3. Install lamp holder
A. Thread the power wire (6) and its joint (5) through the
lamp base and lamp post (the lamp base and lamp post
canbe laiddownor put upside downforconvenience.After
drawingoutthejoint(5), placeit correctlyfor later use);
B.Takeoutthe lampholder (2)andputon thelamptop(1);
C. Draw out the joint (6) and the power line (14), connect
the joints (5) and (6), put the combined joints and their
wires into lamp post (3). Note: At this time, it will be better
to ask anotherpersontohold the lampholder (2) in case of
droppingit.
D. Rotate the lamp holder (2) to fasten it on the lamp post
(3). Note: The screw thread shall be tightened as far as
possible. Meanwhile the direction of the lamp holder (2)
shall be slightly adjusted to make it match the direction of
thelampbases(9)and(10).
4.Positioning, power-on,
Rainproof and examination
A. Positioning:Place carefullythe assembled street lamp at
thesetposition.Note: (1) If thestreetlamp is tobeinstalled
outdoor, please fix the lamp base with ground nails in case
high wind blows it down; (2) The street lamp should be
placed at a location without man-made interference in case
of damages. (3) If the street lamp is being installed indoor
and is a by man-made interference or is to be installed
outdoor and ground nails can not be used, please be sure
touse additional base (7) tokeep it secure.
B. Poweron: Tightlyconnectthetwojoints (1) and (4) of the
adaptor (4) and power wire (6). If the power wire isn’t long
enough, it is able to add the extended wire (5) between
them, and then connect the adapter (4) with the main
power source.
C. Rainproof: (1) The adapter itself is not waterproof, so
make sure that the connection point between the adapter
and themain power source is indoororfree of rainwater or
snow in case of electric leakage or electric shock. (2) The
lamp holder(2) shall be kept vertical to ensure water drains
correctly(3) If the street lampisused outside,all joints of (1)
and (2), (3) and(4), (5) and (6) mustbe tightened in case of
waterand electricleakage.
D. Examination: Whensetting the switch on the bottom of
the lamp holder (2) (see the figure below) to the left side,
the lamp should be lit, snowflakes falling down and music
splaying. If it fails to perform such functions, check if the
joints 1, 2, 3, 4, 5 and 6 are connected well. You can also
turn the switch to theright sidetoturn off themusic.
5. Decorate and enjoy
Asshowninthefigurebelow,fix
the brand (11) and the wreath +
bowknot (13) to the upper side
of the lamp post to make the
street lamp complete the look. If the street lamp is going to
be installed outside, there is no need to install these
decorations.
