Fujitsu x178 Manual de usuario
Display Unit
Fujitsu x178
User’s Guide
Brugervejledning
Käyttäjän käsikirja
Manuel d’utilisation
Benutzerhandbuch
Manual do utilizador
Guía de usuario
Användarhandbok
Fujitsu 8/16/92 5:16 PM Page 2
Display Unit Fujitsu x178
User’s Guide
First Edition Document Number:
August 1999
This document was produced by Fujitsu Computers Oy in Espoo, Finland.
If you have comments or suggestions, we’d like to hear from you!
Mail: Internet:
User Documentation
PO Box 10 X.400:
FIN-02611 Espoo G=user S=documentation
Finland O=fujitsu OU1=fin1703
P=fujitsu A=elisa C=fi
Fujitsu Computers Ltd (hereinafter Fujitsu) endeavours to ensure that the information
in this document is correct, but accepts no liability for any error or omission in the
same.
Any procedures described in this document for operating Fujitsu products should be
read and understood by the operator before such products are used. To ensure that
Fujitsu products function without risk to safety or health, such procedures should be
strictly observed by the operator.
The development of Fujitsu products and services is continuous and published
information may not be up to date. Any particular issue of a product may contain part
only of the facilities described in this document or may contain facilities not described
herein. It is important to check the current position with Fujitsu.
Specifications and statements as to performance in this document are Fujitsu estimates
intended for general guidance. They may require adjustment in particular
circumstances and should therefore not be taken as formal offers or commitments.
Statements in this document are not part of a contract or program product licence
save insofar as they are incorporated into a contract or licence by express written
reference. Issue of this document does not entitle the recipient to access to or use of
the products described, and such access or use may be subject to separate contracts or
licences.
Microsoft, Windows, Windows NT and the Windows logo are registered trademarks
of Microsoft Corporation in the United States and other countries. Other products
mentioned may be trademarks or registered trademarks of their respective owners.
ENERGY STAR is a U.S. registered trademark.
©Copyright Fujitsu Computers Ltd 1998
Fujitsu 8/16/92 5:16 PM Page 3
Contents
Your new display unit . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3
Safety information . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4
Selecting a suitable location . . . . . . . . . . . . . . . . . . . . . . . 5
Installing your display unit . . . . . . . . . . . . . . . . . . . . . . . . 6
Display power management . . . . . . . . . . . . . . . . . . . . . . . . 8
Adjusting the picture . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 9
Cleaning your display unit . . . . . . . . . . . . . . . . . . . . . . . . . 14
Troubleshooting . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 15
Technical fact sheet . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 18
Contents
Fujitsu 8/16/92 5:16 PM Page 4
English
3
Your new display unit
Your new display unit is a highly ergonomic colour display unit
■supporting high screen refresh rates and full scan flicker-free
picture quality
■allowing easy setup through Plug-and-Play
■with On Screen Display menus for user control
■complying with MPR90 and TCO92 recommendations for low
electromagnetic fields
■meeting TCO’99 environmental specifications
■with power management features that allow the unit to enter a
low power consumption state after a period of inactivity.
When you unpack the display unit, check to make sure that you have
the items below. A power cable is included in your system unit
package.
Fujitsu 8/16/92 5:16 PM Page 6
English
4
When you set up and use your display unit, follow the safety
instructions below.
Do not use a continental European type power cable in the
United Kingdom and Denmark. Use a 3-prong plug to ensure
an earthed connection.
This equipment must be connected to an earthed outlet which
is close to the display unit and accessible in case you need to
disconnect the display.
Do not connect an extension cord.
If you need to replace your cords, contact your Fujitsu sales
representative.
Do not under any circumstances open the display unit cabinet.
Slots in the cabinet are provided for ventilation. Do not block
the ventilation slots in the display unit cabinet.
■
■
■
■
Safety information
Fujitsu 8/16/92 5:16 PM Page 7
English
5
Place the display unit at least 30 cm from other electrical or
heat-emitting equipment and allow at least 10 cm on each side
for ventilatiion.
Place the display unit in a position where no light shines
directly onto or is reflected on the screen.
To reduce eye strain, avoid installing the display unit against a
bright background such as a window.
Place your display unit at a comfortable viewing height and
distance: most people prefer the top line of the text to be at or
just below eye level and the display within arm’s length (a
distance of 45 to 90 cm) when you are comfortably seated. You
can tilt and swivel the display unit to get a good viewing angle.
This display unit has an anti-glare antistatic screen. The use of
an additional anti-glare screen is not recommended as it will
impair picture quality.
■
■
■
■
■
Selecting a suitable location
Fujitsu 8/16/92 5:16 PM Page 8
English
6
WARNING!
Before you start cabling your display unit, check that the
power is off on all units. To avoid any possibility of electric
shock, always connect your equipment to properly earthed
outlets.
The base of the display is already installed; do not use the
monitor withour it. Place the display unit on a level and sturdy
surface.
Connect the display unit’s signal cable (a)to the system unit
and scure it with the two screws. The connector pins may be
protected against damage by a plastic cover which needs to
be removed first.
Plug the display unit’s power cable (b)first to the back of the
display unit, as shown below.
Then plug the power cable (b)to a 100V-240V earthed
electrical outlet or to the system unit, if it has an outlet for the
display power cable, as shown below.
Installing your display unit
1.
2.
3.
4.
Fujitsu 8/16/92 5:16 PM Page 9
English
7
Turn on the display unit using the power switch (1)and check
to make sure that the power LED (2)is on, as shown below. If
not, repeat steps 2,3 and 4 or refer to the Troubleshooting
section of this guide.
Turn on the power to the computer. The picture will appear
within about 15 seconds. During its start-up the computer
recognizes the display automatically provided that the display
unit has been turned on. Adjust the picture to obtain optimum
picture quality. See the Adjusting the picture section in this
guide for more information.
5.
6.
Fujitsu 8/16/92 5:16 PM Page 10
NOTE!
The power button does not disconnect the display unit from
the mains. The only way to isolate the display unit com-
pletely from the mains supply is to unplug the mains cable.
There is no need to turn your display unit on and off
If the power management function of your computer is enabled,
your display unit turns on and off automatically. You control power
management from your computer. See your computers’EasyGuide
for more information.
Reducing power consumption
Once you have set the timeout periods through the power
management function in your computer, the computer will enter
power savings modes automatically after periods of inactivity.
NOTE!
The sereensaver function (where the screen image is
replaced by a pattern) does not affect power consumption.
The purpose of the sereensaver is to extend the usable life
of the display.
English
8
Display power management
MODE
Operating
Standby
Suspend
Power-off
Unplugged
LED
green
amber
amber/green blinking
amber blinking
not illuminated
POWER
CONSUMPTION
≤120 W
≤70 W
≤15 W
≤3 W
0 W
Fujitsu 8/16/92 5:16 PM Page 11
English
9
You can adjust the screen display using the buttons and controls
located below the screen.
Adjusting the picture
Fujitsu 8/16/92 5:16 PM Page 12
Tabla de contenidos
Otros manuales de Monitor de Fujitsu
Fujitsu
Fujitsu Plasmavision PDS4213 Manual de usuario
Fujitsu
Fujitsu proGREEN B20T-7 Manual de usuario
Fujitsu
Fujitsu Plasmavision P42VCA10 Manual de usuario
Fujitsu
Fujitsu PLASMAVISION P50XCA51WH Manual de usuario
Fujitsu
Fujitsu B24W-7 Manual de usuario
Fujitsu
Fujitsu P24W-6 IPS Manual de usuario
Fujitsu
Fujitsu x150f Manual de usuario
Fujitsu
Fujitsu X23T-1 MHL Manual de usuario
Fujitsu
Fujitsu 38B2-M Manual de usuario
Fujitsu
Fujitsu Plasmavision PV42VCA30W Manual de usuario
Fujitsu
Fujitsu P24W-6 Manual de usuario
Fujitsu
Fujitsu Plasmavisioin Manual de usuario
Fujitsu
Fujitsu P2711 TE QHD Instrucciones de instalación
Fujitsu
Fujitsu Plasmavision PDS4207E-H Manual de usuario
Fujitsu
Fujitsu P24W-6 LED Manual de usuario
Fujitsu
Fujitsu 280X1024@75Hz Manual de usuario
Fujitsu
Fujitsu B24-9 WE Manual de usuario
Fujitsu
Fujitsu Plasmavision P42HTA51E Series Manual de usuario
Fujitsu
Fujitsu B22W-6 LED Manual de usuario
Fujitsu
Fujitsu B23T-6 LED Manual de usuario
