Friedrich ZStar Manual de usuario

Room Air Conditioner

Installation and Operation

Manual

MODEL NUMBER SERIAL NUMBER PURCHASE DATE

ZStar®

920-095-03 (12/03)

ZQ05115 Volts ZQ07

Registering Your Room Air Conditioner

Model information can be found on the name plate located on the

side of the unit near the control panel. Please complete and mail

the owner registration card furnished with this product or register

on-line at www.friedrich.com (USA only). For your future

convenience, record the model information here.

ENGLISH FRANÇAIS ESPAÑOL

ENGLISH

Congratulations!

You have purchased a Friedrich ZStar®

room air conditioner. The Friedrich

ZStar®is designed to give maximum

comfort and quietness.

Table of Contents

Introduction ..................................................................................2

Safety Precautions.......................................................................3

How to operate your Friedrich ZStar

.......................................5

Installation Instructions...............................................................7

Troubleshooting Tips.................................................................11

Warranty......................................................................................12

Before Operating Your Unit

Make sure the wiring is adequate for your unit.

If you have fuses, they should be of the time delay type. Before you install or relocate this unit, be sure that

the amperage rating of the circuit breaker or time delay fuse does not exceed the amp rating listed in figure 1.

DO NOT use an extension cord.

The cord provided will carry the proper amount of electrical power to the unit; an extension cord will not.

Make sure that the receptacle is compatible with the wall plug provided.

This insures proper grounding. If you have a two-prong receptacle you will need to have the circuit replaced

by a certified electrician with a grounded circuit that meets all national and local codes and ordinances. You

must use the three-prong plug furnished with the air conditioner.

Figure 1

For the Best Cooling Performance and Energy Efficiency

Keep the filter clean

Make sure that your air conditioner is always in top performing condition by cleaning the filter regularly.

Instructions for removing and cleaning the filter can be found on page 6.

Provide good airflow

Make sure that the airflow to and from the unit is clear. Your air conditioner puts the air out at the top of

the unit, and takes in air at the bottom. Airflow is critical to good operation. It is just as important on the

outside of the building that the airflow around the unit exterior is not blocked.

Unit Placement

If your air conditioner can be placed in a window or a wall that is shaded by a tree or another building, the

unit will operate even more efficiently. Using drapes or blinds on the sunny side of the dwelling will also

add to your unit's efficiency.

Insulation

Good insulation will be a big help in maintaining desirable comfort levels. Doors should have weather

stripping. Be sure to caulk around doors and windows.

Introduction

MODEL

ZQ05

ZQ07

AMP VOLT NEMA NO.

15 125 5-15P

CIRCUIT

RATING OR

TIME DELAY

FUSE PLUG FACE

ENGLISH

Safety Precautions

To prevent injury to the user or other people and property damage, the following instructions must be

followed.

■Incorrect operation will cause harm or damage. Follow all operating instructions. The seriousness

of potential harm or damage due to incorrect operation is classified below:

WARNING

WARNING This symbol indicates the possibility of death or serious injury.

CAUTION This symbol indicates the possibility of injury or damage to

propertyonly.

■Meanings of symbols used in this manual are as shown below,

Never Do This

Always Do This

Plug in the power plug

properly.

•Otherwise,itwillcauseelectric

shock or fire due to heat

generation.

Do not operate or stop the

unit by inserting or pulling

out the power plug.

• It will cause electric shock or fire

due to heat generation.

Do not damage or use an

unspecified power cord.

• It will cause electric shock or fire.

•

If the power cord is damaged, it must

be replaced by the manufacturer or a

Friedrich-certified service agent.

Do not modify power cord

length or share the outlet

with other appliances.

• It will cause electric shock or fire

due to heat generation.

Do not operate with wet

hands or in damp

environment.

• It will cause electric shock.

Do not direct air flow at room

occupants only.

•

This could lead to health problems

Safety Precautions

Sharp

edges

When the air filter is to be

removed, do not touch the

metal parts of the unit.

•They are sharp and may cause

an injury.

Do not clean the air

conditioner with water.

•Water may enter the unit and

degrade the insulation. It may

causeanelectricshock.

Whentheunitistobe

cleaned, switch the unit off,

and unplug it.

•Since the fan rotates at high

speed during operation, it may

causeaninjury.

Do not operate the unit

without the air filter or when

the front intake grille has

been removed.

•It could cause dust to

accumulate on the heat

exchanger.

Do not put a pet or house

plant where it will be

exposed to direct air flow.

•This could injure the pets

or plants.

Do not use for special

purposes.

•Do not use this air conditioner to

preserve precision devices, food,

pets, plants, and art objects.

It may cause deterioration of

quality, etc.

Do not operate switches

with wet hands

•It may cause an electric shock.

Do not apply an insecticide

or flammable spray.

•It may cause a fire or

deformation of the cabinet.

SHARP EDGES!

The edges of the case can

be SHARP!

•Use caution when handling the

case.Gripitfirmlyanddonotallow

it to slip while holding it.

•

Use heavy gloves to handle

the case if necessary.

•

DO NOT

allow the

case to slide

against

your skin!

ENGLISH

How to operate your Friedrich ZStar®

Fan

Cool

Off

Cool

Temperature

Mode

Warmer Cooler

Function Controls

When the air conditioner has finished cooling the room and is turned off or set to the fan

position, wait at least 3 minutes before resetting to the cooling operation again.

FUNCTION CONTROL

This dial allows you to select 2 cooling and 2 fan speeds.

Turn to Off to turn everything off.

Turn to Hi Cool for quick cooling.

Turn to Lo Cool to maintain a desired temperature.

The Hi Fan setting provides maximum circulation of filtered room air

without cooling.

The Lo Fan setting is a slow fan speed without cooling.

TEMPERATURE CONTROL

This dial is the thermostat. Turn it clockwise for cooler and

counterclockwise for warmer temperature.

•FOR NORMAL COOLING

1. Turn the Mode switch to the Hi Cool or the Lo Cool setting.

2. Set the Temperature control to the desired temperature point (the mid-point is a good

starting position). If the room temperature is not satisfactory after a reasonable time, adjust the

control to a cooler or warmer setting, as appropriate.

•FOR MAXIMUM COOLING

1. Turn the Mode switch to the Hi Cool setting.

2. Set the temperature control to the coolest temperature point (all the way to the right).

•FOR QUIETER OPERATION

1. Turn the Mode switch to the Lo Cool setting.

2. Set the Temperature control as needed.

CAUTION

How to operate your Friedrich ZStar®

Do not force

open or open too

far (about 56°)

Fig. 1

Fig. 2

Fig. 3

Fig. 4

Additional controls and important information.

Care and Maintenance

Air Direction

• ADJUSTING THE AIR DIRECTION USING THE HORIZONTAL AIR-DEFLECTOR CONTROL

Using the Control Tabs, the air flow can be directed

to the left, right, straight ahead, or any combination

of these directions.

TURN THE AIR CONDITIONER OFF AND REMOVE THE PLUG FROM THE POWER OUTLET.

•To Remove the Filter

Remove the front cover by gripping the top outside

edges and pulling toward you (see Fig.1).

You will notice that the grille will only open to

about 56°. Do not force the grille open too far.

2. Find the two clips that hold the filter in place.

Gently lift the filter out.

•To Clean the Filter

1. Clean with warm water. Be sure to shake all water off

before replacing the filter.

2. Carefully position the filter, bottom first, and snap

back into place.

The filter should be cleaned every two weeks for best

results.

•Cleaning The Air Conditioner

The Front Grille and Inlet Grille may be wiped with a

cloth dampened in a mild detergent and lukewarm water

solution. (Fig. 2)

The cabinet may be washed with mild soap or detergent and

lukewarm water.

To ensure continued peak efficiency, the condenser

coils(outside of unit) should be checked periodically and

cleaned if clogged with soot or dirt from the atmosphere.

Consult a certified Friedrich service agent for more information.

•Removing the Front Grille

1. Remove the temperature and mode control knobs by gently

pulling them off.(Fig.3)

2. Remove the screw securing the Front Grille.(Fig.3) The screw is

located behind the bottom temperature knob.

3. Push the grille up from the bottom and pull the top of the grille

away from the case as the top tabs lift out of their slots.(Fig. 4)

4. Carefully position the grille, bottom first, and snap back into

place.

5. Reposition the screw that secures the Front Grille and replace the

knobs.

ENGLISH

Learning the key components will help you properly install the unit.

Features

1. CABINET

2. HORIZONTAL AIR DEFLECTOR

3. COOL AIR DISCHARGE

4. FRONT GRILLE

5. INLET GRILLE

6. AIR FILTER

7. KNOBS

8. AIR INTAKE

9. UPPER GUIDE

Installation Instructions

OUTDOORSINDOORS

INNER

SILL

OUTER

SILL

INNER

SILL

WOOD STRIP MOUNTED

ON TOP OF INNER SILL

WOOD STRIP

FOR

BRACKET

3/4"

CLEARANCE

1" MAX.

STORM

WINDOW

FRAME

OUTDOORSINDOORS

OUTER

SILL

TYPE B: 5EA

(WOOD SCREW)

HARDWARE

TYPE A: 11EA

(SHORT SCREW) TYPE C: 3EA

(

BRACKET)

TYPE E: 1EA

(SASH SEAL)

(Not adhesive backed)

TYPE D: 1EA

(SEAL STRIP)

(Adhesive backed)

TYPE F: 2EA

(GUIDE PANEL) TYPE G: 1EA

(SUPPORT BRACKET)

10mm

16mm

Fig. 5-1 Fig. 5-2

NOTE: All supporting parts should be secured to firm wood, masonry, or metal.

1. This unit is designed for installation in standard double hung windows with actual opening widths of

22" to 36". The upper and lower sash must open sufficiently to allow a clear vertical opening of 13"

from the bottom of the sash to the window stool.

2.If storm window presents interference, fasten a 2" wide wood strip to the inner window sill across

the full width of the sill. The wood strip should be thick enough to raise the height of the window sill

so that the unit can be installed without interference by the storm window frame.

See Fig. 5-2. The top of the wood strip should be approximately 3/4" higher than the storm window

frame (STORM WINDOW FRAME) or wood strip (OUTDOORS) to help condensation to drain

properly to the outside.

3. Install a second wood strip (approximately 6" long by 11/2" wide and same thickness as first strip) in

the center of the outer sill flush against the back off the inner sill. This will raise the Lbracket as

shown Fig. 5-2.

4. If the distance between STORM WINDOW FRAME and WOOD STRIP MOUNTED ON TOP OF

INNER SILL is more than 1", two of wood strips are not necessary.

Window Requirements

Installation

Este manual sirve para los siguientes modelos

Tabla de contenidos

Idiomas:

Otros manuales de Acondicionador de aire de Friedrich

Friedrich

Friedrich Uni-Fit US12C30 Manual de usuario

Friedrich

Friedrich ZoneAire P09B Manual de usuario

Friedrich

Friedrich CP10E10 Series Manual

Friedrich

Friedrich EP12 Manual de usuario

Friedrich

Friedrich QuietMaster SL28L30 Manual de usuario

Friedrich

Friedrich PTAC - R410A Manual de usuario

Friedrich

Friedrich M18CF Manual de usuario

Friedrich

Friedrich WallMaster WCT08 Manual de usuario

Friedrich

Friedrich ZoneAir P-12 Manual de usuario

Friedrich

Friedrich MW09C3E Manual de usuario

Friedrich

Friedrich SP05 Manual de usuario

Friedrich

Friedrich Kuhl SS10 Manual de usuario

Friedrich

Friedrich Chill Premiere Series Manual de usuario

Friedrich

Friedrich MR09C1H Manual de usuario

Friedrich

Friedrich CP10 Manual de usuario

Friedrich

Friedrich Chill+ EP18 Manual de usuario

Friedrich

Friedrich S36YF Manual de usuario

Friedrich

Friedrich ZoneAire P09B Manual de usuario

Friedrich

Friedrich MC12Y3JM Manual de usuario

Friedrich

Friedrich MW09Y1E Manual de usuario

Friedrich

Friedrich CP12F10 Instrucciones de construcción

Friedrich

Friedrich QUIETMASTER 2008 Manual de usuario

Friedrich

Friedrich Z-Star ZQ05C10 Manual de usuario

Friedrich

Friedrich UE08A13A Instrucciones de construcción

Manuales populares de Acondicionador de aire de otras marcas

Spheros

Spheros CC 355 Manual de usuario

Bosch

Bosch Climate 5000 SCI 24 CAS/ OU- OUE Manual de usuario

Panasonic

Panasonic CS-E12HKEW Manual de usuario

nedis

nedis ACMB1WT7 Manual de usuario

Samsung

Samsung AR KV Series Guía

Daikin

Daikin FCFV50A Manual de usuario

Fujitsu

Fujitsu Inverter ASBA30JFC Manual de usuario

Toshiba

Toshiba RAS-M10SMUV-E Manual de usuario

Daikin

Daikin FXLQ20MAVE Manual de usuario

Hitachi

Hitachi RAS-E24CAK Manual de usuario

CIAT

CIAT Magister 2 Series Guía

Bestron

Bestron AAC6000 Manual de usuario

Hisense

Hisense 7K Manual técnico

Frigidaire

Frigidaire FFRE0533S1E0 Manual de usuario

Samsung

Samsung AS09HM3N Manual de usuario

Frigidaire

Frigidaire CRA073PU11 Manual del propietario

Soleus Air

Soleus Air GB-PAC-08E4 Manual de usuario

McQuay

McQuay MCK020A Manual de usuario