Fujitsu F2MC-8FX Series Manual de usuario

The following document contains information on Cypress products.

Colophon

The products described in this document are designed, developed and manufactured as contemplated for general use,

including without limitation, ordinary industrial use, general office use, personal use, and household use, but are not

designed, developed and manufactured as contemplated (1) for any use that includes fatal risks or dangers that, unless

extremely high safety is secured, could have a serious effect to the public, and could lead directly to death, personal injury,

severe physical damage or other loss (i.e., nuclear reaction control in nuclear facility, aircraft flight control, air traffic control,

mass transport control, medical life support system, missile launch control in weapon system), or (2) for any use where

chance of failure is intolerable (i.e., submersible repeater and artificial satellite). Please note that Spansion will not be liable

to you and/or any third party for any claims or damages arising in connection with above-mentioned uses of the products.

Any semiconductor devices have an inherent chance of failure. You must protect against injury, damage or loss from such

failures by incorporating safety design measures into your facility and equipment such as redundancy, fire protection, and

prevention of over-current levels and other abnormal operating conditions. If any products described in this document

represent goods or technologies subject to certain restrictions on export under the Foreign Exchange and Foreign Trade Law

of Japan, the US Export Administration Regulations or the applicable laws of any other country, the prior authorization by the

respective government entity will be required for export of those products.

Trademarks and Notice

The contents of this document are subject to change without notice. This document may contain information on a Spansion

product under development by Spansion. Spansion reserves the right to change or discontinue work on any product without

notice. The information in this document is provided as is without warranty or guarantee of any kind as to its accuracy,

completeness, operability, fitness for particular purpose, merchantability, non-infringement of third-party rights, or any other

warranty, express, implied, or statutory. Spansion assumes no liability for any damages of any kind arising out of the use of

the information in this document.

ORNANDTM and combinations thereof, are trademarks and registered trademarks of Spansion LLC in the United States and

other countries. Other names used are for informational purposes only and may be trademarks of their respective owners.

Fujitsu Semiconductor (Shanghai) Co., Ltd.

Setup Guide MCU-AN-500092-E-10

F²MC-8FX FAMILY

8-BIT MICROCONTROLLER

MB95390 SERIES

EV BOARD MB2146-441-E

SETUP GUIDE

EV BOARD MB2146-441-E V1.0

Revision History

ersion Date Updated by Modifications

1.0 2010-04-21 Kevin Wang First draft

This manual contains 15 pages.

5. Some of the products described in this manual may be strategic materials (or special technology) as defined

by the Foreign Exchange and Foreign Trade Control Law. In such cases, the products or portions theory

must not be exported without permission as defined under the law.

4. The products contained in this document are not intended for use with equipment which require extremely

high reliability such as aerospace equipment, undersea repeaters, nuclear control systems or medical

equipment for life support.

3. The contents of this manual may not be transferred or copied without the express permission of Fujitsu.

2. Fujitsu will not be liable for infringement of copyright, industrial property right, or other rights of a third party

caused by the use of information or drawings described in this manual.

1. The products described in this manual and the specifications thereof may be changed without prior notice.

To obtain up-to-date information and/or specifications, contact your Fujitsu sales representative or Fujitsu

authorized dealer.

MCU-AN-500092-E-10 – Page 2

EV BOARD MB2146-441-E V1.0

Contents

CONTENTS

REVISION HISTORY.............................................................................................................. 2

CONTENTS ............................................................................................................................ 3

1BGMA MANUAL................................................................................................................ 4

1.1BGMA Overview........................................................................................................ 4

1.2Function List.............................................................................................................. 4

1.3IDC10 Interface Description...................................................................................... 5

1.4BGMA USB Configuration......................................................................................... 5

1.5LED Description........................................................................................................ 7

2EV BOARD INTRODUCTION............................................................................................ 9

2.1EV Board Overview................................................................................................... 9

2.2Function List............................................................................................................ 10

2.3EV Board Schematic............................................................................................... 11

2.4HW Module Description .......................................................................................... 12

2.4.1Power Module........................................................................................... 12

2.4.2BGMA Interface......................................................................................... 12

2.4.3Test Pin..................................................................................................... 12

2.4.4Connector.................................................................................................. 12

3DEVELOPMENT PLATFORM QUICK START ............................................................... 13

3.1Tools Setup Sequence............................................................................................ 13

3.2Open Project and Start Debug................................................................................ 13

4ADDITIONAL INFORMATION......................................................................................... 14

5APPENDIX....................................................................................................................... 15

MCU-AN-500092-E-10 – Page 3

EV BOARD MB2146-441-E V1.0

Chapter 1 BGMA Manual

1 BGMA Manual

This chapter gives introduction on how to set up BGMA.

1.1 BGMA Overview

Below is a close look of MB95390 Series BGMA. The part number is MB2146-08-E. It

provides a debugging platform for the MB95390 Series MCU in a small size of 55.7mm (W)

X127mm (D) X30mm (H).

Figure 1-1: BGMA overview

1.2 Function List

ID Function description Remarks

1 Support MB95390 Series MCU MCU MAX machine clock: 16.25 MHz

MCU power voltage: 2.8 V ~ 5.5 V

2 Break pointer 256 software breakpoints

3 USB interface to PC/SOFTUNE Compatible with USB protocol version 1.1

4 1-Line UART interface to the MB95390 Series

MCU The Baud rate is 62,500 bps

5 Support the MCU flash programming fo

engineering development The programming and reading speed is about 800 B/S.

MCU-AN-500092-E-10 – Page 4

EV BOARD MB2146-441-E V1.0

Chapter 1 BGMA Manual

1.3 IDC10 Interface Description

Pin Numbe

Pin Name Description

1 UVCC Target MCU VCC

2 GND Target MCU VSS

3 RSTIN Target MCU reset input

4 RSTOUT Target MCU reset output

5 RSV Reserved

6 RSV Reserved

7 RSV Reserved

8 DBG Target MCU debugging pin

9 RSV Reserved

10 RSV Reserved

1.4 BGMA USB Configuration

The BGMA is provided with a USB cable. Connect the BGMA to PC with the USB cable. If

the connection is right, the following window will pop up. Follow the instructions displayed,

and then click Next.

Figure 1-2: Install BGMA in Windows (1)

MCU-AN-500092-E-10 – Page 5

EV BOARD MB2146-441-E V1.0

Chapter 1 BGMA Manual

Select Install from a list or specific location (Advanced), then click Next.

Figure 1-3: Install BGMA in Windows (2)

Select …\Drivers from the folder where SOFTUNE is installed, then click Next.

Figure 1-4: Install BGMA in Windows (3)

MCU-AN-500092-E-10 – Page 6

EV BOARD MB2146-441-E V1.0

Chapter 1 BGMA Manual

MCU-AN-500092-E-10 – Page 7

Select BGMA (MB2146-08) as displayed below, and then click Next.

Figure 1-5: Install BGMA in Windows (4)

Windows will install the driver automatically. Click Finish after the driver has completed the

installation normally. Then users can find the BGMA is recognized as MB2146-08 in

Windows system.

Figure 1-6: BGMA is installed in Windows

1.5 LED Description

First, only plug USB cable to PC; check whether the power LED on BGMA turns green.

Refer to Figure 1-7.

Figure 1-7: BGMA Power LED (1)

Green USB Plugged to PC

EV BOARD MB2146-441-E V1.0

Chapter 1 BGMA Manual

MCU-AN-500092-E-10 – Page 8

Second, plug IDC10 cable to the EV board (target MCU board), then turn on EV board. After

that, check whether the power LED on the BGMA turns orange. Refer to Figure 1-8.

Figure 1-8: BGMA Power LED (2)

Orange

Otros manuales para F2MC-8FX Series

Este manual sirve para los siguientes modelos

Tabla de contenidos

Otros manuales de Placa madre de Fujitsu

Fujitsu

Fujitsu D3231-S Manual de usuario

Fujitsu

Fujitsu D3641 Manual de usuario

Fujitsu

Fujitsu Mainboard D2974 Manual de usuario

Fujitsu

Fujitsu D3488 Manual de lista de piezas

Fujitsu

Fujitsu MB91360 SERIES Manual de usuario

Fujitsu

Fujitsu SK-96320-80PMC Manual de usuario

Fujitsu

Fujitsu SK-96380-120PMT Manual de usuario

Fujitsu

Fujitsu D2860 Manual de usuario

Fujitsu

Fujitsu D1031 Manual de usuario

Fujitsu

Fujitsu MB89PV930 Manual del operador

Fujitsu

Fujitsu D1451 Manual de usuario

Fujitsu

Fujitsu D3003 Manual de usuario

Fujitsu

Fujitsu MB2146-450-E Manual de usuario

Fujitsu

Fujitsu GA-8ISXT-FS P4 Titan Manual de usuario

Fujitsu

Fujitsu GA-7VAXFS Manual de usuario

Fujitsu

Fujitsu F2MC-8FX Series Manual de usuario

Fujitsu

Fujitsu SK-91F467D-208PFV Manual de usuario

Fujitsu

Fujitsu GA-8I848PM P4 Titan Series Manual de usuario

Fujitsu

Fujitsu D2119 Manual de usuario

Fujitsu

Fujitsu D1692 Manual de usuario

Fujitsu

Fujitsu D1271 Manual de usuario

Fujitsu

Fujitsu D3011 Manual de usuario

Fujitsu

Fujitsu P4 Titan-DDR GA-8STXC Manual de usuario

Fujitsu

Fujitsu D1826-G Manual de usuario

Manuales populares de Placa madre de otras marcas

DFI

DFI SD170 Manual de usuario

ASROCK

ASROCK ROMED8-2T Manual de usuario

Asus

Asus P2L97A Manual de usuario

Winmate

Winmate IC70 Manual de usuario

Asus

Asus MES-B Manual de usuario

Grantech

Grantech SYS8F377VGGA-3OMN Manual de usuario

Telit Wireless Solutions

Telit Wireless Solutions SL869-3DR Manual de usuario

Gigabyte

Gigabyte GA-9IVDT Manual de usuario

Texas Instruments

Texas Instruments ADS8372EVM Manual de usuario

Commell

Commell MS-C73 Manual de usuario

IBT Technologies

IBT Technologies MB860 Manual de usuario

Nvidia

Nvidia TEGRA DG-04927-001_V01 Manual de usuario

Biostar

Biostar M7VIT Bravo Instrucciones de funcionamiento e instalación

Intel

Intel D33217CK Manual de usuario

Asus

Asus F1A55-M LX PLUS R2.0 Manual de usuario

EPC

EPC EPC9147C Manual de usuario

Asus

Asus EX-B760M-V5 D4 Manual de usuario

EPOX

EPOX MU-8KHA0010 Manual de usuario