General Safety Regulations
5
3. General Safety Regulations
Safety information
Please read this safety information carefully for your personal safety and for the prevention of property
damage.
In case of a malfunction, immediately disconnect the power plug and contact your dealer or the next Distec
GmbH service centre. A malfunction is also considered if the housing, a control element or cable is damaged
or if liquids or other objects penetrate the monitor.
Please read the safety information carefully before installing the device. If you have any doubts about
whether the device may be used in a particular environment, please contact our service partner.
Repairs
Repairs may only be carried out by authorized technical personnel. Unauthorized access or improper re-
pairs might cause serious property damage or cause danger to the user. In addition to that, any legitimate
warranty claim expires.
Electrical connection
Disconnect the monitor from socket before executing any work. Do not touch or connect data cables or
power cables during thunderstorms.
System start-up
Before the system start-up let the monitor adjust to the room temperature. Do not expose the device to
direct heat sources. In case of condensation, please wait a minimum of 12 hours before switching on the
monitor. The monitor shall only be installed and used according to this documentation data sheets. Only
qualified personnel may perform the initial installation and system setup.
Qualified personnel
Qualified personnel, in terms of the safety information of this documentation, are persons who are quali-
fied to activate, ground and label devices, systems and circuits according to the safety standards.
Operation
For a proper and safe utilization of the product, adequate transportation, storage, installation, assembly,
careful handling and maintenance are essential. The device is only certified for in-door operation. Extreme
ambient conditions shall be avoided and the monitor shall be protected from dust, humidity and heat. Do
not expose the monitor to direct sunlight.
Transport
Unpack the monitor at the place of installation. Use only original packaging for transportation. Please ob-
serve these rules for any later transport.
Condensation
Avoid condensation during transport at low temperatures or at extreme fluctuations of temperature.
