FUNAI ZV427FX4 Manual de usuario
Funai ZV427FX4 DVD/VCR Dubbing Unit
Quick Start Guide
ATTENTION!
You must purchase DVD-R
or DVD-RW discs to use
with this unit.
DVD+R and DVD+RW discs
are NOT SUPPORTED.
Funai ZV427FX4 DVD Recorder/VCR with Line-In Recording
The Funai ZV427FX4 allows you to record:
-from VHS to DVD-R/DVD-RW
-from DVD-R/DVD-RW to VHS
NOTE: DVD+R/DVD+RW discs are NOT SUPPORTED by this player.
1. Plugging in the Recorder to your TV
To begin, locate your TV’s “Line In” jack. First you need to determine what kind of connecon
your TV has. The Funai ZV427FX4 has both HDMI and composite connecons.
Now, connect the cable to your ‘Composite In’ or ‘HDMI In’ jack on your TV, then connect to
either the HDMI Out (labeled below le) or the Composite Out (labeled below right) on the
recorder. Also, plug in the recorder’s power plug to a grounded wall socket.
Once these steps are complete, turn to the next page to begin the process.
HDMI cable and port Composite cables and ports
HDMI Port
Component/Composite Ports
Funai ZV427FX4 DVD Recorder/VCR with Line-In Recording
Now you must rst nd the correct input of your TV/receiver.
If you have an HDMI cable connected from the unit to your TV, the [INPUT] or [SOURCE]
buon will allow you to select the HDMI input that you need.
NOTE: This most likely will be [HDMI 1] or [HDMI 2].
The chart shown below (also included in the User’s Manual) outlines the most likely buons
your TV or remote might have to switch the input/source.
If you are having trouble nding how
to change your TV’s source input,
nd your TV’s brand in the list to the
right and try looking for that buon
on your TV (or on your TV’s remote).
Funai ZV427FX4 DVD Recorder/VCR with Line-In Recording
2. Turn on the recorder and load media
To start the Funai ZV427FX4, either press the unit’s [POWER] buon (pictured below le) or,
while poinng the remote at the unit, press the remote’s [STANDBY-ON] buon (pictured be-
low right).
Once the power buon has been pressed, you should see a blue screen with a “DVD” logo in
the background. Once at this screen, it’s me to load your DVD and VHS media.
Noce that the machine says ‘LOAD’ on the front display. This means it is waing for a disc to
be recorded to/from.
Press the Open/Close buon to eject the tray. Now Insert either a blank DVD-R/DVD-RW disc
or the DVD you wish to record from, label side up.
Now insert the cassee tape, front label facing you, into the VCR poron of the unit.
It should automacally start pulling the tape into the unit, at which point release your grip
and it will load properly.
Now that you have both a DVD-R/DVD-RW and VHS media inserted, it’s me to choose your
task.
Power Buon
Standby-On Buon
Funai ZV427FX4 DVD Recorder/VCR with Line-In Recording
3. Choose your recording mode and begin
Once you have both the DVD and VHS media inserted, pick up the unit’s remote control and
press [SETUP].
In the setup menu, you’ll see four opons. Select
[General Seng].
In the [General Seng] menu, select [Recording].
In the [Recording] menu, select the boom
lisng: [Dubbing Mode].
NOTE:
To record from VHS to DVD, follow steps marked (A).
To record from DVD to VHS, follow steps marked (B).
Funai ZV427FX4 DVD Recorder/VCR with Line-In Recording
4(A): Recording from VHS to DVD
To begin copying your VHS tape to DVD, rst you
must select the correct dubbing mode from the
list. Select [VCR -> DVD].
Then press [SETUP] to exit.
Now press [DVD] on the remote. At this point,
you should see the indicator light on the front of the Funai Unit switch from VCR mode to
DVD mode, shown below.
NOTE: If you don’t see the video mode switch to DVD (above), press [DVD] unl you do.
NOTE: The screen will remain blank aer pressing [DVD]. This is normal.
Now, press [REC MODE] repeatedly unl
the desired recording mode is set.
A chart explaining the specics of the re-
cording modes is at the right. If you are
unsure which recording mode to use,
press [REC MODE] unl [SP] is selected.
Funai ZV427FX4 DVD Recorder/VCR with Line-In Recording
5(A): Recording from VHS to DVD
Press [VCR], then press PLAY [ ] to nd the point where
you want to begin recording.
Press PAUSE [ ] when you come to a good starng point
for recording.
Finally, press [D. DUBBING].
You should now see the video start playing…
which means you have successfully started recording!
When you reach the point on the VHS at which you want
to stop recording, press the STOP buon [ ].
NOTE: The disc MUST BE FINALIZED in order to be playable. To do this, turn to page 6(A) now.
PLAY Buon
PAUSE Buon
D. DUBBING Buon
STOP Buon
Funai ZV427FX4 DVD Recorder/VCR with Line-In Recording
6(A): Finalizing Your Recorded Disc
To begin nalizing your disc, press [SETUP], then
navigate down to the [DVD MENU] lisng and se-
lect it.
Use the arrows to select [Finalize] then press
[OK].
Use the arrows to select [Yes], then press [OK].
At this point it will begin nalizing your disc. Finalizing your disc may take several minutes or
up to an hour, depending how much content and in which mode you have recorded.
Once the nalizaon process is complete, your disc is ready to eject and play in other DVD-
compable players!
Simply press the [Open/Close] Buon to eject the DVD, and the [STOP/EJECT] buon to eject
your cassee tape. Thanks for being a Northbrook patron, and we hope you’ve enjoyed mak-
ing use of our DVD VHS Recorder Units!
Funai ZV427FX4 DVD Recorder/VCR with Line-In Recording
4(B): Recording from DVD to VHS
To begin the process of copying your DVD to a
VHS tape, rst you must select the correct dub-
bing mode from the list. Select [DVD -> VCR].
Then press [SETUP] to exit.
Now press [VCR] on the remote, then press [REC MODE] repeatedly unl the desired record-
ing mode is set.
NOTE: At this point, rewind or fast-forward the tape to the point which you want to start re-
cording at. Pre-exisng media on the VHS will be overwrien from this point.
Press [DVD], then press PLAY [ ] to nd the point where you want to begin recording.
Press PAUSE [ ] when you come to a good starng point for recording.
Finally, press [D. DUBBING], and DVD to VHS duplicaon will begin.
When you reach the point on the DVD at which you want to stop recording, press the [STOP]
buon [ ].
Once you have pressed STOP, your recorded VHS tape is ready to be ejected!
Otros manuales para ZV427FX4
2
Otros manuales de Grabadora de DVD de FUNAI
FUNAI
FUNAI DR-C3835 Manual de usuario
FUNAI
FUNAI HD-B2735 Manual de usuario
FUNAI
FUNAI HDR-B2735D Manual de usuario
FUNAI
FUNAI FDR-90E Manual de usuario
FUNAI
FUNAI DR-A2601 Manual de usuario
FUNAI
FUNAI WD6D-M101 Manual de usuario
FUNAI
FUNAI TD6D-D500GB Manual de usuario
FUNAI
FUNAI DR-D2831 Manual de usuario
FUNAI
FUNAI DR-A2635 Manual de usuario
FUNAI
FUNAI DR-A2677 Manual de usuario
FUNAI
FUNAI Magnavox ZV427MG9 A Manual de usuario
FUNAI
FUNAI HD-A2685 Manual de usuario
FUNAI
FUNAI DRVR-B778S Manual de usuario
FUNAI
FUNAI DR-A2631 Manual de usuario
FUNAI
FUNAI W4D-D4180DB Manual de usuario
FUNAI
FUNAI WL6D-M102 Manual de usuario
FUNAI
FUNAI ZV427FX4 Manual de usuario
FUNAI
FUNAI TD6D-M101 Manual de usuario
FUNAI
FUNAI BZV420MW8 Manual de usuario
FUNAI
FUNAI W4A-A4180DB Manual de usuario
