Foxfury Lighting Solutions Nomad Prime Manual de usuario

PRODUCT MANUAL

200-800 |200-800-TC |200-8P56

NOMAD®PRIME & P56

TABLE OF CONTENTS

INTRODUCTION

Reference Guide 3

Overview 4

Physical Characteristics 4

BATTERY

Charging the Batteries 5

Charging from a 12VDC Vehicle Adaptor 5

Charge Indicator 5

OPERATION

AC-DC Adaptor and International Use 6

Operational Modes 6

Battery Life 7

Battery Life Indicator 7

Using the Nomad®while Plugged in 7

FEATURES

Swivel and Tilt Light Head 8

Diffuser Lens (Area-Spot) 8

Swivel and Tilt Light Head 9

Leveling Leg Extensions and Level Bubble 9

Anchor Strap 9

DEPLOYING THE NOMAD®10–11

MAINTENANCE 12–17

WARRANTY 18–19

CONTACT FOXFURY 19

NOMAD®REFERENCE GUIDE

BATTERY SYSTEM/

NOMAD®BODY

POWER/MODE

SWITCH

CARRY

STRAP

CLIP

BATTERY LIFE/

CHARGE INDICATOR

LEVEL BUBBLE

ANCHOR

STRAP

CHARGING PORT

PROTECTIVE

LIGHT CAP

LOCKING SLEEVE

TRIPO-SCOPE®

POLES

TRIPO-SCOPE®

TIGHTENING

RINGS (3)

FOLDING

TRIPO-SCOPE®

LEGS (3)

TRIPO-SCOPE®

LEG LOCK

LEVELING LEG

EXTENSIONS

DIFFUSER LENS

(AREA-SPOT)

TILT ADJUSTMENT

KNOB SWIVEL ADJUSTMENT

KNOB (340º)

LIGHT HEAD

ALSO INCLUDED

Accessories Bag

3M (Yellow) Reflective Tape

Carry Strap

AC-DC Adaptor

AC Cable

12VDC Vehicle Adaptor

DEPLOYED VIEW

STORED POSITION

OVERVIEW

The Nomad®Prime & P56 provide 3–24 hours of continuous lighting. It

converts from an area light to spotlight in seconds by attaching/detaching the

Diffuser Lens. Its portable, waterproof and adaptive design allows it to be

used in places where other area lights cannot. You can use it as a bazooka

light to survey an area or illuminate your path. In around 20 seconds, you’ll be

able to deploy the self-contained Tripo-Scope®Legs and raise the telescoping

head up to 8 ft tall to illuminate the work area.

IMPORTANT!

Please fully charge the Battery System before using the Nomad®for the

first time.

PHYSICAL CHARACTERISTICS

Please read below before using the Nomad®as it relays beneficial operating

and safety information.

NOMAD®PRIME & P56

DIMENSIONS 34.4 x 4.6 in (874 x 117 mm)

WEIGHT 18.4 lbs (8.3 kg)

WARNINGS

When used for extended periods of time the Nomad®will become HOT to

the touch. Please use care when operating.

Do not stare into LEDs for long periods of time or from a close range

(less than 2 ft).

Be sure to rinse the Nomad®with fresh water immediately after use in

the ocean or a pool.

This product may contain chemical(s) known to the State of California

to cause cancer, birth defects or other reproductive harm. For more

information, go to www.P65Warnings.ca.gov/product.

CHARGING THE BATTERIES

1. Start with the AC Cable. Connect it to the AC-DC Adaptor.

The AC Cable is Universal to NEMA 5-15P, 3 prong for USA and will

work with a power range of 100VAC–240VAC 50/60 Hz.

2. Plug the Barrel Connector (part of the AC-DC Adaptor) into the Charging

Port of the Nomad®Prime or P56.

Input voltage: 11–17VDC. Do NOT exceed!

The Nomad®Prime is shipped with a 30% charge. It is important to

charge it before using for the first time.

When the Charge Indicator FLASHES green it indicates that the

battery is being charged. When the Nomad®is completely charged, the

Charge Indicator will turn solid green.

Charging time will be approximately 5 hours.

CHARGING FROM A 12VDC VEHICLE ADAPTOR

1. Insert the 12VDC Vehicle Adaptor Cable into a 12V socket (located within

the vehicle).

2. Insert the opposite end (Barrel Connector) into the Charging Port of the

Nomad®Prime or P56.

NOTE: Do NOT start vehicle while the Nomad®is plugged in.

CHARGE INDICATOR (FOR LOCATION, PLEASE REFERENCE PAGE 3)

COLOR DESCRIPTION

GREEN (SOLID) FULLY CHARGED

GREEN (FLASHING) CHARGING

RED (SOLID) CHARGING ERROR

*If a charging error occurs, please contact FoxFury Customer Service (see pg. 18).

NOTE: Continuously charging (leaving the unit plugged in) could damage the

Battery Pack and lead to a decreased battery life. Please disconnect the unit

once it is fully charged.

Please DO NOT leave AC-DC Adaptor plugged in for more than eight (8)

continuous hours.

AC-DC ADAPTOR AND INTERNATIONAL USE

The Nomad®Series has a AC-DC Adaptor which uses AC Cables like those

used in desktop computers or monitors. With every Nomad®, FoxFury supplies

a cable that terminates in the USA standard 110 VAC plug.

The plug of the AC Cable should be country specific. Example: IEC Types A-N.

The Female Connector side of the AC Cable must be IEC Type C13 to mate

with the Male Inlet of the AC-DC Adaptor.

ON/LOW mode: Press the Power/Mode Switch once.

MEDIUM mode: From LOW mode, press the Power/Mode Switch once.

HIGH mode: From MEDIUM mode, press the Power/Mode Switch once.

FLASHING mode (excludes Nomad®P56): From HIGH mode, press the

Power/Mode Switch once.

OFF: From HIGH/FLASHING mode, press the Power/Mode Switch once.

NOTE: The light does not retain the mode in memory. Once the light is ON,

re-select the mode desired.

OPERATIONAL MODES

AC CABLE

TYPE B

10A (250V)

INLET (MALE) (C14 IEC)

(LOCATED AT END OF

ADAPTOR)

CONNECTOR

(FEMALE) (C13 IEC)

(VIEW OF CABLE END)

AC-DC ADAPTOR

BARREL CONNECTOR

CONNECTOR (FEMALE) AC PLUG

MUST BE IEC C13

CONNECTOR CAN BE ANY PLUG

IEC TYPES A-N

AC CABLE

10A (250V)

BATTERY LIFE

MODE BATTERY LIFE PRIME LUMENS P56 LUMENS

HIGH 3 hours 5,000 4,100

MEDIUM 9 hours 2,000 1,600

LOW 24 hours 600 450

FLASHING 9 hours 5,000 NA

*Battery life may vary according to age and ambient conditions.

BATTERY LIFE INDICATOR (FOR LOCATION, PLEASE REFERENCE PAGE 3)

COLOR DESCRIPTION

GREEN FULL BATTERY

ORANGE CAUTION— BATTERY IS GETTING LOW

RED (FLASHING) CHARGE IMMEDIATELY

USING THE NOMAD®PRIME WHILE PLUGGED IN

The Nomad®can run continuously by plugging it into a power source.

1. Start with the AC Cable. Connect it to the AC-DC Adaptor.

2. Plug the Barrel Connector (part of the AC-DC Adaptor) into the Charging

Port of the Nomad®.

3. Press the Power/Mode Switch. The light will then turn ON.

The Nomad®must be turned OFF in order to charge the Battery

System. If it is plugged in and the Nomad®is ON, the battery is NOT

being charged.

As long as the unit is plugged into a power source, (even if it has a

very low power) the light can be turned ON.

Input voltage: 11–17VDC. Do NOT exceed!

NOTE: The Nomad®will NOT accept a 24VDC input.

SWIVEL AND TILT LIGHT HEAD

The Nomad®Light Head has the versatility to swivel (via the Swivel

Adjustment Knob) and tilt (via the Tilt Adjustment Knob).

DIFFUSER LENS (AREA-SPOT)

Lighting needs can change in an instant or on a case by case basis. As an

Area-Spot light, the Nomad®provides two types of lights in one.

NOTE: The Diffuser Lens can be removed and cleaned for maintenance.

Please reference pg. 15.

FEATURES

SPOT AREA

LEVELING LEG EXTENSIONS AND LEVEL BUBBLE

On uneven ground, fine adjustments can be made by releasing the Leveling

Leg Extensions. The Level Bubble can be used for reference.

ANCHOR STRAP

In case of heavy wind or extreme weather conditions, attach a sand bag, or

equivalent weight, to the concealed Anchor Strap (see the "Nomad®Reference

Guide" on pg. 3 for location).

LEVEL BUBBLE

LEVELING LEG

EXTENSION RELEASED

DEPLOYING THE NOMAD®

LEGS LOCKED LEGS RELEASED

LIGHT HEAD (SIDE VIEW)

TILT

ADJUSTMENT

KNOB

HINGE

SCREW

3 4

LEVELING LEG

EXTENSION RELEASED

Otros manuales para Nomad Prime

Este manual sirve para los siguientes modelos

Tabla de contenidos

Otros manuales de Equipo de iluminación de Foxfury Lighting Solutions

Foxfury Lighting Solutions

Foxfury Lighting Solutions Breakthrough series Manual de usuario

Foxfury Lighting Solutions

Foxfury Lighting Solutions Nomad Transformer Manual de usuario

Foxfury Lighting Solutions

Foxfury Lighting Solutions RUGO 700-300 Manual de usuario

Foxfury Lighting Solutions

Foxfury Lighting Solutions MF Series Manual de usuario

Foxfury Lighting Solutions

Foxfury Lighting Solutions NOMAD NOW Manual de usuario

Foxfury Lighting Solutions

Foxfury Lighting Solutions NOMAD 360 Manual de usuario

Foxfury Lighting Solutions

Foxfury Lighting Solutions 750-500 Manual de usuario

Foxfury Lighting Solutions

Foxfury Lighting Solutions Taker B70 Manual de usuario

Foxfury Lighting Solutions

Foxfury Lighting Solutions SIDESLIDE SERIES Manual de usuario

Foxfury Lighting Solutions

Foxfury Lighting Solutions Nomad N32 Manual de usuario

Foxfury Lighting Solutions

Foxfury Lighting Solutions TAKER B30 Manual de usuario

Foxfury Lighting Solutions

Foxfury Lighting Solutions Nomad Prime Manual de usuario

Foxfury Lighting Solutions

Foxfury Lighting Solutions Nomad Transformer Manual de usuario

Foxfury Lighting Solutions

Foxfury Lighting Solutions EXOLANDER 700-XLS-IIE Manual de usuario

Manuales populares de Equipo de iluminación de otras marcas

Brizo

Brizo 8SP-MU-4 Manual de usuario

LUCE&LIGHT

LUCE&LIGHT BROM 1.0 Manual de usuario

IKEA

IKEA BJÖRKSPIREA Manual de usuario

Laserworld

Laserworld Evolution Series ES-400RGB Manual de usuario

Alien

Alien RG STAR Manual de usuario

EuroLite

EuroLite LED B-40 Manual de usuario

Qazqa

Qazqa Suplux SL 3 Black 103062 Manual de usuario

Commercial Electric

Commercial Electric 54568141 Manual de usuario

CREE LIGHTING

CREE LIGHTING 304 Series Manual de usuario

Goobay

Goobay 49867 Manual de usuario

ECOMAN ITALIA

ECOMAN ITALIA LED T8 Manual de usuario

Alkalite

Alkalite Krypton KT-81 Manual de usuario

Clas Ohlson

Clas Ohlson GU10 Manual de usuario

DTS

DTS DELTA 10 F Manual de usuario

ring

ring Solar Steplight Manual de usuario

One Stop Gardens

One Stop Gardens 57696 Instrucciones de montaje

Chauvet DJ

Chauvet DJ COREpar UV120 ILS Manual de usuario

SIREM

SIREM Swimeo A2 Manual de usuario