FSA E-SYSTEM Manual de usuario
USER MANUAL
2
33
WARNING AND SECURITY
1. OVERVIEW 6
4. POWER ON / OFF 9
7. BATTERY INSERTION 14
2. BATTERY AND CONTROLLER 6
5. RANGE EXTENDER 11
8. CONNECTORS 15
9. APP 16
3. MOTOR 8
6. CHARGING PORT 14
INDEX
10. ERRORS 20
44
WARNING AND SECURITY
IMPORTANT NOTICE
• This manual is intended only for use by experienced mechanics.
• Read the user manual carefully.
• The warranty is voided with any structural change to the product.
• User manual on our website (http://www.fullspeedahead.com).
• Follow the laws and regulations of each country.
• The Bluetooth® trademark and logos are registered trademarks of
Bluetooth SIG,Inc. Any use of this trademarks by FSA-VISION is
subject to a License.
• This device uses ANT+ Protocol.
WARNINGS
• For disposal, completely discharge the battery and go to a sui-
table collection center (RAEE-European directive 2012/19/EU and
2006/66/EC).
• Do not deform, modify or disassemble the battery or weld directly
on the battery. Failure to comply may result in leakage, overheating,
explosion, or battery re.
• Do not leave the battery near heat source. Do not heat the battery.
Failure to comply may result in leakage, overheating, explosion, or
battery re.
• Do not expose the battery to strong impacts. Failure to comply may
result in leakage, overheating, explosion, or battery re.
• Do not immerse the battery in the water, and avoid connectors get-
ting wet. Failure to comply may result in leakage, overheating, explo-
sion, or battery re.
• To charge the battery, use the specied FSA battery charger and
observe the indicated rules.
• Do not leave the battery permanently connected to the battery char-
ger.
55
DANGERS
• When the bike is moving, avoid being distracted by the power/level
battery button.
• Before using bike on busy road, familiarize yourself with starting the
e-bike. The bike could start too abruptly to keep control.
• Do not disassemble the product.
• If liquid is leaking from the battery, and should come into contact
with the eyes. Immediately rinse the affected area with water without
rubbing the eyes and contact a doctor. If these instructions are not
observed, ocular lesions may occur.
• Do not insert or remove the plug when it’s wet. In the event of
non-compliance, electric shocks may occur.
• Do not leave the battery in places exposed to direct sunlight, inside
a vehicle on a hot day, or in other warm places. This could cause
battery failure.
66
1. OVERVIEW
This section of the down tube and the battery shows how the battery
must rest rmly (yellow) on the inner wall of the tube, while on the other
sides, a minimum distance must be respected which can vary according
to the construction tolerances of the frame, we recommend at least 1mm
minimum space. The controller must be screwed in perfectly.
2. BATTERY AND CONTROLLER
Dimensions: Length 469mm. Section 42.0 x 49.5mm.
77
BATTERY FEATURES
Temperature range of use 0 - +40 Degrees Celsius
Temperature range of charging +10 - +40 Degrees Celsius
Long life storage temperature 0 - 20 Degrees Celsius,
Humidity <65%
Charging voltage CC-CV 2A max 42.0 V
Type of cell 18650
Recharge cycle 500 (60% capacity)
Nominal Voltage 36 V
Battery type Li-ion
Nominal capacity 252 Wh
Max Output 15 A
Motor Type Brush-less DC
Weight 1,4kg (1,7kg with controller)
Charging time 4h (100%)
88
3. MOTOR
Power (W) 250
Max Speed (km/h) 25
Voltage (V) 36 (Min: 30; Max: 42)
Wheel size (Inch) 28
Color Black
Hexagon disc brake screw M5x8 (x6)
Disc Brake Diameter >=160mm
MOTOR FEATURES
99
4. POWER ON / OFF
Power ON / OFF Button:
• To turn ON the system, press the button for 1 second.
• To turn OFF the system, press and hold the button for 4 seconds.
Assistance Level:
When switched on, the system automatically selects the ECO level (green).
Meanwhile, please don’t place your feet on the pe-
dals and do not move the bike, it must be stationary
(0km/h), in order to allow the torque sensor and speed
sensor to calibrate themselves. As soon as the light
turns to the green, the bike can be mounted and feet
placed on the pedals.
To select the desired assistance level, press the button: with each suc-
cessive press, the assistance level increases: 1 green, 2 blue, 3 pink, 4
yellow, 5 red. At selected level 5, a further pressure on the key will return
to level 1.
Level 1 Level 2 Level 3 Level 4 Level 5
Eco: Green Light Blue Light Pink Light Yellow Light BOOST: Red Light
Neutral Active Active Active Active
1010
4. POWER ON / OFF
Battery Level:
While using the system, regardless of the level of assistance selected, it
will be possible to check the battery charge level.
A ash of light, will be displayed every 2 seconds, indicating the state of
charge of the battery. An accurate reading of the battery charge level can
be made via the APP.
Green Flash Blue Flash Yellow Flash Red Flash
Recharge Battery step:
Connect the battery charger to the main socket and connect the battery
charger to the e-bike charging socket. The battery charger will automati-
cally switch on and the e-bike button will start ashing every 2 seconds.
(0.5 sec. ON; 1.5 sec. OFF).
Battery charger indicator.
• Red: Charging. (Flashing e-bike button with color level battery; See
above, as battery level).
• Green: Full charge.
Error/fault condition report:
Any error of system or protections (use out of the limits or faults) are
signaled by a ashing of the button.
• Yellow: Temporary error (0.5 sec. ON; 0.5 sec OFF).
• Red:
1. The battery is not connect to controller or CAN-bus. No data
reading (0.5 sec. ON; 9.5 sec OFF).
2. The battery is charging. The level of charge is at the minimum
(0.5 sec. ON; 4.5 sec OFF).
3. Permanent failure, disconnect the battery, isolate it and return
(0.5 sec. ON; 0.5 sec OFF).
Otros manuales para E-SYSTEM
1
Tabla de contenidos
