20127A - CASSARA TEAK CLUB CHAIR
A. BACK REST 1 PC H1 ALLEN HEAD BOLT M6X50mm 6 PCS
H2 WOODEN SCREW, 25mm 2 PCS
B SEAT 1 PC H3 WOODEN SCREW, 40mm 2 PCS
H4 WOODEN PLUG 4 PCS
C RIGHT END FRAME 1 PC
TOOLS NEEDED (INCLUDED) :
T1 ALLEN KEY (Included)
T2 PHILLIP HEAD SCREW DRIVER (Not Included)
D LEFT END FRAME 1 PC T3 GLUE PACKET (Included)
APPROX 30 MINS
NUMBER OF PEOPLE TO INSTALL :
RECOMMENDED 1 to 2 Persons
PRE ASSEMBLY INSTRUCTIONS:
1 Do not throw away packaging materials until the assembly is complete. Part might be
accidentally thrown away.
1.a Lay the Right End Frame , (a sticker on the seat base is attached to differentiate the
2 end frames) on the floor facing up the holes, DETAIL 1. Use the packaging material
Description Description
F R O N T G A T E *
O U T F I T T I N G A M E R I C A ' S F I N E S T H O M E S
2 end frames) on the floor facing up the holes, DETAIL 1. Use the packaging material
the protect the End Frame against the floor. See Figure 1a
1.b Attached the 3pcs of Allen Head Bolt (H1) and tighten it with the Allen Key (T1), DETAIL 2
see Figure 1b
1.c Align the Left End Frame's mortise hole(D), to the tenon of the Seat (B) and Back Rest(A)
See Figure 1c, then follow step 1b
Sticker "RH"
C
Figure 1a Figure 1c
D
Sticker "LH"
H1
T1
Page 2 of 3
