Foxconn 650M02 Series Manual de usuario
Chapter
Thank you for your buying Foxconn’s 650/651M02 series mother-
board. This series of motherboard is one of our newest products,
and offers superior performance, reliability and quality, at a
reasonable price. This motherboard adopts the advanced SiS
650GX/651+962L/962 chipsets, providing users a computer
platform with a high integration-compatibility-performance price
ratio.
This chapter includes the following information:
Main Features
Motherboard Layout
1
1
Chapter 1 Product Introduction
2650M02 and 651M02 Series User Manual
Main Features
Size
mATX form factor of 9.6” x 8.5”
Microprocessor
Supports Intel® Pentium®4 Socket 478 (Willamette/Northwood) processors
Supports Intel® Celeron®Socket 478 (Willamette/Northwood) processors
Supports FSB at 400MHz/533MHz (FSB 533MHz Supported on 651M02 only)
Supports up to 2.8GHz Socket 478 Northwood processor
Chipset
650M02: SiS650GX (North Bridge) + 962L/962 (South Bridge)
651M02: SiS651 (North Bridge) + 962L/962 (South Bridge)
System Memory
Provides two 184-pin DDR DIMM Sockets
Supports for PC 1600/PC 2100/PC 2700 (PC 2700 supported on 651M02 only)
Supports for 64Mb/128Mb/256Mb/512Mb technology up to 2GB
USB 2.0 Ports
Supports hot plug
Six USB 2.0 ports (four rear panel ports, one onboard USB headers provid-
ing two extra ports)
Supports wake-up from S3 (optional), S1
Supports USB 2.0 Protocol, 480 Mbps transmission rate
Onboard 1394 (optional)
Support hot plug
With rate of transmission at 400Mbps
Self-configured addressing
Can connect with 2 independent 1394 units synchronously at most, such
as HDD, CD-ROM
OnboardLAN
Supports 10/100Mbit/sec Ethernet
10/100M LAN interface built-in on board
3
650M02 and 651M02 Series User Manual
Chapter 1 Product Introduction
OnboardIDE
Supports up to four independent drives
Supports Ultra DMA 133/100/66
Two IDE interfaces can connect with four IDE units, including hard disk and
CD-ROM/DVD-ROM etc.
Onboard I/O
One FDD interface; supports two 3.5” or 5.25” FDDs with 360K/720K/1.2M/
1.44M/2.88M format
One high-speed 16550 COM interface with 16-byte FIFO buffer
One infrared interface (optional)
Four USB ports (with 6 ports supported at most)
one 1394 port (with 2 ports supported at most) (optional)
One parallel port supporting SPP/EPP/ECP mode
All I/O ports can be enabled/disabled in the BIOS setup
OnboardAudio
AC’ 97 2.2 Specification Compliant
Supports S/PDIF output (optional)
Onboard Line-in jack, Microphone jack, Line-out jack
Supports 5.1 channels audio (optional)
Onboard Graphics
Supports integrated VGA display functions
Supports external AGP 2.0 specification; supports 4X display cards
BIOS
Licensed advanced AWARD (Phoenix) BIOS, supports flash ROM, plug-
and play ready
Supports IDE, CD-ROM, SCSI HDD and USB device boot up
Green Function
Supports ACPI (Advanced Configuration and Power Interface)
Supports five system modes—S0 (normal), S1 (power on suspend),S3
(suspend to RAM)(optional), S4 (Suspend to disk – depends on OS), and
S5 (soft-off)
Chapter 1 Product Introduction
4650M02 and 651M02 Series User Manual
Expansion Slots
Three PCI slots
One AGP slot
One CNR slot (optional)
Advanced Features
PCI 2.2 Specification Compliant
Supports Windows 98/2000/ME/XP soft-off
Supports Wake-on-LAN
5
650M02 and 651M02 Series User Manual
Chapter 1 Product Introduction
MotherboardLayout
Note:
The above motherboard layout is provided for reference only;
please refer to the physical motherboard.
1
2
3
4
5
6
7
10 98
11
12
13
14
16
15
Chapter 1 Product Introduction
6650M02 and 651M02 Series User Manual
1394 PHY (optional)
The RTL8801B is IEEE 1394a 100/200/400 Mbps 2-Port Cable Transceiver/
Arbiter (PHY) Chip. Provides two fully compliant cable ports at 100/200/400
Mbps.
ATX 12V connector
This power connector connects the 4-pin 12V plug from the ATX 12V power
supply.
AGPslot
This Accelerated Graphics Port (AGP) slot supports 1.5V AGP4X mode
graphics cards for 3D graphical applications.
CPU socket
A 478-pin surface mount, Zero Insertion Force (ZIF) Socket for the Intel®
Pentium®4 processor, with 533/400MHz system bus that allows 4.2GB/s
and 3.2GB/s data transfer rates, respectively.
North Bridge controller
The SiS650GX/651 controller integrates a high performance host interface
for the Intel®Pentium®4 processor, a memory controller and SiS MuTIOL te-
chnology.
DDR DIMM sockets
These two 184-pin DIMM sockets support up to 2GB system memory
using unbuffered non-ECC PC2700 (651M02 series only)/PC2100/PC1600
DDR DIMMs.
ATX power connector
This 20-pin connector connects to an ATX power supply. The power supply
must have at least 1A on the +5V standby lead (+5VSB).
Super I/O controller
The Pin Count (LPC) interface provides the commonly used Supper I/O
functionality. The chipset supports a high-performance floppy disk controller
for a 360K/720K/1.44M/2.88M floppy disk drive, a multi-mode parallel port,
one serial port, the mouse and keyboard interface and a Flash ROM interface.
1
3
4
5
6
7
2
8
7
650M02 and 651M02 Series User Manual
Chapter 1 Product Introduction
Floppy disk connector
This connector accommodates the provided ribbon cable for the floppy disk
drive. One side of the connector is slotted to prevent incorrect insertion of
the floppy disk cable.
IDE connectors
These dual-Channel bus master IDE connectors support Ultra DMA 133/
100/66, PIO Modes 3 & 4 IDE devices. Both the primary (blue) and secondary
(white) connectors are slotted to prevent incorrect insertion of the IDE ribbon
cable.
Flash Rom
This 2Mb firmware contains the programmable BIOS program.
South Bridge controller
Referred to as the SiS962/SiS962L MuTIOL Media I/O, this controller
integrates the audio controller with AC’97 interface, Ethernet MAC, Dual
Universal Serial Bus Host controller, IDE Master/Slave controllers, and the
MuTIOL Connect to PCI Bridge.
PCI Slots
These three 32-bit PCI 2.2 expansion slots support bus master PCI cards
like SCSI or LAN cards with 133MB/s maximum throughput.
CNR Slot (optional)
This slot is specifically designed for the Communication and Networking
Riser (CNR) card. The CNR supports V.90 analog modem, CNR audio
card, etc.
LANPHY
The SiS 962L/962 integrated 10/100Mbps Fast Ethernet with Realtek
external PHY supports your local area networking needs.
6-Channel Audio CODEC (optional)
The ALC655 is an AC’97 CODEC that allows 6-Channel audio playback. The
audio CODEC provides six DAC channel for 5.1 surround sound, S/PDIF
output and Line-in stereo inputs, integrated headphone amplifier, greater
than 90dB dynamic range with the jack sense and jack enumeration feature.
9
10
11
12
13
14
15
16
Chapter 2 Installation Instructions
8650M02 and 651M02 Series User Manual
This chapter introduces the hardware installation process,
including the installation of the CPU, memory, power supply,
slots, rear panel and pin headers, and the mounting of
jumpers. Caution should be exercised during the installation
of these modules. Please refer to the motherboard layout prior to
any installation and read the contents in this chapter carefully.
This chapter includes the following information:
CPU
Memory
Power supply
Rear Panel
Connectors
Expansion Slots
Jumpers
Chapter2
2
Chapter 2 Installation Instructions
9
650M02 and 651M02 Series User Manual
Notes:
Take note of the following precautions before you install motherboard
Components or change any motherboard settings.
1. Unplug the power cord form the wall socket before touching
any component.
2. Use a grounded wrist strap or touch a safely grounded object
or to a metal object, such as the power supply case, before
handling components to avoid damaging them due to static
electricity.
3. Hold components by the edges to avoid touching the ICs on
them.
4. Whenever you uninstall any component, place it on a grounded
Antistatic pad or in the bag that came with the component.
5. Before you install or remove any component, ensure that the
ATX power supply is switched off. Failure to do so may cause
severe damage to the motherboard, peripherals, and /or
components.
Chapter 2 Installation Instructions
10 650M02 and 651M02 Series User Manual
CPU
This motherboard supports socket 478 CPU with a FSB 400/533 MHz (FSB
533MHz Supported on 651M02 only).
Installation of CPU
Follow these steps to install a CPU.
1. Unlock the socket by pressing the
lever sideways, then lift it up to a 900
angle.
2. Align the cut edge to the gap in the
base of the socket. Carefully insert
the CPU into the socket until it fits in
place.
3. When the CPU is in place, press it
firmly on the socket while you push
down the socket lever to secure the
CPU. The lever clicks on the side
tab to indicate that it is locked.
Cut edge
90°
Gap in the base
Push down the socket
lever to secure the CPU.
Attention:
The CPU pins must be properly aligned with the slots in the
socket, otherwise the CPU may be damaged.
Este manual sirve para los siguientes modelos
1
Tabla de contenidos
Otros manuales de Placa madre de Foxconn
Foxconn
Foxconn G41MD Manual de usuario
Foxconn
Foxconn Q77M Series Manual de usuario
Foxconn
Foxconn Destroyer Manual de usuario
Foxconn
Foxconn 45CTD Instrucciones de funcionamiento originales
Foxconn
Foxconn 671MX Series Manual de usuario
Foxconn
Foxconn H61MXP Series Manual de usuario
Foxconn
Foxconn P4M800P7MB Manual de usuario
Foxconn
Foxconn H81MXV Series Manual de usuario
Foxconn
Foxconn WinFast 6150K8M Series Manual de usuario
Foxconn
Foxconn H61MXE Series Manual de usuario
Foxconn
Foxconn Q57M Series Manual de usuario
Foxconn
Foxconn 45CS Manual de usuario
Foxconn
Foxconn MARS Manual de usuario
Foxconn
Foxconn NF4UK8AA series Manual de usuario
Foxconn
Foxconn 720AL Series Manual de usuario
Foxconn
Foxconn Z68A-S Series Manual de usuario
Foxconn
Foxconn 945G7ME Instrucciones de uso
Foxconn
Foxconn G31MXP-K Manual de usuario
Foxconn
Foxconn P9657AA Manual de usuario
Foxconn
Foxconn 865M01 series Manual de usuario
Manuales populares de Placa madre de otras marcas
Telit Wireless Solutions
Telit Wireless Solutions SL869-3DR Manual de usuario
Gigabyte
Gigabyte GA-9IVDT Manual de usuario
Texas Instruments
Texas Instruments ADS8372EVM Manual de usuario
Commell
Commell MS-C73 Manual de usuario
IBT Technologies
IBT Technologies MB860 Manual de usuario
Nvidia
Nvidia TEGRA DG-04927-001_V01 Manual de usuario
