Forest garden OPA810DD Manual de usuario

10’ x 8’

Overlap Workshop

Issue 0215

FELT

60360200A1

TRUSS SUPPORT QTY 2

OPA8PE

PLAIN END

OPA810WS

WINDOW PANEL

QTY 2

OPA810PS

PLAIN PANEL

QTY 2

WS10X8BRDFL

FLOOR

QTY 2

85052 QTY 3

C D E G IF

28120675PARPTR

675mmm STRIP QTY 2

OPA8TRUSS

TRUSS

OPA810DD PARTS LIST

154013408

ROOF SHEET

QTY 4

DDRPT

DOOR QTY 2

OPA8DE

DOOR END

90121375AII74PT

1375mm BARGE BOARD QTY 4

60151710PTR

1710mm CORNER STRIP QTY 6

45281462PTR

1462mm BATTEN QTY 8

45451630PT

1630mm BATTEN QTY 1

Floor

Top View

5 I

45281540PTR

1540mmm BATTEN QTY 4

Important : Assembly of

this shed requires a

minimum of two adults. Must Pre-drill for

each screw used.

PCWIN1

WINDOW QTY 4

The windows are packed

together tightly, separate

before assembly.

84996

675mmm PLASTIC STRIP QTY 8

RFIN20010512PT

FINIAL QTY 2

Place the hinge against the inside of the door frame and position the large section of the hinge so

that it is flush with the inside of the framing as shown and fix with 25mm screws.

Open the hinge and fix the smaller section to the door framing. Again make sure that the hinge is

flush and that the holes are positioned so that the 25mm screws locate correctly into the batten.

Place the two floor sections together and position the panels on top of the completed floor. Make

sure that all the panels are tight and flush before fixing them to each other using 3x50mm screws.

When the panels are secured to each other, make sure they are flush and fix to the floor using

3x50mm screws for each panel. Make sure that the screws locate into the bearers underneath.

Place the window from the outside so that the lip sits on the bottom board as shown.

Place the plastic strips at the top and bottom of the window so that one side butts up

against the cladding. Fix each strip in place using 2 x security screws.

Position the remaining strip vertically against the outer edge of the window so that one

side of the strip butts up against the cladding.

Place one 675mm wooden strip in the middle so that it overlaps the window equally on

both sides and the remaining strip on the door side of the window. Again fix each

wooden strip in place using 2 x security screws.

IMPORTANT, RETAIN FOR FUTURE REFERENCE; READ

CAREFULLY

This building is pressure treated to ensure longevity of all

timber components and to protect against rot. This may leave

a colour difference on some parts that will even out as the

moisture content stabilises. This will not need additional

treatment.

- This product must be built on a solid level base.

- Please keep all plastic bags and small parts away from

children.

- The roof of this building is not a load bearing structure.

- Timber is a natural material. It will shrink and swell as a

result of varying moisture content.

- Due to the nature of the material the doors may need some

trimming for a neater fit.

Technical Help line: 0333 7777 089 8.30 am and 5.00

pm Monday to Friday.

Please check all parts prior to assembly

Assembly of damaged parts may be deemed to be

acceptance and this may affect the remedies you are entitled

to.

If the product is not constructed in accordance with the

instructions, or is altered in any way (e.g. painted), the

manufacturer cannot be held liable for any resulting damage.

Fix the 1645mm batten against the

end of the door using 3x70mm

screws. Make sure it is flush with

the door end framework.

Fix a turn button to the top and

bottom of the batten using

1x30mm (zinc) screw for each.

Board

Lip

Attention:

Take care when

placing the

screws. These

can not be

backed out.

You may need to

cut the plastic

strips to size using

a pair of scissors

Place and secure each angled block using 2x70mm screws. Make

sure these are 1470mm from the floor level and are tight against the

framework.

Place the truss so that is sits on the angled blocks. Secure this in

place by screwing down through the truss into the blocks using 2 x

90mm screws for each end.

REQUIRED TOOLS :

(NOT SUPPLIED)

HAMMER

SHARP KNIFE SCISSORS

FLAT HEAD

SCREWDRIVER

POZI DRIVE

SCREWDRIVER

TAPE MEASURE

LADDER

Fixing Pack (OPA812DDFP)

This fixing pack is used for several products.

There may be additional fixings.

Not to Scale

Turn Button

Qty 2

Z’ bracket

Qty 16

70mm Screw Qty 7

50mm Screw Qty 36

10mm Felt tacks

Qty 110

25mm Screw Qty 61

30mm Screw Qty 18

30mm Nail Qty 90

Flush Hinge

Qty 4

25mm Countersunk

Security Screws Qty 40

Hasp & Staple

40mm Screw Qty 18

80mm Screw Qty 3

90mm Screw Qty 4

Place the 1695mm batten against

the inside of the door end so that

the batten is covering the gap

between the door end and the

door. Fix this in place using

2x30mm screws.

Repeat for the opposite side of

the door way.

32mm

S32161695PTR

1695mm STRIP QTY 2

Forest Garden Ltd, Unit 288 Hartlebury Trading Estate, Hartlebury, Worcestershire, DY10 4JB

Maintenance.

We recommend that you treat your shed at the beginning of each season with a wood preservative treatment. Apply in

accordance with the manufacturers instructions.

Regularly check all fixings are secure.

Biocidal Product Regulation (EU 528/2012) Article 58 Information

This article contains timber treated with Celcure AC-500, incorporating biocidal products to give protection against wood destroying insects & wood rotting fungi.

Contains: Basic copper carbonate (Copper (II) carbonate – Copper (II) hydroxide (1:1)), Boric acid, Benzalkonium chloride.

Wear gloves when handling freshly treated wood. Avoid breathing dust when cutting treated or untreated wood. Dispose of off-cuts responsibly – do not burn.

Attention

Take care when

cutting and trimming

the roof felt.

Unroll the felt and place a section on to each eaves so that there is a 50mm overhang on the

three edges as shown. Fix this to the roof using felt nails spaced in 150mm intervals. Cut and

fold the corners securing with a single felt nail for each.

Place the two remaining sections as shown making sure that the last piece overlaps the others.

Again secure each sheet in place using felt nails spaced in 150mm intervals.

10 11

Secure a Z’ bracket to each end of the 1462mm battens using a single

25mm screw for each bracket. Position the battens as shown so that there

is four battens on either side of the truss and the Z’ bracket sits on the

framework. Secure the battens in position using a 25mm screw for each Z’

bracket. You will need to stagger the battens to allow the bracket to sit

properly on the truss.

Before fixing the Hasp to the door, make sure that it is in line with the framing

on the reverse of the door and that it closes over the Staple. Fix this in place

using 3 x 25mm screws.

Position the Staple opposite, again making sure that it is in line with the

framing behind and fix it in place using 2 x 25mm screws.

Place the barge boards against the ends of the workshop so that they are flush

with the overhang of the roof and in line with the top. Fix each in place using

4x40mm screws.

Place the finial over the top where the barge boards meet and fix it in place

using 2 x 30mm screws.

Repeat for the opposite end of the shed.

Lift the roof sections into place making sure that they are in line with

the apex and the front and back panels of the shed.

Fix the roof in place using 30mm nails spaced in approximately

300mm intervals (Make sure the nails locate into the framework of

the truss and panels)

Place a roof sheet on top of one of the 1540mm

battens. Make sure the board is sat on the narrow

side of the batten and that it is flush on all sides. Fix

this in place using 30mm nails spaced in 300mm

intervals.

Place the 1710mm strips so that they cover the joins at

each corner and between the panels. Fix each corner

strip in place using 3x30mm screws and each middle

strip with 3 x 40mm screws

Otros manuales de Casa de jardín de Forest garden

Forest garden

Forest garden BASEMSFP Manual de usuario

Forest garden

Forest garden WRGH Manual de usuario

Forest garden

Forest garden Overlap Apex Shed 7' x 5' Manual de usuario

Forest garden

Forest garden Bloxham 7' x 5’ Summer Manual de usuario

Forest garden

Forest garden TPC77 Manual de usuario

Forest garden

Forest garden OPASUM75M Manual de usuario

Forest garden

Forest garden Large Apex Out Door Store OPAOSFP Manual de usuario

Forest garden

Forest garden Oakley Summer House 8 x 6 Manual de usuario

Forest garden

Forest garden Overlap Apex Shed 7' x 5' Manual de usuario

Forest garden

Forest garden Overlap Pent Wall Shed 6' x 3'' Manual de usuario

Forest garden

Forest garden Overlap Apex Shed 6 x 4 Manual de usuario

Forest garden

Forest garden SDA68ON Manual de usuario

Forest garden

Forest garden ODA810DD Manual de usuario

Forest garden

Forest garden TPCS88 Manual de usuario

Forest garden

Forest garden ODA68M Manual de usuario

Forest garden

Forest garden APEX PREMIUM Manual de usuario

Forest garden

Forest garden Overlap Apex Shed 6 X 4 Manual de usuario

Forest garden

Forest garden ODA46 Manual de usuario

Forest garden

Forest garden Overlap Apex Shed ODA68NW Manual de usuario

Forest garden

Forest garden TPC88 Manual de usuario

Forest garden

Forest garden MODULAR PERGOLA Manual de usuario

Forest garden

Forest garden OPA68 Manual de usuario

Forest garden

Forest garden OPA77DD Manual de usuario

Forest garden

Forest garden SDA68 Manual de usuario

Manuales populares de Casa de jardín de otras marcas

Mercia Garden Products

Mercia Garden Products 0628LOG181-V4 Manual de usuario

Lemeks

Lemeks Palmako PA120-5930-6 Manual del instalador

Gartenhaus-King

Gartenhaus-King Valery Manual de usuario

Rion

Rion Hobby Gardener Manual de usuario

POD

POD Camping 480 Manual de usuario

Select

Select ISAAC E9682 Manual de usuario

Mercia Garden Products

Mercia Garden Products 01DTSHPWOR1010DDOW-V4 Manual de instrucciones

Palmako

Palmako Saale Manual de usuario

Lemeks

Lemeks Palmako Kira EL16-3623 Manual del instalador

Mercia Garden Products

Mercia Garden Products 0644LOG186-V4 Manual de instrucciones

Palmako

Palmako Roger FR44-5953-2 Manual de usuario

Mercia Garden Products

Mercia Garden Products 03DTSHHP1206HGD4MW-V1 Manual de instrucciones

WAR-LOCK

WAR-LOCK GARDENSHED Skillion Series Manual de usuario

Pergola kits USA

Pergola kits USA PREMIUM VINYL PAVILION Manual de usuario

G21

G21 Boston 882 Manual de usuario

Lemeks

Lemeks Palmako Grace PM56-4529 Manual del instalador

Mercia Garden Products

Mercia Garden Products 03WES0808-V1 Manual de instrucciones

Shire

Shire Salcey Manual de usuario