’ty Remarks
Main unit FAX-410 1 set AC Power supply or DC Power supply
Installation materials 1
Accessories 1 set
Spare parts
1 set
Installation materials
Name Model nam
e/Code No.
Q’ty Remarks
Grounding wire 343200G01 2ｍWith terminal
Coaxial connector M207-P 2 For Antenna cable
Self-tapping screw M5×25
4 Clamp for Main unit
Flat washer M6 5 Adjust to Clamp for Main unit
Accessories
Name Model nam
e/Code No.
Q’ty Remarks
Recording paper F220VP 1 257mm×30m
Operator’s Manual 1
Spare parts（AC Power supply）
Name Model nam
e/Code No.
Q’ty Remarks
Fuse ST4-2AN1
4 250VAC2A
Spare parts（DC Power supply）
Name Model nam
e/Code No.
Q’ty Remarks
Fuse ST6-7A
4 125VAC7A
Busse-Yachtshop.de [email protected]
3
１．３ System Components
2.6m Whip antenna
Main unit
A
ntenna
coupler,fax-5
To BK line
To Grounding wire
To Power supply Coaxial cable
Busse-Yachtshop.de [email protected]
Otros manuales para FAX-410
3
Este manual sirve para los siguientes modelos
2
Tabla de contenidos
Otros manuales de Máquina de fax de Furuno
Furuno
Furuno FAX-207 Manual de usuario
Furuno
Furuno FAX-30 Manual de usuario
Furuno
Furuno PFX-50 Manual de usuario
Furuno
Furuno FAX-410 Manual de usuario
Furuno
Furuno FAX-408 Manual de usuario
Furuno
Furuno FAX-30 Manual de usuario
Furuno
Furuno DFAX FAX-208/A/N Manual de usuario
Furuno
Furuno FAX-410 Manual de usuario
Furuno
Furuno FAX-207 Manual de usuario
Furuno
Furuno FAX-30 Manual
