99.MP.0056.EN - ASSEMBLING PROCEDURE
·Priortoinstallation be suretocheckyourlocalbuildingandzoning requirements.
·Pleasecarryoutthestepsintheorderset out in these instructions.
IMPORTANT
·Pleasereadtheseinstructionscarefullybefore you starttoassembleyourenclosure.
SAFETY ADVICE
·Keeptheseinstructionsinasafeplace for futurereference.
·Wood/composite decking
dizzyspells.
·3.5"thickfoundationofreinforcedconcrete
TOOLS AND EQUIPMENT REQUIRED
·more informations about recommended tools are in this assembling
procedure
·Ifusingastepladderorpowertools,ensure that you followthemanufacturer'ssafetyadvice.
TRACK INSTALATION
Aflat, levelsurfaceisrequired; any of the following is acceptable:
·Use of work gloves and safety glasses during assembly is required.
·Do not attempt to assemble the enclosure in windy or wet conditions.
·Do not touch overhead power cables (if any) with the aluminum profiles.
·Always wear shoes and safety goggles when working with extruded aluminum.
·Dispose of all plastic bags safely - keep them out of reach of small children.
·The enclosure must be positioned and attached on a flat level surface.
·Do not lean against or push t he enclosure during assembly.
·Keep children away from the assembly area.
·Do not position your enclosure in an area exposed to excessive wind or overhead tree limbs.
·Do not attempt to assemble the enclosure, if you are tired, have taken drugs or alcohol or if you are prone to
·Paversset in Concrete
CLEANING
Polycarbonate panels can easily be cleaned by hosing down with cold clean water or with a soft cloth made
from100% cotton using a mild dish detergent solution and rinsing with cold water.
DO NOT use acetone, abrasive cleaners or other special detergents to clean the panels. This will void
warranty!
IMMEDIATE REMOVAL OF PROTECTION SHEETSFROM PANELS
The polyethylene masking (plastic sheets/foil) must be removed immediately from the panels during or
immediately after installation. The polyethylene masking covers the panels to protect them during
handling,hipping, storage, and installation. If it is removed at a later time, it may be very difficult if not
impossible to remove as it will stick to the panel. In hot climates, even 24 hours after the installation is
completed it may be too late to remove.
2 / 63
